/*
* In the case of non-SPL based booting we'll want to call these
* functions a tiny bit later as it will require gd to be set and cleared
* and that's not true in s_init in this case so we cannot do it there.
*/
int board_early_init_f(void)
{
prcm_init();
set_mux_conf_regs();
return 0;
}
/*
* In the case of non-SPL based booting we'll want to call these
* functions a tiny bit later as it will require gd to be set and cleared
* and that's not true in s_init in this case so we cannot do it there.
*/
int board_early_init_f(void)
{
prcm_init();
set_mux_conf_regs();
#if defined(CONFIG_SPL_BUILD) && defined(CONFIG_SPL_RTC_DDR_SUPPORT)
update_rtc_magic();
#endif
return 0;
}
void s_init(void)
{
/*
* The ROM will only have set up sufficient pinmux to allow for the
* first 4KiB NOR to be read, we must finish doing what we know of
* the NOR mux in this space in order to continue.
*/
#ifdef CONFIG_NOR_BOOT
enable_norboot_pin_mux();
#endif
/*
* Save the boot parameters passed from romcode.
* We cannot delay the saving further than this,
* to prevent overwrites.
*/
#ifdef CONFIG_SPL_BUILD
save_omap_boot_params();
#endif
watchdog_disable();
timer_init();
set_uart_mux_conf();
setup_clocks_for_console();
uart_soft_reset();
#ifdef CONFIG_NOR_BOOT
gd->baudrate = CONFIG_BAUDRATE;
serial_init();
gd->have_console = 1;
#elif defined(CONFIG_SPL_BUILD)
gd = &gdata;
preloader_console_init();
#endif
prcm_init();
set_mux_conf_regs();
/* Enable RTC32K clock */
rtc32k_enable();
sdram_init();
}
