/*
* Check if autoload is enabled. If so, use either NFS or TFTP to download
* the boot file.
*/
static void auto_load(void)
{
const char *s = getenv("autoload");
if (s != NULL) {
if (*s == 'n') {
/*
* Just use BOOTP to configure system;
* Do not use TFTP to load the bootfile.
*/
NetState = NETLOOP_SUCCESS;
return;
}
#if defined(CONFIG_CMD_NFS)
if (strcmp(s, "NFS") == 0) {
/*
* Use NFS to load the bootfile.
*/
NfsStart();
return;
}
#endif
}
TftpStart();
}
/*
* Handle a BOOTP received packet.
*/
static void
BootpHandler(uchar * pkt, unsigned dest, unsigned src, unsigned len)
{
Bootp_t *bp;
char *s;
debug("got BOOTP packet (src=%d, dst=%d, len=%d want_len=%zu)\n",
src, dest, len, sizeof (Bootp_t));
bp = (Bootp_t *)pkt;
if (BootpCheckPkt(pkt, dest, src, len)) /* Filter out pkts we don't want */
return;
/*
* Got a good BOOTP reply. Copy the data into our variables.
*/
#ifdef CONFIG_STATUS_LED
status_led_set (STATUS_LED_BOOT, STATUS_LED_OFF);
#endif
BootpCopyNetParams(bp); /* Store net parameters from reply */
/* Retrieve extended information (we must parse the vendor area) */
if (NetReadLong((ulong*)&bp->bp_vend[0]) == htonl(BOOTP_VENDOR_MAGIC))
BootpVendorProcess((uchar *)&bp->bp_vend[4], len);
NetSetTimeout(0, (thand_f *)0);
debug("Got good BOOTP\n");
if ((s = getenv("autoload")) != NULL) {
if (*s == 'n') {
/*
* Just use BOOTP to configure system;
* Do not use TFTP to load the bootfile.
*/
NetState = NETLOOP_SUCCESS;
return;
#if defined(CONFIG_CMD_NFS)
} else if (strcmp(s, "NFS") == 0) {
/*
* Use NFS to load the bootfile.
*/
NfsStart();
return;
#endif
}
}
struct NetTask tftp_task;
BootpDeriveTaskTftp(&tftp_task, bp);
TftpStart(&tftp_task);
}
/*
* Handle a RARP received packet.
*/
static void
RarpHandler(uchar * dummi0, unsigned dummi1, unsigned dummi2, unsigned dummi3)
{
char *s;
debug("Got good RARP\n");
if ((s = getenv("autoload")) != NULL) {
if (*s == 'n') {
/*
* Just use RARP to configure system;
* Do not use TFTP/NFS to to load the bootfile.
*/
NetState = NETLOOP_SUCCESS;
return;
#if defined(CONFIG_CMD_NFS)
} else if ((s != NULL) && !strcmp(s, "NFS")) {
NfsStart();
return;
#endif
}
}
TftpStart ();
}
/*
* Check if autoload is enabled. If so, use either NFS or TFTP to download
* the boot file.
*/
void net_auto_load(void)
{
#if defined(CONFIG_CMD_NFS)
const char *s = getenv("autoload");
if (s != NULL && strcmp(s, "NFS") == 0) {
/*
* Use NFS to load the bootfile.
*/
NfsStart();
return;
}
#endif
if (getenv_yesno("autoload") == 0) {
/*
* Just use BOOTP/RARP to configure system;
* Do not use TFTP to load the bootfile.
*/
net_set_state(NETLOOP_SUCCESS);
return;
}
TftpStart(TFTPGET);
}
int NetLoop(enum proto_t protocol)
{
bd_t *bd = gd->bd;
int ret = -1;
NetRestarted = 0;
NetDevExists = 0;
NetTryCount = 1;
debug_cond(DEBUG_INT_STATE, "--- NetLoop Entry\n");
bootstage_mark_name(BOOTSTAGE_ID_ETH_START, "eth_start");
net_init();
if (eth_is_on_demand_init() || protocol != NETCONS) {
eth_halt();
eth_set_current();
if (eth_init(bd) < 0) {
eth_halt();
return -1;
}
} else
eth_init_state_only(bd);
restart:
#ifdef CONFIG_USB_KEYBOARD
net_busy_flag = 0;
#endif
net_set_state(NETLOOP_CONTINUE);
/*
* Start the ball rolling with the given start function. From
* here on, this code is a state machine driven by received
* packets and timer events.
