/** Event handler for the library USB Configuration Changed event. */
void EVENT_USB_Device_ConfigurationChanged(void)
{
bool ConfigSuccess = true;
/* Configure the device endpoints according to the selected mode */
if (CurrentFirmwareMode == MODE_USART_BRIDGE)
{
ConfigSuccess &= CDC_Device_ConfigureEndpoints(&VirtualSerial_CDC_Interface);
/* Configure the UART flush timer - run at Fcpu/1024 for maximum interval before overflow */
TCCR0B = ((1 << CS02) | (1 << CS00));
/* Initialize ring buffers used to hold serial data between USB and software UART interfaces */
RingBuffer_InitBuffer(&USBtoUART_Buffer, USBtoUART_Buffer_Data, sizeof(USBtoUART_Buffer_Data));
RingBuffer_InitBuffer(&UARTtoUSB_Buffer, UARTtoUSB_Buffer_Data, sizeof(UARTtoUSB_Buffer_Data));
/* Start the software USART */
SoftUART_Init();
}
else
{
ConfigSuccess &= Endpoint_ConfigureEndpoint(AVRISP_DATA_OUT_EPADDR, EP_TYPE_BULK, AVRISP_DATA_EPSIZE, 1);
if ((AVRISP_DATA_IN_EPADDR & ENDPOINT_EPNUM_MASK) != (AVRISP_DATA_OUT_EPADDR & ENDPOINT_EPNUM_MASK))
ConfigSuccess &= Endpoint_ConfigureEndpoint(AVRISP_DATA_IN_EPADDR, EP_TYPE_BULK, AVRISP_DATA_EPSIZE, 1);
/* Configure the V2 protocol packet handler */
V2Protocol_Init();
}
LEDs_SetAllLEDs(ConfigSuccess ? LEDMASK_USB_READY : LEDMASK_USB_ERROR);
}
/** Main program entry point. This routine contains the overall program flow, including initial
* setup of all components and the main program loop.
*/
int main(void)
{
SetupHardware();
V2Protocol_Init();
LEDs_SetAllLEDs(LEDMASK_USB_NOTREADY);
sei();
for (;;)
{
#if (BOARD == BOARD_USBTINYMKII)
/* On the USBTINY-MKII target, there is a secondary LED which indicates the current selected power
mode - either VBUS, or sourced from the VTARGET pin of the programming connectors */
LEDs_ChangeLEDs(LEDMASK_VBUSPOWER, (PIND & (1 << 0)) ? 0 : LEDMASK_VBUSPOWER);
#endif
AVRISP_Task();
USB_USBTask();
}
}
