static __init void dm365_evm_init(void)
{
GPIORequsetInit();
GetAirGroundStationFlag();
evm_init_i2c();
davinci_serial_init(&uart_config);
//dm365evm_emac_configure();
dm365evm_usb_configure();
//davinci_setup_mmc(0, &dm365evm_mmc_config);
/* maybe setup mmc1/etc ... _after_ mmc0 */
evm_init();
//dm365_init_asp(&dm365_evm_snd_data);
dm365_init_rtc();
//dm365_init_ks(&dm365evm_ks_data);
dm365_init_spi0(BIT(0), dm365_evm_spi_info,
ARRAY_SIZE(dm365_evm_spi_info));
dm365_init_spi4(BIT(0), dm365_evm_spi4_info,
ARRAY_SIZE(dm365_evm_spi4_info));
//dm365_init_tsc2004();
}
static __init void evm_init(void)
{
struct davinci_soc_info *soc_info = &davinci_soc_info;
evm_init_i2c();
davinci_serial_init(&uart_config);
soc_info->emac_pdata->phy_mask = DM646X_EVM_PHY_MASK;
soc_info->emac_pdata->mdio_max_freq = DM646X_EVM_MDIO_FREQUENCY;
}
static __init void dm355_evm_init(void)
{
struct clk *aemif;
int ret;
ret = dm355_gpio_register();
if (ret)
pr_warn("%s: GPIO init failed: %d\n", __func__, ret);
gpio_request(1, "dm9000");
gpio_direction_input(1);
dm355evm_dm9000_rsrc[2].start = gpio_to_irq(1);
aemif = clk_get(&dm355evm_dm9000.dev, "aemif");
if (IS_ERR(aemif))
WARN("%s: unable to get AEMIF clock\n", __func__);
else
clk_prepare_enable(aemif);
platform_add_devices(davinci_evm_devices,
ARRAY_SIZE(davinci_evm_devices));
evm_init_i2c();
davinci_serial_init(dm355_serial_device);
/* NOTE: NAND flash timings set by the UBL are slower than
* needed by MT29F16G08FAA chips ... EMIF.A1CR is 0x40400204
* but could be 0x0400008c for about 25% faster page reads.
*/
gpio_request(2, "usb_id_toggle");
gpio_direction_output(2, USB_ID_VALUE);
/* irlml6401 switches over 1A in under 8 msec */
davinci_setup_usb(1000, 8);
davinci_setup_mmc(0, &dm355evm_mmc_config);
davinci_setup_mmc(1, &dm355evm_mmc_config);
dm355_init_video(&vpfe_cfg, &dm355evm_display_cfg);
dm355_init_spi0(BIT(0), dm355_evm_spi_info,
ARRAY_SIZE(dm355_evm_spi_info));
/* DM335 EVM uses ASP1; line-out is a stereo mini-jack */
dm355_init_asp1(ASP1_TX_EVT_EN | ASP1_RX_EVT_EN, &dm355_evm_snd_data);
}
