static void OEMInitializeSystemTimer(UINT32 msecPerSysTick, UINT32 countsPerMSec, UINT32 countsMargin)
{
UINT32 countsPerSysTick;
// Validate Input parameters
countsPerSysTick = msecPerSysTick * countsPerMSec;
InitSystemTimer(countsPerSysTick);
}
int main(void)
{
//STATIC_ASSERT(sizeof(uint16_t) == 2);
InitGPIO();
InitSPI_soft();
InitI2C_soft();
InitADC();
InitSystemTimer();
InitTimers();
InitMessages();
InitCC2500(preferredSettings); //(const uint8_t **)conf(+6bytes of code), preferredSettings
uart0_init( UART_BAUD_SELECT(RS485_BAUDRATE, F_CPU) );
//_delay_ms(5000);
//InitEXTI();
//MCUCR |= (_BV(ISC11) | _BV(ISC01));
/*check Watchdog reset flag*/
if(bit_is_set(MCUCSR, WDRF)) {
//increase wathcdog reset counter and save in eeprom
}
set_sleep_mode(SLEEP_MODE_IDLE); //варианты SLEEP_MODE_PWR_SAVE SLEEP_MODE_IDLE SLEEP_MODE_ADC
//wdt_enable(WDTO_2S);
sei(); //enable interrupts
for (uint8_t i = 0; i<0x05; i++) {
//_spi_start();
//spi_TxRx(0x9D);
//_spi_stop();
_delay_ms(100);
PORTC |= _BV(PC2); //blink for test
_delay_ms(100);
PORTC &= ~_BV(PC2);
_delay_ms(100);
RS485_DE_HIGH;
uart0_putc(0xba);
_delay_ms(2);
RS485_DE_LOW;
}
RS485_DE_LOW;
while(1) {
cc_table_state[CC_state]();
ProcessTimers(&sys_timer);
ProcessMessages();
wdt_reset();
/*enter in sleep mode until interrupts occured*/
// cli(); //disable interrupts
// if (some_condition)
// {
// sleep_enable();
// sei();
// sleep_cpu();
// sleep_disable();
// }
// sei();
}
return 0;
}
