//! [setup]
void configure_gclock_generator(void)
{
//! [setup_1]
struct system_gclk_gen_config gclock_gen_conf;
//! [setup_1]
//! [setup_2]
system_gclk_gen_get_config_defaults(&gclock_gen_conf);
//! [setup_2]
#if (SAML21)
//! [setup_3]
gclock_gen_conf.source_clock = SYSTEM_CLOCK_SOURCE_OSC16M;
gclock_gen_conf.division_factor = 128;
//! [setup_3]
#else
//! [setup_3]
gclock_gen_conf.source_clock = SYSTEM_CLOCK_SOURCE_OSC8M;
gclock_gen_conf.division_factor = 128;
//! [setup_3]
#endif
//! [setup_4]
system_gclk_gen_set_config(GCLK_GENERATOR_1, &gclock_gen_conf);
//! [setup_4]
//! [setup_5]
system_gclk_gen_enable(GCLK_GENERATOR_1);
//! [setup_5]
}
/** Initializes the XOSC32K crystal failure detector, and starts it.
*
* \param[in] ok_callback Callback function to run upon XOSC32K operational
* \param[in] fail_callback Callback function to run upon XOSC32K failure
*/
static void init_xosc32k_fail_detector(
const tc_callback_t ok_callback,
const tc_callback_t fail_callback)
{
/* TC pairs share the same clock, ensure reference and crystal timers use
* different clocks */
Assert(Abs(_tc_get_inst_index(CONF_TC_OSC32K) -
_tc_get_inst_index(CONF_TC_XOSC32K)) >= 2);
/* The crystal detection cycle count must be less than the reference cycle
* count, so that the reference timer is periodically reset before expiry */
Assert(CRYSTAL_RESET_CYCLES < CRYSTAL_FAIL_CYCLES);
/* Must use different clock generators for the crystal and reference, must
* not be CPU generator 0 */
Assert(GCLK_GENERATOR_XOSC32K != GCLK_GENERATOR_OSC32K);
Assert(GCLK_GENERATOR_XOSC32K != GCLK_GENERATOR_0);
Assert(GCLK_GENERATOR_OSC32K != GCLK_GENERATOR_0);
/* Configure and enable the XOSC32K GCLK generator */
struct system_gclk_gen_config xosc32k_gen_conf;
system_gclk_gen_get_config_defaults(&xosc32k_gen_conf);
xosc32k_gen_conf.source_clock = SYSTEM_CLOCK_SOURCE_XOSC32K;
system_gclk_gen_set_config(GCLK_GENERATOR_XOSC32K, &xosc32k_gen_conf);
system_gclk_gen_enable(GCLK_GENERATOR_XOSC32K);
/* Configure and enable the reference clock GCLK generator */
struct system_gclk_gen_config ref_gen_conf;
system_gclk_gen_get_config_defaults(&ref_gen_conf);
ref_gen_conf.source_clock = SYSTEM_CLOCK_SOURCE_OSC32K;
system_gclk_gen_set_config(GCLK_GENERATOR_OSC32K, &ref_gen_conf);
system_gclk_gen_enable(GCLK_GENERATOR_OSC32K);
/* Set up crystal counter - when target count elapses, trigger event */
struct tc_config tc_xosc32k_conf;
tc_get_config_defaults(&tc_xosc32k_conf);
tc_xosc32k_conf.clock_source = GCLK_GENERATOR_XOSC32K;
tc_xosc32k_conf.counter_16_bit.compare_capture_channel[0] =
CRYSTAL_RESET_CYCLES;
tc_xosc32k_conf.wave_generation = TC_WAVE_GENERATION_MATCH_FREQ;
tc_init(&tc_xosc32k, CONF_TC_XOSC32K, &tc_xosc32k_conf);
/* Set up reference counter - when event received, restart */
struct tc_config tc_osc32k_conf;
tc_get_config_defaults(&tc_osc32k_conf);
tc_osc32k_conf.clock_source = GCLK_GENERATOR_OSC32K;
tc_osc32k_conf.counter_16_bit.compare_capture_channel[0] =
CRYSTAL_FAIL_CYCLES;
tc_osc32k_conf.wave_generation = TC_WAVE_GENERATION_MATCH_FREQ;
tc_init(&tc_osc32k, CONF_TC_OSC32K, &tc_osc32k_conf);
/* Configure event channel and link it to the xosc32k counter */
struct events_config config;
struct events_resource event;
events_get_config_defaults(&config);
config.edge_detect = EVENTS_EDGE_DETECT_NONE;
config.generator = CONF_EVENT_GENERATOR_ID;
config.path = EVENTS_PATH_ASYNCHRONOUS;
events_allocate(&event, &config);
/* Configure event user and link it to the osc32k counter */
events_attach_user(&event, CONF_EVENT_USED_ID);
/* Enable event generation for crystal counter */
struct tc_events tc_xosc32k_events = { .generate_event_on_overflow = true };