*/
debug_cond(DEBUG_INT_STATE, "--- NetLoop Init\n");
NetInitLoop();
switch (net_check_prereq(protocol)) {
case 1:
/* network not configured */
eth_halt();
return -1;
case 2:
/* network device not configured */
break;
case 0:
NetDevExists = 1;
NetBootFileXferSize = 0;
switch (protocol) {
case TFTPGET:
#ifdef CONFIG_CMD_TFTPPUT
case TFTPPUT:
#endif
/* always use ARP to get server ethernet address */
TftpStart(protocol);
break;
#ifdef CONFIG_CMD_TFTPSRV
case TFTPSRV:
TftpStartServer();
break;
#endif
#if defined(CONFIG_CMD_DHCP)
case DHCP:
BootpReset();
NetOurIP = 0;
DhcpRequest(); /* Basically same as BOOTP */
break;
#endif
case BOOTP:
BootpReset();
NetOurIP = 0;
BootpRequest();
break;
#if defined(CONFIG_CMD_RARP)
case RARP:
RarpTry = 0;
NetOurIP = 0;
RarpRequest();
break;
#endif
#if defined(CONFIG_CMD_PING)
case PING:
ping_start();
break;
#endif
#if defined(CONFIG_CMD_NFS)
case NFS:
NfsStart();
break;
#endif
#if defined(CONFIG_CMD_CDP)
case CDP:
CDPStart();
break;
#endif
#if defined (CONFIG_NETCONSOLE) && !(CONFIG_SPL_BUILD)
case NETCONS:
NcStart();
break;
#endif
#if defined(CONFIG_CMD_SNTP)
case SNTP:
SntpStart();
break;
#endif
#if defined(CONFIG_CMD_DNS)
case DNS:
DnsStart();
break;
#endif
#if defined(CONFIG_CMD_LINK_LOCAL)
case LINKLOCAL:
link_local_start();
break;
#endif
default:
break;
}
break;
}
#if defined(CONFIG_MII) || defined(CONFIG_CMD_MII)
#if defined(CONFIG_SYS_FAULT_ECHO_LINK_DOWN) && \
defined(CONFIG_STATUS_LED) && \
defined(STATUS_LED_RED)
/*
* Echo the inverted link state to the fault LED.
*/
if (miiphy_link(eth_get_dev()->name, CONFIG_SYS_FAULT_MII_ADDR))
status_led_set(STATUS_LED_RED, STATUS_LED_OFF);
else
status_led_set(STATUS_LED_RED, STATUS_LED_ON);
#endif /* CONFIG_SYS_FAULT_ECHO_LINK_DOWN, ... */
#endif /* CONFIG_MII, ... */
#ifdef CONFIG_USB_KEYBOARD
net_busy_flag = 1;
#endif
/*
* Main packet reception loop. Loop receiving packets until
* someone sets `net_state' to a state that terminates.
*/
for (;;) {
WATCHDOG_RESET();
#ifdef CONFIG_SHOW_ACTIVITY
show_activity(1);
#endif
/*
* Check the ethernet for a new packet. The ethernet
* receive routine will process it.
*/
eth_rx();
/*
* Abort if ctrl-c was pressed.
*/
if (ctrlc()) {
/* cancel any ARP that may not have completed */
NetArpWaitPacketIP = 0;
net_cleanup_loop();
eth_halt();
/* Invalidate the last protocol */
eth_set_last_protocol(BOOTP);
puts("\nAbort\n");
/* include a debug print as well incase the debug
messages are directed to stderr */
debug_cond(DEBUG_INT_STATE, "--- NetLoop Abort!\n");
goto done;
}
ArpTimeoutCheck();
/*
* Check for a timeout, and run the timeout handler
* if we have one.
*/
if (timeHandler && ((get_timer(0) - timeStart) > timeDelta)) {
thand_f *x;
#if defined(CONFIG_MII) || defined(CONFIG_CMD_MII)
#if defined(CONFIG_SYS_FAULT_ECHO_LINK_DOWN) && \
defined(CONFIG_STATUS_LED) && \
defined(STATUS_LED_RED)
/*
* Echo the inverted link state to the fault LED.
