uint64_t cvmx_clock_get_rate(cvmx_clock_t clock)
{
#if !defined(CVMX_BUILD_FOR_LINUX_HOST)
return cvmx_clock_get_rate_node(cvmx_get_node_num(), clock);
#else
return cvmx_clock_get_rate_node(0, clock);
#endif
}
void init_octeon_pcie(void)
{
int first_busno;
int i;
int rc = 0;
int node = cvmx_get_node_num();
struct pci_controller *hose;
int pcie_port;
first_busno = OCTEON_FIRST_PCIE_BUSNO;
memset(&hose_pcie[0], 0, sizeof(hose_pcie[0]) * num_pcie_ports);
debug("Starting PCIE on node %d\n", node);
for (i = 0; i < num_pcie_ports; i++) {
pcie_port = ((node << 4) | i);
rc = cvmx_pcie_rc_initialize(pcie_port);
if (rc != 0)
continue;
mdelay(1000); /* Should delay 1 second according to standard */
hose = &hose_pcie[i];
hose->priv_data = (void *)&oct_pcie_data[i];
oct_pcie_data[i].pcie_port = pcie_port;;
hose->config_table = pci_board_config_table;
hose->first_busno = first_busno;
hose->last_busno = 0xff;
/* PCI I/O space (Sub-DID == 2) */
pci_set_region(hose->regions + 0,
octeon_pcie_region_info[i].io_base,
octeon_pcie_region_info[i].io_base,
octeon_pcie_region_info[i].io_size,
PCI_REGION_IO);
/* PCI memory space (Sub-DID == 3) */
pci_set_region(hose->regions + 1,
octeon_pcie_region_info[i].mem_base,
octeon_pcie_region_info[i].mem_base,
octeon_pcie_region_info[i].mem_size,
PCI_REGION_MEM);
hose->region_count = 2;
pci_set_ops(hose,
octeon_pcie_read_config_byte,
octeon_pcie_read_config_word,
octeon_pcie_read_config_dword,
octeon_pcie_write_config_byte,
octeon_pcie_write_config_word,
octeon_pcie_write_config_dword);
pci_register_hose(hose);
hose->last_busno = pci_hose_scan(hose);
debug("PCIe: port=%d, first_bus=%d, last_bus=%d,\n\t"
"mem_base=0x%x, mem_size=0x%x, io_base=0x%x, io_size=0x%x\n",
octeon_get_pcie_port(hose),
hose->first_busno, hose->last_busno,
octeon_pcie_region_info[i].mem_base,
octeon_pcie_region_info[i].mem_size,
octeon_pcie_region_info[i].io_base,
octeon_pcie_region_info[i].io_size);
first_busno = hose->last_busno + 1;
#if CONFIG_OCTEON_PCI_ENABLE_32BIT_MAPPING
if (OCTEON_IS_OCTEON2() || OCTEON_IS_OCTEON3()) {
cvmx_pemx_bar_ctl_t bar_ctl;
cvmx_pemx_bar1_indexx_t pemx_bar1_indexx;
uint64_t bar_base;
int j;
/* Setup BAR1 to map bus address 0x0 to the base of
* u-boot's TLB mapping. This allows us to have u-boot
* located anywhere in memory (including above 32 bit
* addressable space) and still have 32 bit PCI devices
* have access to memory that is statically allocated
* or malloced by u-boot, both of which are TLB mapped.
*/
cvmx_write_csr_node(node, CVMX_PEMX_P2N_BAR1_START(i), 0);
/* Disable bar0/bar2, as we are not using them here */
cvmx_write_csr_node(node, CVMX_PEMX_P2N_BAR0_START(i), -1);
cvmx_write_csr_node(node, CVMX_PEMX_P2N_BAR2_START(i), -1);
/* Select 64 MByte mapping size for bar 1 on
* all ports
*/
bar_ctl.u64 = cvmx_read_csr_node(node, CVMX_PEMX_BAR_CTL(i));
bar_ctl.s.bar1_siz = 1; /* 64MB */
bar_ctl.s.bar2_enb = 0;
cvmx_write_csr_node(node, CVMX_PEMX_BAR_CTL(i), bar_ctl.u64);
/* Configure the regions in bar 1 to map to the
* DRAM used by u-boot.
*/
/* Round down to 4MByte boundary to meet BAR mapping
* requirements
*/
bar_base = gd->bd->bi_uboot_ram_addr & ~0x3fffffull;
debug("pcie: port %d, setting BAR base to 0x%llx\n",
i, bar_base);
pemx_bar1_indexx.u64 = 0;
pemx_bar1_indexx.s.addr_v = 1;
pemx_bar1_indexx.s.end_swp = 1;
pemx_bar1_indexx.s.ca = 1;
for (j = 0; j < 16; j++) {
pemx_bar1_indexx.s.addr_idx =
(bar_base + 4 * 1024 * 1024 * j) >> 22;
cvmx_write64_uint64(CVMX_PEMX_BAR1_INDEXX(j, i),
pemx_bar1_indexx.u64);
}
}
#endif /* CONFIG_OCTEON_PCI_ENABLE_32BIT_MAPPING */
}