tc_enable_events(&tc_xosc32k, &tc_xosc32k_events);
/* Enable event reception for reference counter */
struct tc_events tc_osc32k_events = { .on_event_perform_action = true };
tc_osc32k_events.event_action = TC_EVENT_ACTION_RETRIGGER;
tc_enable_events(&tc_osc32k, &tc_osc32k_events);
/* Enable overflow callback for the crystal counter - if crystal count
* has been reached, crystal is operational */
tc_register_callback(&tc_xosc32k, ok_callback, TC_CALLBACK_CC_CHANNEL0);
tc_enable_callback(&tc_xosc32k, TC_CALLBACK_CC_CHANNEL0);
/* Enable compare callback for the reference counter - if reference count
* has been reached, crystal has failed */
tc_register_callback(&tc_osc32k, fail_callback, TC_CALLBACK_CC_CHANNEL0);
tc_enable_callback(&tc_osc32k, TC_CALLBACK_CC_CHANNEL0);
/* Start both crystal and reference counters */
tc_enable(&tc_xosc32k);
tc_enable(&tc_osc32k);
}
/** Main application entry point. */
int main(void)
{
system_init();
system_flash_set_waitstates(2);
init_osc32k();
init_xosc32k();
init_xosc32k_fail_detector(
xosc32k_ok_callback, xosc32k_fail_callback);
#if ENABLE_CPU_CLOCK_OUT == true
/* Configure a GPIO pin as the CPU clock output */
struct system_pinmux_config clk_out_pin;
system_pinmux_get_config_defaults(&clk_out_pin);
clk_out_pin.direction = SYSTEM_PINMUX_PIN_DIR_OUTPUT;
clk_out_pin.mux_position = CONF_CLOCK_PIN_MUX;
system_pinmux_pin_set_config(CONF_CLOCK_PIN_OUT, &clk_out_pin);
#endif
for (;;) {
static bool old_run_osc = true;
bool new_run_osc =
(port_pin_get_input_level(BUTTON_0_PIN) == BUTTON_0_INACTIVE);
/* Check if the XOSC32K needs to be started or stopped when the board
* button is pressed or released */
if (new_run_osc != old_run_osc) {
if (new_run_osc) {
system_clock_source_enable(SYSTEM_CLOCK_SOURCE_XOSC32K);
while(!system_clock_source_is_ready(
SYSTEM_CLOCK_SOURCE_XOSC32K));
}
else {
system_clock_source_disable(SYSTEM_CLOCK_SOURCE_XOSC32K);
}
old_run_osc = new_run_osc;
}
}
}
void serial_data_handler(void)
{
if (data_length == 0) {
/* No data to process, read the stream IO */
//rx_index = 0;
data_length = sio2host_rx(data, 156); /* @ToDo 20 ?,
* different
* values for
* USB and
* UART ? */
} else { /* Data has been received, process the data */
printf("Receiving file..\n");
data_length--;
rx_index++;
if(rx_index ==99)
{
printf("Received File!!!!!!!!!!\n");
}
}
#endif
void configure_gclock_generator(void)
{
//! [setup_1]
struct system_gclk_gen_config gclock_gen_conf;
//! [setup_1]
//! [setup_2]
system_gclk_gen_get_config_defaults(&gclock_gen_conf);
//! [setup_2]
//! [setup_3]
gclock_gen_conf.source_clock = SYSTEM_CLOCK_SOURCE_ULP32K;
gclock_gen_conf.division_factor = 128;
//! [setup_3]
//! [setup_4]
system_gclk_gen_set_config(GCLK_GENERATOR_4, &gclock_gen_conf);
//! [setup_4]
//! [setup_5]
system_gclk_gen_enable(GCLK_GENERATOR_4);
//! [setup_5]
}
/*---------------------------------------------------------------------------*/
static void
set_link_addr(void)
{
linkaddr_t addr;
unsigned int i;
memset(&addr, 0, sizeof(linkaddr_t));
#if UIP_CONF_IPV6
#if SAMR21
memcpy(addr.u8, eui64, sizeof(addr.u8));
#else
memcpy(addr.u8, node_mac, sizeof(addr.u8));
#endif
#else /* UIP_CONF_IPV6 */
if(node_id == 0) {
for(i = 0; i < sizeof(linkaddr_t); ++i) {
#if SAMR21
addr.u8[i] = eui64 [7 - i];
#else
addr.u8[i] = node_mac [7 - i];
#endif
}
} else {
addr.u8[0] = node_id & 0xff;
addr.u8[1] = node_id >> 8;
}
#endif /* UIP_CONF_IPV6 */
linkaddr_set_node_addr(&addr);
printf("Link layer addr ");
for(i = 0; i < sizeof(addr.u8) - 1; i++) {
printf("%u:", addr.u8[i]);
}
printf("%u, ", addr.u8[i]);
for(i = 0; i < sizeof(addr.u8) - 1; i++) {
printf("%02x:", addr.u8[i]);
}
printf("%02x\n", addr.u8[i]);
}
