static uint8_t verifyF(__uint24 cap){
datIn;
PORTB|=(1<<3)|(1<<4)|(1<<5);//CE# OE# WE# all high
PORTB&=~((1<<3)|(1<<4));//CE# OE# to low
__uint24 addr;
for (addr=0;addr<cap;++addr){
shift24(addr);
if (rdDat()!=0xFF){
serialWrB('E');
PORTB|=(1<<3)|(1<<4);//CE# OE# to high
return 1;
}
}
serialWrB('S');
PORTB|=(1<<3)|(1<<4);//CE# OE# to high
return 0;
}
static void ReadChip(__uint24 sz){//sends entire flash content to serial
datIn;
PORTB|=(1<<3)|(1<<4)|(1<<5);//CE# OE# WE# all high
PORTB&=~((1<<3)|(1<<4));//CE# OE# to low
__uint24 addr;
for (addr=0;addr<sz;++addr){
shift24(addr);
serialWrB(rdDat());
}
PORTB|=(1<<3)|(1<<4);//CE# OE# to high
}
static inline void pgmB(__uint24 addr,uint8_t dat){
datOut;
PORTB&=~(1<<4);//set OE# to low
PORTB|=(1<<3)|(1<<5);//set CE# and WE# to high
PORTB|=(1<<4);//set OE# to high
sendCmd(0x5555,0xAA);
sendCmd(0x2AAA,0x55);
sendCmd(0x5555,0xA0);
sendCmd(addr,dat);
//This assumes a delay will follow the writing of the byte
serialWrB('N');
}
__attribute__((noreturn)) void main(void){
cli();
//set-up serial communications
DDRD=28;//3 serial pins on d.2 to d.4 d.5 to d.7 contain msbs for flash data d.0 to d.4 is in port C
DDRB=62;//serial clocks (B.1 SHCP) (B.2 Latch) (B.3 CE#) (B.4 OE#) (B.5 WE#)
UBRR0H=0;
UBRR0L=3;//set to 0.5M baud
UCSR0A|=2;//double speed aysnc
UCSR0B = (1<<RXEN0)|(1<<TXEN0);//Enable receiver and transmitter
UCSR0C=6;//async 1 stop bit 8bit char no parity bits
_delay_ms(50);
StringPgm(PSTR("RDY"));
USART_Receive();//wait for handshake
char mode = USART_Receive();//wait for mode
StringPgm(PSTR("RDY"));
serialWrB(readId(0));
uint8_t cap=readId(1);
serialWrB(cap);
__uint24 capacity=524288L;
switch(cap){
case 0xB5:
capacity=131072L;
case 0xB6:
capacity=262144L;
break;
}
if(mode=='W'){
chipErase();
serialWrB('D');
verifyF(capacity);
__uint24 x;
for (x=0;x<capacity;++x){
pgmB(x,USART_Receive());
serialWrB(readB(x));
}
}else if(mode=='R')
ReadChip(capacity);
while(1);
}
static void StringPgm(const char * str){
do{
serialWrB(pgm_read_byte_near(str));
}while(pgm_read_byte_near(++str));
}
void menu(void) {
uint16_t x,y,z;
while (1) {
switch (selection((const char**)menu_table,10)) {
case 0:
#ifdef MT9D111
setRes(QVGA);
setColor(RGB565);
MT9D111Refresh();
editRegs(0);
#else
setColor(RGB565);
setRes(QVGA);
editRegs();
#endif
break;
case 1:
#ifdef MT9D111
setRes(QVGA);
setColor(RGB565);
MT9D111Refresh();
editRegs(1);
#else
#ifdef ov7740
setmatrix(selection((const char**)maxtrix_table,2));
#else
setmatrix(selection((const char**)maxtrix_table,3));
#endif
tft_setOrientation(1);
capImg();
tft_setDisplayDirect(DOWN2UP);
#endif
break;
