void main(unsigned long bist) { if (bist == 0) { if (memory_initialized()) hard_reset(); } /* Set southbridge and superio gpios */ mb_gpio_init(); smscsuperio_enable_serial(SERIAL_DEV, CONFIG_TTYS0_BASE); console_init(); /* Halt if there was a built in self test failure. */ report_bist_failure(bist); /* disable TCO timers */ i82801dx_halt_tco_timer(); /* Setup mainboard specific registers */ mb_early_setup(); /* Initialize memory */ sdram_initialize(); }
void mainboard_romstage_entry(unsigned long bist) { const u8 spd_addrmap[4] = { 0x50, 0x51, 0, 0 }; if (bist == 0) enable_lapic(); /* Disable watchdog timer */ RCBA32(0x3410) = RCBA32(0x3410) | 0x20; /* Set southbridge and Super I/O GPIOs. */ mb_gpio_init(); nm10_enable_lpc(); winbond_enable_serial(SERIAL_DEV, CONFIG_TTYS0_BASE); console_init(); report_bist_failure(bist); enable_smbus(); pineview_early_initialization(); post_code(0x30); printk(BIOS_DEBUG, "Initializing memory\n"); sdram_initialize(0, spd_addrmap); printk(BIOS_DEBUG, "Memory initialized\n"); post_code(0x31); ram_check(0x200000,0x300000); rcba_config(); }
void main(unsigned long bist) { /* Set southbridge and Super I/O GPIOs. */ mb_gpio_init(); smscsuperio_enable_serial(SERIAL_DEV, CONFIG_TTYS0_BASE); console_init(); report_bist_failure(bist); enable_smbus(); dump_spd_registers(); sdram_set_registers(); sdram_set_spd_registers(); sdram_enable(); }
/************************************************* * enable the dedicated function in tim5690 board. * This function called early than rs690_enable. *************************************************/ static void mainboard_enable(device_t dev) { u16 gpio_base = IT8712F_SIMPLE_IO_BASE; #if CONFIG_VGA_ROM_RUN rs690_vbios_regs vbios_regs; u8 port2; #endif printk(BIOS_INFO, "Mainboard tim5690 Enable. dev=0x%p\n", dev); mb_gpio_init(&gpio_base); #if CONFIG_VGA_ROM_RUN /* The LCD's panel id seletion by switch. */ port2 = inb(gpio_base+1); lcd_panel_id(&vbios_regs, ((~port2) & 0xf)); /* No support TV */ vbios_regs.int15_regs.fun05_tv_standard = TV_MODE_NO; vgabios_init(&vbios_regs); #endif set_thermal_config(); }
/************************************************* * enable the dedicated function in tim5690 board. * This function called early than rs690_enable. *************************************************/ static void tim5690_enable(device_t dev) { rs690_vbios_regs vbios_regs; u16 gpio_base = IT8712F_SIMPLE_IO_BASE; u8 port2; printk(BIOS_INFO, "Mainboard tim5690 Enable. dev=0x%p\n", dev); mb_gpio_init(&gpio_base); /* The LCD's panel id seletion by switch. */ port2 = inb(gpio_base+1); lcd_panel_id(&vbios_regs, ((~port2) & 0xf)); /* No support TV */ vbios_regs.int15_regs.fun05_tv_standard = TV_MODE_NO; vgabios_init(&vbios_regs); #if (CONFIG_GFXUMA == 1) msr_t msr, msr2; /* TOP_MEM: the top of DRAM below 4G */ msr = rdmsr(TOP_MEM); printk(BIOS_INFO, "%s, TOP MEM: msr.lo = 0x%08x, msr.hi = 0x%08x\n", __func__, msr.lo, msr.hi); /* TOP_MEM2: the top of DRAM above 4G */ msr2 = rdmsr(TOP_MEM2); printk(BIOS_INFO, "%s, TOP MEM2: msr2.lo = 0x%08x, msr2.hi = 0x%08x\n", __func__, msr2.lo, msr2.hi); switch (msr.lo) { case 0x10000000: /* 256M system memory */ uma_memory_size = 0x2000000; /* 32M recommended UMA */ break; case 0x18000000: /* 384M system memory */ uma_memory_size = 0x4000000; /* 64M recommended UMA */ break; case 0x20000000: /* 512M system memory */ uma_memory_size = 0x4000000; /* 64M recommended UMA */ break; default: /* 1GB and above system memory */ uma_memory_size = 0x8000000; /* 128M recommended UMA */ break; } uma_memory_base = msr.lo - uma_memory_size; /* TOP_MEM1 */ printk(BIOS_INFO, "%s: uma size 0x%08llx, memory start 0x%08llx\n", __func__, uma_memory_size, uma_memory_base); /* TODO: TOP_MEM2 */ #else uma_memory_size = 0x8000000; /* 128M recommended UMA */ uma_memory_base = 0x38000000; /* 1GB system memory supposed */ #endif set_thermal_config(); }