void cache_as_ram_main(unsigned long bist, unsigned long cpu_init_detectedx)
{
u32 val;
u8 reg8;
// all cores: allow caching of flash chip code and data
// (there are no cache-as-ram reliability concerns with family 14h)
__writemsr (0x20c, (0x0100000000ull - CONFIG_ROM_SIZE) | 5);
__writemsr (0x20d, (0x1000000000ull - CONFIG_ROM_SIZE) | 0x800);
// all cores: set pstate 0 (1600 MHz) early to save a few ms of boot time
__writemsr (0xc0010062, 0);
if (boot_cpu())
{
u8 reg8;
// SB800: program AcpiMmioEn to enable MMIO access to MiscCntrl register
outb(0x24, 0xCD6);
reg8 = inb(0xCD7);
reg8 |= 1;
reg8 &= ~(1 << 1);
outb(reg8, 0xCD7);
// program SB800 MiscCntrl
*(volatile u32 *)(0xFED80000+0xE00+0x40) &= ~((1 << 0) | (1 << 2)); /* 48Mhz */
*(volatile u32 *)(0xFED80000+0xE00+0x40) |= 1 << 1; /* 48Mhz */
}
// early enable of PrefetchEnSPIFromHost
if (boot_cpu())
{
__outdword (0xcf8, 0x8000a3b8);
__outdword (0xcfc, __indword (0xcfc) | 1 << 24);
}
// early enable of SPI 33 MHz fast mode read
if (boot_cpu())
{
volatile u32 *spiBase = (void *) 0xa0000000;
u32 save;
__outdword (0xcf8, 0x8000a3a0);
save = __indword (0xcfc);
__outdword (0xcfc, (u32) spiBase | 2); // set temp MMIO base
spiBase [3] = (spiBase [3] & ~(3 << 14)) | (1 << 14);
spiBase [0] |= 1 << 18; // fast read enable
__outdword (0xcfc, save); // clear temp base
}
if (!cpu_init_detectedx && boot_cpu()) {
post_code(0x30);
sb_poweron_init();
post_code(0x31);
f81865f_enable_serial(SERIAL_DEV, CONFIG_TTYS0_BASE);
console_init();
}
/* Halt if there was a built in self test failure */
post_code(0x34);
report_bist_failure(bist);
// Load MPB
val = cpuid_eax(1);
printk(BIOS_DEBUG, "BSP Family_Model: %08x \n", val);
printk(BIOS_DEBUG, "cpu_init_detectedx = %08lx \n", cpu_init_detectedx);
post_code(0x35);
val = agesawrapper_amdinitmmio();
post_code(0x37);
val = agesawrapper_amdinitreset();
if(val) {
printk(BIOS_DEBUG, "agesawrapper_amdinitreset failed: %x \n", val);
}
post_code(0x38);
printk(BIOS_DEBUG, "Got past sb800_early_setup\n");
post_code(0x39);
val = agesawrapper_amdinitearly ();
if(val) {
printk(BIOS_DEBUG, "agesawrapper_amdinitearly failed: %x \n", val);
}
printk(BIOS_DEBUG, "Got past agesawrapper_amdinitearly\n");
post_code(0x40);
val = agesawrapper_amdinitpost ();
if(val) {
printk(BIOS_DEBUG, "agesawrapper_amdinitpost failed: %x \n", val);
}
printk(BIOS_DEBUG, "Got past agesawrapper_amdinitpost\n");
post_code(0x41);
val = agesawrapper_amdinitenv ();
if(val) {
printk(BIOS_DEBUG, "agesawrapper_amdinitenv failed: %x \n", val);
}
printk(BIOS_DEBUG, "Got past agesawrapper_amdinitenv\n");
/* Initialize i8259 pic */
post_code(0x41);
setup_i8259 ();
/* Initialize i8254 timers */
post_code(0x42);
setup_i8254 ();
post_code(0x50);
copy_and_run(0);
post_code(0x54); // Should never see this post code.
}
void cache_as_ram_main(unsigned long bist, unsigned long cpu_init_detectedx)
{
u32 val;
post_code(0x35);
printk(BIOS_DEBUG, "agesawrapper_amdinitmmio ");
val = agesawrapper_amdinitmmio();
if (val)
printk(BIOS_DEBUG, "error level: %x \n", val);
else
printk(BIOS_DEBUG, "passed.\n");
if (!cpu_init_detectedx && boot_cpu()) {
post_code(0x30);
gpioEarlyInit();
sb_poweron_init();
post_code(0x31);
kbc1100_early_init(CONFIG_SIO_PORT);
post_code(0x32);
uart_init();
post_code(0x33);
console_init();
}
/* Halt if there was a built in self test failure */
post_code(0x34);
report_bist_failure(bist);
// Load MPB
val = cpuid_eax(1);
printk(BIOS_DEBUG, "BSP Family_Model: %08x \n", val);
printk(BIOS_DEBUG, "cpu_init_detectedx = %08lx \n", cpu_init_detectedx);
post_code(0x36);
printk(BIOS_DEBUG, "agesawrapper_amdinitreset ");
val = agesawrapper_amdinitreset();
if (val)
printk(BIOS_DEBUG, "error level: %x \n", val);
else
printk(BIOS_DEBUG, "passed.\n");
post_code(0x37);
printk(BIOS_DEBUG, "agesawrapper_amdinitearly ");
val = agesawrapper_amdinitearly();
if (val)
printk(BIOS_DEBUG, "error level: %x \n", val);
else
printk(BIOS_DEBUG, "passed.\n");
post_code(0x38);
printk(BIOS_DEBUG, "agesawrapper_amdinitpost ");
val = agesawrapper_amdinitpost();
if (val)
printk(BIOS_DEBUG, "error level: %x \n", val);
else
printk(BIOS_DEBUG, "passed.\n");
post_code(0x39);
printk(BIOS_DEBUG, "sb_before_pci_init ");
sb_before_pci_init();
printk(BIOS_DEBUG, "passed.\n");
post_code(0x40);
printk(BIOS_DEBUG, "agesawrapper_amdinitenv ");
val = agesawrapper_amdinitenv();
if (val)
printk(BIOS_DEBUG, "error level: %x \n", val);
else
printk(BIOS_DEBUG, "passed.\n");
/* Initialize i8259 pic */
post_code(0x41);
printk(BIOS_DEBUG, "setup_i8259\n");
setup_i8259();
/* Initialize i8254 timers */
post_code(0x42);
printk(BIOS_DEBUG, "setup_i8254\n");
setup_i8254();
post_code(0x43);
copy_and_run();
printk(BIOS_ERR, "Error: copy_and_run returned!\n");
post_code(0x44); // Should never see this post code.
}