case 2:
#ifdef ov7670
initCam(0);
#else
initCam();
#endif
break;
#ifndef MT9D111
case 3:
//compare matrices
tft_setOrientation(1);
do {
getPoint(&x,&y,&z);
uint8_t a;
#ifdef ov7670
for (a=0; a<3; a++) {
#elif defined ov7740
for (a=0; a<2; a++) {
#endif
setmatrix(a);
capImg();
}
}
while (z < 10);
tft_setDisplayDirect(DOWN2UP);
break;
#endif
case 4:
setColor(RGB565);
setRes(QQVGA);
#ifdef MT9D111
MT9D111Refresh();
#endif
do {
getPoint(&x,&y,&z);
tft_setOrientation(1);
capImgqqvga(160);
tft_setDisplayDirect(DOWN2UP);
} while(z<10);
setRes(QVGA);
break;
case 5:
#ifdef ov7670
setColor(RGB565);
#endif
gammaEdit();
break;
case 6:
//File browser
//start by listing files
#ifdef haveSDcard
browserSD();
#else
tft_drawStringP(PSTR("No SD card"),16,320,3,WHITE);
_delay_ms(666);
#endif
break;
case 7:
#ifdef ov7670
{ uint8_t pick=selection((const char**)wb_table,7);//registers from http://thinksmallthings.wordpress.com/2012/10/25/white-balance-control-with-ov7670/
if(pick==1||pick==2) {
wrReg(0x13, 0xE7);
wrReg(0x6F, 0x9E|(pick&1));
} else {
wrReg(0x13, 0xE5);
switch(pick) {
case 2:
wrReg(0x01, 0x5A);
wrReg(0x02, 0x5C);
break;
case 3:
wrReg(0x01, 0x58);
wrReg(0x02, 0x60);
break;
case 4:
wrReg(0x01, 0x84);
wrReg(0x02, 0x4C);
break;
case 5:
wrReg(0x01, 0x96);
wrReg(0x02, 0x40);
break;
}
}
tft_setOrientation(1);
setRes(QVGA);
setColor(RGB565);
capImg();
tft_setDisplayDirect(DOWN2UP);
}
#endif
break;
case 8:
#ifdef ov7670
wrReg(0x1e,rdReg(0x1e)&(~(1<<5))&(~(1<<4)));
#endif
{
#ifdef MT9D111
uint8_t reso=selection((const char**)res_tab,4);
#else
uint8_t reso=selection((const char**)res_tab,3);
#endif
#ifdef MT9D111
wrReg16(0xF0,2);//page 2
wrReg16(0x0D,0);
setColor(YUV422);
#endif
switch(reso) {
case 0:
#ifdef ov7670
wrReg(REG_COM7, COM7_BAYER); // BGBGBG... GRGRGR...
#elif defined MT9D111
//setup jpeg
MT9D111JPegCapture();
#endif
break;
case 1:
#ifdef MT9D111
setRes(SVGA);
#else
setRes(QVGA);
setColor(YUV422);
#endif
break;
#ifdef MT9D111
case 2:
setRes(QVGA);
break;
#endif
default:
goto theEnd;
break;
}
#ifdef ov7670
_delay_ms(200);
if(reso)
wrReg(0x11,1);
else
wrReg(0x11,2);
#endif
tft_setOrientation(1);
do {
#ifdef MT9D111
switch(reso) {
case 0:
{ uint32_t jpgSize=capJpeg();
serialWrB('R');
serialWrB('D');
serialWrB('Y');
uint16_t w;
uint8_t h=0;
serialWrB(jpgSize&255);
serialWrB(jpgSize>>8);
serialWrB(jpgSize>>16);
serialWrB(jpgSize>>24);
while(jpgSize) {
if(jpgSize>=640) {
for (w=0; w<320; ++w) {
tft_setXY(h,w);
BSend();
}
++h;
jpgSize-=640;
} else {
for(w=0; w<jpgSize/2; ++w) {
tft_setXY(h,w);
BSend();
}
if(jpgSize&1) {
tft_setXY(h,w);
uint16_t res=tft_readRegister(0x22);
