/*
* Transfer the firmware image to RAM for execution by the microcontroller.
*
* Architecturally, the DMA engine is bidirectional, and can potentially even
* transfer between GTT locations. This functionality is left out of the API
* for now as there is no need for it.
*
* Note that GuC needs the CSS header plus uKernel code to be copied by the
* DMA engine in one operation, whereas the RSA signature is loaded via MMIO.
*/
static int guc_ucode_xfer_dma(struct drm_i915_private *dev_priv,
struct i915_vma *vma)
{
struct intel_uc_fw *guc_fw = &dev_priv->guc.fw;
unsigned long offset;
struct sg_table *sg = vma->pages;
u32 status, rsa[UOS_RSA_SCRATCH_MAX_COUNT];
int i, ret = 0;
/* where RSA signature starts */
offset = guc_fw->rsa_offset;
/* Copy RSA signature from the fw image to HW for verification */
sg_pcopy_to_buffer(sg->sgl, sg->nents, rsa, sizeof(rsa), offset);
for (i = 0; i < UOS_RSA_SCRATCH_MAX_COUNT; i++)
I915_WRITE(UOS_RSA_SCRATCH(i), rsa[i]);
/* The header plus uCode will be copied to WOPCM via DMA, excluding any
* other components */
I915_WRITE(DMA_COPY_SIZE, guc_fw->header_size + guc_fw->ucode_size);
/* Set the source address for the new blob */
offset = guc_ggtt_offset(vma) + guc_fw->header_offset;
I915_WRITE(DMA_ADDR_0_LOW, lower_32_bits(offset));
I915_WRITE(DMA_ADDR_0_HIGH, upper_32_bits(offset) & 0xFFFF);
/*
* Set the DMA destination. Current uCode expects the code to be
* loaded at 8k; locations below this are used for the stack.
*/
I915_WRITE(DMA_ADDR_1_LOW, 0x2000);
I915_WRITE(DMA_ADDR_1_HIGH, DMA_ADDRESS_SPACE_WOPCM);
/* Finally start the DMA */
I915_WRITE(DMA_CTRL, _MASKED_BIT_ENABLE(UOS_MOVE | START_DMA));
/*
* Wait for the DMA to complete & the GuC to start up.
* NB: Docs recommend not using the interrupt for completion.
* Measurements indicate this should take no more than 20ms, so a
* timeout here indicates that the GuC has failed and is unusable.
* (Higher levels of the driver will attempt to fall back to
* execlist mode if this happens.)
*/
ret = wait_for(guc_ucode_response(dev_priv, &status), 100);
DRM_DEBUG_DRIVER("DMA status 0x%x, GuC status 0x%x\n",
I915_READ(DMA_CTRL), status);
if ((status & GS_BOOTROM_MASK) == GS_BOOTROM_RSA_FAILED) {
DRM_ERROR("GuC firmware signature verification failed\n");
ret = -ENOEXEC;
}
DRM_DEBUG_DRIVER("returning %d\n", ret);
return ret;
}
/* Copy RSA signature from the fw image to HW for verification */
static void guc_xfer_rsa(struct intel_guc *guc, struct i915_vma *vma)
{
struct drm_i915_private *dev_priv = guc_to_i915(guc);
u32 rsa[UOS_RSA_SCRATCH_COUNT];
int i;
sg_pcopy_to_buffer(vma->pages->sgl, vma->pages->nents,
rsa, sizeof(rsa), guc->fw.rsa_offset);
for (i = 0; i < UOS_RSA_SCRATCH_COUNT; i++)
I915_WRITE(UOS_RSA_SCRATCH(i), rsa[i]);
}
/* Copy RSA signature from the fw image to HW for verification */
static void guc_xfer_rsa(struct intel_guc *guc)
{
struct drm_i915_private *dev_priv = guc_to_i915(guc);
struct intel_uc_fw *fw = &guc->fw;
struct sg_table *pages = fw->obj->mm.pages;
u32 rsa[UOS_RSA_SCRATCH_COUNT];
int i;
sg_pcopy_to_buffer(pages->sgl, pages->nents,
rsa, sizeof(rsa), fw->rsa_offset);
for (i = 0; i < UOS_RSA_SCRATCH_COUNT; i++)
I915_WRITE(UOS_RSA_SCRATCH(i), rsa[i]);
}
/* Copy RSA signature from the fw image to HW for verification */
static int guc_xfer_rsa(struct intel_guc *guc, struct i915_vma *vma)
{
struct drm_i915_private *dev_priv = guc_to_i915(guc);
struct intel_uc_fw *guc_fw = &guc->fw;
struct sg_table *sg = vma->pages;
u32 rsa[UOS_RSA_SCRATCH_COUNT];
int i;
if (sg_pcopy_to_buffer(sg->sgl, sg->nents, rsa, sizeof(rsa),
guc_fw->rsa_offset) != sizeof(rsa))
return -EINVAL;
for (i = 0; i < UOS_RSA_SCRATCH_COUNT; i++)
I915_WRITE(UOS_RSA_SCRATCH(i), rsa[i]);
return 0;
}
