Esempio n. 1
0
void system_setup(void)
{
    clock_setup();
    mco_setup();
    usb_setup();
    systick_setup();
    rng_setup();
    battery_setup();

    speaker_setup();
    jack_setup();
    // setup pad and screen
    interface_setup();

    // setup and reset SAM2695
    sam2695_setup();
    wait_ms(100);
    sam2695_reset();

    usbmidi_setup();

    // init gfx and fill screen
    gfx_init(ssd1306_drawpixel, SSD1306_WIDTH, SSD1306_HEIGHT, GFX_FONT_SMALL);
    gfx_setRotation(GFX_ROT_180);
    gfx_fillScreen(OLED_BLACK);
    gfx_setTextColor(OLED_WHITE, OLED_BLACK);
//    gfx_setTextWrap(1);
    gfx_setTextSize(1);
    ssd1306_display();
}
int main(void)
{

    uint16_t printer_data = 0xff;
    clock_setup();
    gpio_setup();
    mco_setup();
    usart_setup();
    spi_setup();
    //timer_setup();
    systick_setup(SYSTICK_FREQ);
    print("Hello from STM32F0\n");
   // StepperMotor engine(GPIOA, M1,M2,M3,M4);
    //gpio_port_write(GPIOA,0);
//    gpio_set(GPIOA,GPIO1);
    //engine.step(100);
    while (1) {
        printer_send(printer_data);
        engine.step(1);
        delay(200);
       //engine.step(1);
       /*
    for(i = 0; i < sizeof(steps)/sizeof(steps[0]);i++) {
    gpio_port_write(GPIOA,steps[i]);
    delay(3);
    }
    */
    };
}
int main(void)
{
	clock_setup();
	gpio_setup();
	mco_setup();

	/* setup systick to generate 2 LED flashes per second */
	systick_setup(8);

	/* Do nothing in main loop */
	while (1);
}
int main(void)
{
    clock_setup();
    gpio_setup();
    mco_setup();

    /* 125ms ticks =>  250ms period => 4Hz blinks */
    systick_setup(125);

    /* Do nothing in main loop */
    while (1);
}
Esempio n. 5
0
int main(void)
{
	cm_disable_interrupts();
	clk_tree_setup();
	mco_setup();
	clock_setup();
	usb_setup();
	cli_setup();
	pwm_init();
	led_setup();
	button_setup();
	ncn_setup();
	cm_enable_interrupts();

	while (1) {
		__WFI();
	}

	return 0;
}