*/
if (miiphy_link(eth_get_dev()->name,
CONFIG_SYS_FAULT_MII_ADDR)) {
status_led_set(STATUS_LED_RED, STATUS_LED_OFF);
} else {
status_led_set(STATUS_LED_RED, STATUS_LED_ON);
}
#endif /* CONFIG_SYS_FAULT_ECHO_LINK_DOWN, ... */
#endif /* CONFIG_MII, ... */
debug_cond(DEBUG_INT_STATE, "--- NetLoop timeout\n");
x = timeHandler;
timeHandler = (thand_f *)0;
(*x)();
}
switch (net_state) {
case NETLOOP_RESTART:
NetRestarted = 1;
goto restart;
case NETLOOP_SUCCESS:
net_cleanup_loop();
if (NetBootFileXferSize > 0) {
printf("Bytes transferred = %ld (%lx hex)\n",
NetBootFileXferSize,
NetBootFileXferSize);
setenv_hex("filesize", NetBootFileXferSize);
setenv_hex("fileaddr", load_addr);
}
if (protocol != NETCONS)
eth_halt();
else
eth_halt_state_only();
eth_set_last_protocol(protocol);
ret = NetBootFileXferSize;
debug_cond(DEBUG_INT_STATE, "--- NetLoop Success!\n");
goto done;
case NETLOOP_FAIL:
net_cleanup_loop();
/* Invalidate the last protocol */
eth_set_last_protocol(BOOTP);
debug_cond(DEBUG_INT_STATE, "--- NetLoop Fail!\n");
goto done;
case NETLOOP_CONTINUE:
continue;
}
}
done:
#ifdef CONFIG_USB_KEYBOARD
net_busy_flag = 0;
#endif
#ifdef CONFIG_CMD_TFTPPUT
/* Clear out the handlers */
net_set_udp_handler(NULL);
net_set_icmp_handler(NULL);
#endif
return ret;
}
int NetLoop(enum proto_t protocol)
{
int ret = -1;
NetRestarted = 0;
NetDevExists = 0;
NetTryCount = 1;
debug_cond(DEBUG_INT_STATE, "--- NetLoop Entry\n");
net_init();
restart:
net_set_state(NETLOOP_CONTINUE);
/*
* Start the ball rolling with the given start function. From
* here on, this code is a state machine driven by received
* packets and timer events.
*/
debug_cond(DEBUG_INT_STATE, "--- NetLoop Init\n");
NetInitLoop();
switch (net_check_prereq(protocol)) {
case 1:
case 2:
return -1;
case 0:
NetDevExists = 1;
NetBootFileXferSize = 0;
switch (protocol) {
case TFTPGET:
#ifdef CONFIG_CMD_TFTPPUT
case TFTPPUT:
#endif
/* always use ARP to get server ethernet address */
TftpStart(protocol);
break;
case PING:
ping_start();
break;
default:
break;
}
break;
}
/*
* Main packet reception loop. Loop receiving packets until
* someone sets `net_state' to a state that terminates.
*/
for (;;) {
/*
* Check the ethernet for a new packet. The ethernet
* receive routine will process it.
*/
eth_rx();
/*
* Abort if q was pressed.
*/
if ('q' == ftuart_kbhit()) {
/* cancel any ARP that may not have completed */
NetArpWaitPacketIP = 0;
net_cleanup_loop();
puts("\nAbort\n");
/* include a debug print as well incase the debug
messages are directed to stderr */
debug_cond(DEBUG_INT_STATE, "--- NetLoop Abort!\n");
goto done;
}
ArpTimeoutCheck();
/*
* Check for a timeout, and run the timeout handler
* if we have one.
*/
if (timeHandler && ((get_timer(0) - timeStart) > timeDelta)) {
thand_f *x;
debug_cond(DEBUG_INT_STATE, "--- NetLoop timeout\n");
x = timeHandler;
timeHandler = (thand_f *)0;
(*x)();
}
switch (net_state) {
case NETLOOP_RESTART:
NetRestarted = 1;
goto restart;
case NETLOOP_SUCCESS:
net_cleanup_loop();
if (NetBootFileXferSize > 0) {
prints("Bytes transferred = %ld (%lx hex)\n",
NetBootFileXferSize,
NetBootFileXferSize);
}
ret = NetBootFileXferSize;
debug_cond(DEBUG_INT_STATE, "--- NetLoop Success!\n");
goto done;
case NETLOOP_FAIL:
net_cleanup_loop();
debug_cond(DEBUG_INT_STATE, "--- NetLoop Fail!\n");
goto done;
case NETLOOP_CONTINUE:
continue;
}
}
done:
#ifdef CONFIG_CMD_TFTPPUT
/* Clear out the handlers */
net_set_udp_handler(NULL);
net_set_icmp_handler(NULL);
#endif
return ret;
}
