int wl1271_init_ap_rates(struct wl1271 *wl, struct wl12xx_vif *wlvif)
{
int i, ret;
struct conf_tx_rate_class rc;
u32 supported_rates;
wl1271_debug(DEBUG_AP, "AP basic rate set: 0x%x",
wlvif->basic_rate_set);
if (wlvif->basic_rate_set == 0)
return -EINVAL;
rc.enabled_rates = wlvif->basic_rate_set;
rc.long_retry_limit = 10;
rc.short_retry_limit = 10;
rc.aflags = 0;
ret = wl1271_acx_ap_rate_policy(wl, &rc, wlvif->ap.mgmt_rate_idx);
if (ret < 0)
return ret;
/* use the min basic rate for AP broadcast/multicast */
rc.enabled_rates = wl1271_tx_min_rate_get(wl, wlvif->basic_rate_set);
rc.short_retry_limit = 10;
rc.long_retry_limit = 10;
rc.aflags = 0;
ret = wl1271_acx_ap_rate_policy(wl, &rc, wlvif->ap.bcast_rate_idx);
if (ret < 0)
return ret;
/*
* If the basic rates contain OFDM rates, use OFDM only
* rates for unicast TX as well. Else use all supported rates.
*/
if ((wlvif->basic_rate_set & CONF_TX_OFDM_RATES))
supported_rates = CONF_TX_OFDM_RATES;
else
supported_rates = CONF_TX_ENABLED_RATES;
/* unconditionally enable HT rates */
supported_rates |= CONF_TX_MCS_RATES;
/* get extra MIMO or wide-chan rates where the HW supports it */
supported_rates |= wlcore_hw_ap_get_mimo_wide_rate_mask(wl, wlvif);
/* configure unicast TX rate classes */
for (i = 0; i < wl->conf.tx.ac_conf_count; i++) {
rc.enabled_rates = supported_rates;
rc.short_retry_limit = 10;
rc.long_retry_limit = 10;
rc.aflags = 0;
ret = wl1271_acx_ap_rate_policy(wl, &rc,
wlvif->ap.ucast_rate_idx[i]);
if (ret < 0)
return ret;
}
return 0;
}
int wl1271_init_ap_rates(struct wl1271 *wl)
{
int i, ret;
struct conf_tx_rate_class rc;
u32 supported_rates;
wl1271_debug(DEBUG_AP, "AP basic rate set: 0x%x", wl->basic_rate_set);
if (wl->basic_rate_set == 0)
return -EINVAL;
rc.enabled_rates = wl->basic_rate_set;
rc.long_retry_limit = 10;
rc.short_retry_limit = 10;
rc.aflags = 0;
ret = wl1271_acx_ap_rate_policy(wl, &rc, ACX_TX_AP_MODE_MGMT_RATE);
if (ret < 0)
return ret;
/* use the min basic rate for AP broadcast/multicast */
rc.enabled_rates = wl1271_tx_min_rate_get(wl, wl->basic_rate_set);
rc.short_retry_limit = 10;
rc.long_retry_limit = 10;
rc.aflags = 0;
ret = wl1271_acx_ap_rate_policy(wl, &rc, ACX_TX_AP_MODE_BCST_RATE);
if (ret < 0)
return ret;
/*
* If the basic rates contain OFDM rates, use OFDM only
* rates for unicast TX as well. Else use all supported rates.
*/
if ((wl->basic_rate_set & CONF_TX_OFDM_RATES))
supported_rates = CONF_TX_OFDM_RATES;
else
supported_rates = CONF_TX_AP_ENABLED_RATES;
/* unconditionally enable HT rates */
supported_rates |= CONF_TX_MCS_RATES;
/* configure unicast TX rate classes */
for (i = 0; i < wl->conf.tx.ac_conf_count; i++) {
rc.enabled_rates = supported_rates;
rc.short_retry_limit = 10;
rc.long_retry_limit = 10;
rc.aflags = 0;
ret = wl1271_acx_ap_rate_policy(wl, &rc, i);
if (ret < 0)
return ret;
}
return 0;
}
