Esempio n. 1
0
static int
ed_isa_probe_Novell(device_t dev)
{
	struct ed_softc *sc = device_get_softc(dev);
	int flags = device_get_flags(dev);
	int err;

	err = ed_probe_Novell(dev, 0, flags);
	if (err)
		return err;
	ed_Novell_read_mac(sc);
	/*
	 * Final sanity check for Gateway Ethernet cards before
	 * believing that they really are Gateway AT.
	 * XXX I think this is stale.
	 */
	if ((ED_FLAGS_GETTYPE(flags) == ED_FLAGS_GWETHER) &&
	    (sc->enaddr[2] == 0x86)) {
		sc->type_str = "Gateway AT";
	}
	
	return (0);
}
Esempio n. 2
0
/*
 * Probe and vendor-specific initialization routine for NE1000/2000 boards
 */
int
ed_probe_Novell_generic(device_t dev, int flags)
{
	struct ed_softc *sc = device_get_softc(dev);
	u_int   memsize;
	int	error;
	u_char  tmp;
	static char test_pattern[32] = "THIS is A memory TEST pattern";
	char    test_buffer[32];

	/* Reset the board */
	if (ED_FLAGS_GETTYPE(flags) == ED_FLAGS_GWETHER) {
		ed_asic_outb(sc, ED_NOVELL_RESET, 0);
		DELAY(200);
	}
	tmp = ed_asic_inb(sc, ED_NOVELL_RESET);

	/*
	 * I don't know if this is necessary; probably cruft leftover from
	 * Clarkson packet driver code. Doesn't do a thing on the boards I've
	 * tested. -DG
	 */
	ed_asic_outb(sc, ED_NOVELL_RESET, tmp);
	DELAY(5000);

	/*
	 * This is needed because some NE clones apparently don't reset the
	 * NIC properly (or the NIC chip doesn't reset fully on power-up) XXX
	 * - this makes the probe invasive! ...Done against my better
	 * judgement. -DLG
	 */
	ed_nic_outb(sc, ED_P0_CR, ED_CR_RD2 | ED_CR_STP);
	DELAY(5000);

	/* Make sure that we really have an 8390 based board */
	if (!ed_probe_generic8390(sc))
		return (ENXIO);

	sc->vendor = ED_VENDOR_NOVELL;
	sc->mem_shared = 0;
	sc->cr_proto = ED_CR_RD2;

	/*
	 * Test the ability to read and write to the NIC memory. This has the
	 * side affect of determining if this is an NE1000 or an NE2000.
	 */

	/*
	 * This prevents packets from being stored in the NIC memory when the
	 * readmem routine turns on the start bit in the CR.
	 */
	ed_nic_outb(sc, ED_P0_RCR, ED_RCR_MON);

	/* Temporarily initialize DCR for byte operations */
	ed_nic_outb(sc, ED_P0_DCR, ED_DCR_FT1 | ED_DCR_LS);

	ed_nic_outb(sc, ED_P0_PSTART, 8192 / ED_PAGE_SIZE);
	ed_nic_outb(sc, ED_P0_PSTOP, 16384 / ED_PAGE_SIZE);

	/*
	 * Some devices identify themselves.  Some of those devices
	 * can't handle being probed, so we allow forcing a mode.  If
	 * these flags are set, force it, otherwise probe.
	 */
	if (flags & ED_FLAGS_FORCE_8BIT_MODE) {
		sc->isa16bit = 0;
		sc->type = ED_TYPE_NE1000;
		sc->type_str = "NE1000";
	} else if (flags & ED_FLAGS_FORCE_16BIT_MODE) {
		sc->isa16bit = 1;
		sc->type = ED_TYPE_NE2000;
		sc->type_str = "NE2000";
		ed_nic_outb(sc, ED_P0_DCR, ED_DCR_WTS | ED_DCR_FT1 | ED_DCR_LS);
		ed_nic_outb(sc, ED_P0_PSTART, 16384 / ED_PAGE_SIZE);
		ed_nic_outb(sc, ED_P0_PSTOP, 32768 / ED_PAGE_SIZE);
	} else {
		/*
		 * Write a test pattern in byte mode. If this fails, then there
		 * probably isn't any memory at 8k - which likely means that the board
		 * is an NE2000.
		 */
		ed_pio_writemem(sc, test_pattern, 8192, sizeof(test_pattern));
		ed_pio_readmem(sc, 8192, test_buffer, sizeof(test_pattern));

		if (bcmp(test_pattern, test_buffer, sizeof(test_pattern)) == 0) {
			sc->type = ED_TYPE_NE1000;
			sc->type_str = "NE1000";
			sc->isa16bit = 0;
		} else {
			/* Not an NE1000 - try NE2000 */
			sc->isa16bit = 1;
			ed_nic_outb(sc, ED_P0_DCR, ED_DCR_WTS | ED_DCR_FT1 | ED_DCR_LS);
			ed_nic_outb(sc, ED_P0_PSTART, 16384 / ED_PAGE_SIZE);
			ed_nic_outb(sc, ED_P0_PSTOP, 32768 / ED_PAGE_SIZE);
			/*
			 * Write a test pattern in word mode. If this also fails, then
			 * we don't know what this board is.
			 */
			ed_pio_writemem(sc, test_pattern, 16384, sizeof(test_pattern));
			ed_pio_readmem(sc, 16384, test_buffer, sizeof(test_pattern));
			if (bcmp(test_pattern, test_buffer, sizeof(test_pattern)) == 0) {
				sc->type = ED_TYPE_NE2000;
				sc->type_str = "NE2000";
			} else {
				return (ENXIO);
			}
		}
	}
	sc->chip_type = ED_CHIP_TYPE_DP8390;

	/* 8k of memory plus an additional 8k if 16bit */
	memsize = 8192 + sc->isa16bit * 8192;
	sc->mem_size = memsize;

	/* NIC memory doesn't start at zero on an NE board */
	/* The start address is tied to the bus width */
	sc->mem_start = 8192 + sc->isa16bit * 8192;
	sc->mem_end = sc->mem_start + memsize;
	sc->tx_page_start = memsize / ED_PAGE_SIZE;

	if (ED_FLAGS_GETTYPE(flags) == ED_FLAGS_GWETHER) {
		error = ed_probe_gwether(dev);
		if (error)
			return (error);
	}

	/*
	 * Use one xmit buffer if < 16k, two buffers otherwise (if not told
	 * otherwise).
	 */
	if ((memsize < 16384) || (flags & ED_FLAGS_NO_MULTI_BUFFERING))
		sc->txb_cnt = 1;
	else
		sc->txb_cnt = 2;

	sc->rec_page_start = sc->tx_page_start + sc->txb_cnt * ED_TXBUF_SIZE;
	sc->rec_page_stop = sc->tx_page_start + memsize / ED_PAGE_SIZE;

	sc->mem_ring = sc->mem_start + sc->txb_cnt * ED_PAGE_SIZE * ED_TXBUF_SIZE;
	/* clear any pending interrupts that might have occurred above */
	ed_nic_outb(sc, ED_P0_ISR, 0xff);

	sc->sc_write_mbufs = ed_pio_write_mbufs;
	return (0);
}