static void setMACAddress() {
unsigned long ulUser0, ulUser1;
/* Try to get the device MAC address from flash or use a fixed MAC to allow initial configuration */
ROM_FlashUserGet(&ulUser0, &ulUser1);
if ((ulUser0 == 0xffffffff) || (ulUser1 == 0xffffffff)) {
interface.hwaddr[0] = 0xAA;
interface.hwaddr[1] = 0x00;
interface.hwaddr[2] = 0x00;
interface.hwaddr[3] = 0xFF;
interface.hwaddr[4] = 0xff;
interface.hwaddr[5] = 0xff;
} else {
/* Convert the MAC address from flash into sequence of bytes. */
interface.hwaddr[0] = ((ulUser0 >> 0) & 0xff);
interface.hwaddr[1] = ((ulUser0 >> 8) & 0xff);
interface.hwaddr[2] = ((ulUser0 >> 16) & 0xff);
interface.hwaddr[3] = ((ulUser1 >> 0) & 0xff);
interface.hwaddr[4] = ((ulUser1 >> 8) & 0xff);
interface.hwaddr[5] = ((ulUser1 >> 16) & 0xff);
}
/* Program the MAC address. */
EthernetMACAddrSet(ETH_BASE, interface.hwaddr);
interface.hwaddr_len = 6;
}
//*****************************************************************************
//
// Set the SimpliciTI device address as the least significant 4 digits of the
// device Ethernet MAC address. This ensures that the address is unique across
// Stellaris devices. If the MAC address has not been set, we return false to
// indicate failure.
//
//*****************************************************************************
tBoolean
SetSimpliciTIAddress(void)
{
unsigned long ulUser0, ulUser1;
addr_t sAddr;
//
// Make sure we are using 4 byte addressing.
//
ASSERT(NET_ADDR_SIZE == 4);
//
// Get the MAC address from the non-volatile user registers.
//
ROM_FlashUserGet(&ulUser0, &ulUser1);
//
// Has the MAC address been programmed?
//
if((ulUser0 == 0xffffffff) || (ulUser1 == 0xffffffff))
{
//
// No - we don't have an address so return a failure.
//
UpdateStatus(false, "Flash user registers are clear");
UpdateStatus(true, "Error - address not set!");
return(false);
}
else
{
//
// The MAC address is stored with 3 bytes in each of the 2 flash user
// registers. Extract the least significant 4 MAC bytes for use as the
// SimpliciTI device address.
//
sAddr.addr[0] = ((ulUser1 >> 16) & 0xff);
sAddr.addr[1] = ((ulUser1 >> 8) & 0xff);
sAddr.addr[2] = ((ulUser1 >> 0) & 0xff);
sAddr.addr[3] = ((ulUser0 >> 16) & 0xff);
//
// SimpliciTI requires that the first byte of the device address is
// never either 0x00 or 0xFF so we check for these cases and invert the
// first bit if either is detected. This does result in the
// possibility of two devices having the same address but, for example
// purposes, is likely to be fine.
//
if((sAddr.addr[0] == 0x00) || (sAddr.addr[0] == 0xFF))
{
sAddr.addr[0] ^= 0x80;
}
//
// Tell the SimpliciTI stack which device address we want to use.
//
SMPL_Ioctl(IOCTL_OBJ_ADDR, IOCTL_ACT_SET, &sAddr);
}
//
// If we get here, all is well.
//
return(true);
}
