/**
* mei_txe_check_and_ack_intrs - translate multi BAR interrupt into
* single bit mask and acknowledge the interrupts
*
* @dev: the device structure
* @do_ack: acknowledge interrupts
*
* Return: true if found interrupts to process.
*/
static bool mei_txe_check_and_ack_intrs(struct mei_device *dev, bool do_ack)
{
struct mei_txe_hw *hw = to_txe_hw(dev);
u32 hisr;
u32 hhisr;
u32 ipc_isr;
u32 aliveness;
bool generated;
/* read interrupt registers */
hhisr = mei_txe_br_reg_read(hw, HHISR_REG);
generated = (hhisr & IPC_HHIER_MSK);
if (!generated)
goto out;
hisr = mei_txe_br_reg_read(hw, HISR_REG);
aliveness = mei_txe_aliveness_get(dev);
if (hhisr & IPC_HHIER_SEC && aliveness) {
ipc_isr = mei_txe_sec_reg_read_silent(hw,
SEC_IPC_HOST_INT_STATUS_REG);
} else {
ipc_isr = 0;
hhisr &= ~IPC_HHIER_SEC;
}
generated = generated ||
(hisr & HISR_INT_STS_MSK) ||
(ipc_isr & SEC_IPC_HOST_INT_STATUS_PENDING);
if (generated && do_ack) {
/* Save the interrupt causes */
hw->intr_cause |= hisr & HISR_INT_STS_MSK;
if (ipc_isr & SEC_IPC_HOST_INT_STATUS_IN_RDY)
hw->intr_cause |= TXE_INTR_IN_READY;
mei_txe_intr_disable(dev);
/* Clear the interrupts in hierarchy:
* IPC and Bridge, than the High Level */
mei_txe_sec_reg_write_silent(hw,
SEC_IPC_HOST_INT_STATUS_REG, ipc_isr);
mei_txe_br_reg_write(hw, HISR_REG, hisr);
mei_txe_br_reg_write(hw, HHISR_REG, hhisr);
}
out:
return generated;
}
/**
* mei_txe_hw_reset - resets host and fw.
*
* @dev: the device structure
* @intr_enable: if interrupt should be enabled after reset.
*
* returns 0 on success and < 0 in case of error
*/
static int mei_txe_hw_reset(struct mei_device *dev, bool intr_enable)
{
struct mei_txe_hw *hw = to_txe_hw(dev);
u32 aliveness_req;
/*
* read input doorbell to ensure consistency between Bridge and SeC
* return value might be garbage return
*/
(void)mei_txe_sec_reg_read_silent(hw, SEC_IPC_INPUT_DOORBELL_REG);
aliveness_req = mei_txe_aliveness_req_get(dev);
hw->aliveness = mei_txe_aliveness_get(dev);
/* Disable interrupts in this stage we will poll */
mei_txe_intr_disable(dev);
/*
* If Aliveness Request and Aliveness Response are not equal then
* wait for them to be equal
* Since we might have interrupts disabled - poll for it
*/
if (aliveness_req != hw->aliveness)
if (mei_txe_aliveness_poll(dev, aliveness_req) < 0) {
dev_err(&dev->pdev->dev,
"wait for aliveness settle failed ... bailing out\n");
return -EIO;
}
/*
* If Aliveness Request and Aliveness Response are set then clear them
*/
if (aliveness_req) {
mei_txe_aliveness_set(dev, 0);
if (mei_txe_aliveness_poll(dev, 0) < 0) {
dev_err(&dev->pdev->dev,
"wait for aliveness failed ... bailing out\n");
return -EIO;
}
}
/*
* Set rediness RDY_CLR bit
*/
mei_txe_readiness_clear(dev);
return 0;
}
