static void suc_add_usb_devices(void) { android_usb_pdata.products[0].product_id = android_usb_pdata.product_id; android_usb_pdata.serial_number = board_serialno(); msm_hsusb_pdata.serial_number = board_serialno(); msm_device_hsusb.dev.platform_data = &msm_hsusb_pdata; config_supersonic_usb_id_gpios(0); config_gpio_table(usb_phy_3v3_table, ARRAY_SIZE(usb_phy_3v3_table)); gpio_set_value(SUPERSONIC_USB_PHY_3V3_ENABLE, 1); platform_device_register(&msm_device_hsusb); platform_device_register(&usb_mass_storage_device); platform_device_register(&android_usb_device); }
/* system_rev == higher 16bits of PCBID XA -> 0000FFFF -> 0x0000 XB -> 0101FFFF -> 0x0101 XC -> 0202FFFF -> 0x0202 */ static void __init supersonic_init(void) { int ret; struct kobject *properties_kobj; printk("supersonic_init() revision=%d\n", system_rev); android_usb_pdata.serial_number = board_serialno(); msm_hw_reset_hook = supersonic_reset; OJ_BMA_power(); msm_acpu_clock_init(&supersonic_clock_data); #if defined(CONFIG_MSM_SERIAL_DEBUGGER) msm_serial_debug_init(MSM_UART1_PHYS, INT_UART1, &msm_device_uart1.dev, 1, MSM_GPIO_TO_INT(SUPERSONIC_GPIO_UART1_RX)); #endif #ifdef CONFIG_ARCH_QSD8X50 bt_export_bd_address(); #endif /* set the gpu power rail to manual mode so clk en/dis will not * turn off gpu power, and hang it on resume */ supersonic_kgsl_power_rail_mode(0); supersonic_kgsl_power(true); #ifdef CONFIG_SPI_QSD msm_device_spi.dev.platform_data = &supersonic_spi_pdata; #endif msm_device_uart_dm1.dev.platform_data = &msm_uart_dm1_pdata; config_gpio_table(usb_phy_3v3_table, ARRAY_SIZE(usb_phy_3v3_table)); config_gpio_table(camera_off_gpio_table, ARRAY_SIZE(camera_off_gpio_table)); gpio_request(SUPERSONIC_GPIO_TP_EN, "tp_en"); gpio_direction_output(SUPERSONIC_GPIO_TP_EN, 0); supersonic_audio_init(); supersonic_init_panel(); #ifdef CONFIG_MICROP_COMMON supersonic_microp_init(); #endif platform_add_devices(devices, ARRAY_SIZE(devices)); if (!opt_usb_h2w_sw) { msm_device_hsusb.dev.platform_data = &msm_hsusb_pdata; config_supersonic_usb_id_gpios(0); } i2c_register_board_info(0, i2c_devices, ARRAY_SIZE(i2c_devices)); ret = supersonic_init_mmc(system_rev); if (ret != 0) pr_crit("%s: Unable to initialize MMC\n", __func__); properties_kobj = kobject_create_and_add("board_properties", NULL); if (properties_kobj) ret = sysfs_create_group(properties_kobj, &supersonic_properties_attr_group); if (!properties_kobj || ret) pr_err("failed to create board_properties\n"); msm_init_pmic_vibrator(); }