void cdc_ep_init()
{
// setup the endpoints
ep_config(EP_1, BULK, DIR_IN, MAX_PACKET_SZ);
ep_config(EP_2, INTP, DIR_IN, MAX_PACKET_SZ);
ep_config(EP_3, BULK, DIR_OUT, MAX_PACKET_SZ);
}
void ep_init()
{
U8 i;
// Initialize USB clock to use 48Mhz Oscillator
//SI32_USB_A_verify_clock_is_running(SI32_USB_0);
// disable and clear all endpoints
for (i=0; i<MAX_EPS; i++)
{
ep_disable(i);
ep_cfg_clear(i);
}
// reset all the endpoints
//UERST = 0x7F;
//UERST = 0;
// configure the control endpoint first since that one is needed for enumeration
ep_config( EP_CTRL, XFER_CONTROL, DIR_OUT, MAX_PACKET_SZ );
NVIC_EnableIRQ( USB0_IRQn );
// set the rx setup interrupt to received the enumeration interrupts
//ep_select(EP_CTRL);
}
void ep_init()
{
U8 i;
// disable and clear all endpoints
for (i=0; i<MAX_EPS; i++)
{
ep_select(i);
ep_disable(i);
ep_cfg_clear(i);
}
// reset all the endpoints
UERST = 0x7F;
UERST = 0;
// configure the control endpoint first since that one is needed for enumeration
ep_config(EP_CTRL, CONTROL, DIR_OUT, MAX_PACKET_SZ);
// set the rx setup interrupt to received the enumeration interrupts
ep_select(EP_CTRL);
}
/*
* Initialize the endpoints according to the CDC class driver. The class
* driver specifies a BULK IN, BULK OUT, and INTERRUPT IN endpoint. We will
* usually set this after the host issues the set_configuration request.
*/
void cdc_ep_init()
{
ep_config(EP_1, BULK, DIR_IN, PKTSZ_64);
ep_config(EP_2, INTP, DIR_IN, PKTSZ_64);
ep_config(EP_3, BULK, DIR_OUT, PKTSZ_64);
}
