void
pal_init(void)
{
unsigned long i, rev;
struct percpu_struct * percpu;
struct pcb_struct * pcb_pa;
/* */
pcb_va->ksp = 0;
pcb_va->usp = 0;
pcb_va->ptbr = L1[1] >> 32;
pcb_va->asn = 0;
pcb_va->pcc = 0;
pcb_va->unique = 0;
pcb_va->flags = 1;
pcb_va->res1 = 0;
pcb_va->res2 = 0;
pcb_pa = find_pa(VPTB, pcb_va);
/*
*/
srm_printk("Switching to OSF PAL-code .. ");
i = switch_to_osf_pal(2, pcb_va, pcb_pa, VPTB);
if (i) {
srm_printk("failed, code %ld\n", i);
__halt();
}
percpu = (struct percpu_struct *)
(INIT_HWRPB->processor_offset + (unsigned long) INIT_HWRPB);
rev = percpu->pal_revision = percpu->palcode_avail[2];
srm_printk("Ok (rev %lx)\n", rev);
tbia(); /* */
}
void
pal_init(void)
{
unsigned long i, rev;
struct percpu_struct * percpu;
struct pcb_struct * pcb_pa;
/* Create the dummy PCB. */
pcb_va->ksp = 0;
pcb_va->usp = 0;
pcb_va->ptbr = L1[1] >> 32;
pcb_va->asn = 0;
pcb_va->pcc = 0;
pcb_va->unique = 0;
pcb_va->flags = 1;
pcb_va->res1 = 0;
pcb_va->res2 = 0;
pcb_pa = (struct pcb_struct *)find_pa((unsigned long)pcb_va);
/*
* a0 = 2 (OSF)
* a1 = return address, but we give the asm the vaddr of the PCB
* a2 = physical addr of PCB
* a3 = new virtual page table pointer
* a4 = KSP (but the asm sets it)
*/
srm_printk("Switching to OSF PAL-code... ");
i = switch_to_osf_pal(2, pcb_va, pcb_pa, VPTB);
if (i) {
srm_printk("failed, code %ld\n", i);
__halt();
}
percpu = (struct percpu_struct *)
(INIT_HWRPB->processor_offset + (unsigned long) INIT_HWRPB);
rev = percpu->pal_revision = percpu->palcode_avail[2];
srm_printk("OK (rev %lx)\n", rev);
tbia(); /* do it directly in case we are SMP */
}