serialWrB(res>>8);
}
jpgSize=0;
}
}
}
break;
case 1:
capImgPC();
break;
case 2:
capImgPCqvga();
break;
}
#else
if(reso)
capImgPCqvga();
else
capImgPC();
#endif
getPoint(&x,&y,&z);
} while(z<10);
theEnd:
tft_setDisplayDirect(DOWN2UP);
}
break;
case 9:
switch(selection((const char**)menu_tablep2,3)) {
case 0:
{
tft_drawImage_P(exit_icon,32,32,0,0);
uint16_t x1,y1;
do {
getPoint(&x,&y,&z);
} while(z<10);
if((y<=32)&&(x<=32))
break;
tft_fillCircle(x,y,4,WHITE);
while(1) {
x1=x;
y1=y;
do {
getPoint(&x,&y,&z);
} while(z<10);
tft_fillRectangle(224,320,16,36,BLACK);
tft_fillCircle(x1,y1,4,BLACK);
tft_fillCircle(x,y,4,WHITE);
if((y<=32)&&(x<=32))
break;
char temp[6];
utoa(x,temp,10);
tft_drawString(temp,224,320,1,WHITE);
utoa(y,temp,10);
tft_drawString(temp,232,320,1,WHITE);
}
}
break;
case 1:
//time lapse
#ifdef MT9D111
//MT9D111Refresh();
//Since This is a time lapse we want to be in "video" mode
MT9D111JPegCapture();
/*do{
_delay_ms(10);
wrReg16(0xC6,(1<<15)|(1<<13)|(1<<8)|4);
}while(rdReg16(0xC8)<4);
waitStateMT9D111(3);*/
#endif
#ifdef haveSDcard
{
char buf[24];
uint16_t imgc=0;
tft_setOrientation(1);
do {
FIL Fo;
#ifdef MT9D111
uint32_t jpgSize=capJpeg();
#else
capImg();
#endif
utoa(imgc,buf,10);
#ifdef MT9D111
strcat(buf,".JPG");
#else
strcat(buf,".RAW");
#endif
f_open(&Fo,buf,FA_WRITE|FA_CREATE_ALWAYS);
++imgc;
UINT written;
uint16_t w;
uint8_t h;
uint16_t cpybuf[320];
#ifdef MT9D111
h=0;
uint8_t * cpyptr=cpybuf;
for(w=0; w<619; ++w)
*cpyptr++=pgm_read_byte_near(jpegHeader+w);
f_write(&Fo,cpybuf,619,&written);
while(jpgSize) {
if(jpgSize>=640) {
for (w=0; w<320; ++w) {
tft_setXY(h,w);
cpybuf[w]=__builtin_bswap16(tft_readRegister(0x22));//Either bytes need to be swapped or a byte is being missed
}
f_write(&Fo,cpybuf,640,&written);
++h;
jpgSize-=640;
} else {
for(w=0; w<jpgSize/2; ++w) {
tft_setXY(h,w);
cpybuf[w]=__builtin_bswap16(tft_readRegister(0x22));
}
f_write(&Fo,cpybuf,jpgSize,&written);
if(jpgSize&1) {
tft_setXY(h,w);
cpybuf[w]=tft_readRegister(0x22);
f_write(&Fo,&cpybuf[w],1,&written);
}
jpgSize=0;
}
}
cpybuf[0]=0xFFD9;
f_write(&Fo,cpybuf,2,&written);
#else
for (h=0; h<240; ++h) {
for (w=0; w<320; ++w) {
tft_setXY(h,w);
cpybuf[w]=tft_readRegister(0x22);
}
f_write(&Fo,cpybuf,640,&written);
}
#endif
f_close(&Fo);
getPoint(&x,&y,&z);
} while(z<10);
tft_setDisplayDirect(DOWN2UP);
#ifdef MT9D111
MT9D111DoPreview();
#endif
}
#else
tft_drawStringP(PSTR("No SD card"),16,320,3,WHITE);
_delay_ms(666);
#endif
break;
case 2:
//previous page
break;
}
break;
}
}
}
static void BSend(void) {
uint16_t res=tft_readRegister(0x22);
serialWrB(res>>8);
serialWrB(res&255);
}
