void __hyp_text __timer_disable_traps(struct kvm_vcpu *vcpu)
{
/*
* We don't need to do this for VHE since the host kernel runs in EL2
* with HCR_EL2.TGE ==1, which makes those bits have no impact.
*/
if (!has_vhe())
enable_el1_phys_timer_access();
}
void __hyp_text __kvm_tlb_flush_vmid_ipa(struct kvm *kvm, phys_addr_t ipa)
{
unsigned long flags;
dsb(ishst);
/* Switch to requested VMID */
kvm = kern_hyp_va(kvm);
__tlb_switch_to_guest()(kvm, &flags);
/*
* We could do so much better if we had the VA as well.
* Instead, we invalidate Stage-2 for this IPA, and the
* whole of Stage-1. Weep...
*/
ipa >>= 12;
__tlbi(ipas2e1is, ipa);
/*
* We have to ensure completion of the invalidation at Stage-2,
* since a table walk on another CPU could refill a TLB with a
* complete (S1 + S2) walk based on the old Stage-2 mapping if
* the Stage-1 invalidation happened first.
*/
dsb(ish);
__tlbi(vmalle1is);
dsb(ish);
isb();
/*
* If the host is running at EL1 and we have a VPIPT I-cache,
* then we must perform I-cache maintenance at EL2 in order for
* it to have an effect on the guest. Since the guest cannot hit
* I-cache lines allocated with a different VMID, we don't need
* to worry about junk out of guest reset (we nuke the I-cache on
* VMID rollover), but we do need to be careful when remapping
* executable pages for the same guest. This can happen when KSM
* takes a CoW fault on an executable page, copies the page into
* a page that was previously mapped in the guest and then needs
* to invalidate the guest view of the I-cache for that page
* from EL1. To solve this, we invalidate the entire I-cache when
* unmapping a page from a guest if we have a VPIPT I-cache but
* the host is running at EL1. As above, we could do better if
* we had the VA.
*
* The moral of this story is: if you have a VPIPT I-cache, then
* you should be running with VHE enabled.
*/
if (!has_vhe() && icache_is_vpipt())
__flush_icache_all();
__tlb_switch_to_host()(kvm, flags);
}
void __hyp_text __timer_enable_traps(struct kvm_vcpu *vcpu)
{
if (!has_vhe())
disable_el1_phys_timer_access();
}