Esempi in C++ (Cpp) per usba_udc_probe

Esempio n. 1

File: board.c Progetto: CogSystems/u-boot

int board_init(void)
{
	/* address of boot parameters */
	gd->bd->bi_boot_params = CONFIG_SYS_SDRAM_BASE + 0x100;

	/* we have to request the gpios again after relocation */
	corvus_request_gpio();
#ifdef CONFIG_CMD_NAND
	corvus_nand_hw_init();
#endif
#ifdef CONFIG_ATMEL_SPI
	at91_spi0_hw_init(1 << 4);
#endif
#ifdef CONFIG_MACB
	corvus_macb_hw_init();
#endif
#ifdef CONFIG_CMD_USB
	taurus_usb_hw_init();
#endif
#ifdef CONFIG_USB_GADGET_ATMEL_USBA
	at91_udp_hw_init();
	usba_udc_probe(&pdata);
#endif
	return 0;
}

Esempio n. 2

File: board.c Progetto: 13xiaobang/mini2440-uboot_2016.01

int board_init(void)
{
	/* address of boot parameters */
	gd->bd->bi_boot_params = CONFIG_SYS_SDRAM_BASE + 0x100;

#ifdef CONFIG_CMD_NAND
	corvus_nand_hw_init();
#endif
#ifdef CONFIG_ATMEL_SPI
	at91_spi0_hw_init(1 << 4);
#endif
#ifdef CONFIG_HAS_DATAFLASH
	at91_spi0_hw_init(1 << 0);
#endif
#ifdef CONFIG_MACB
	corvus_macb_hw_init();
#endif
#ifdef CONFIG_CMD_USB
	taurus_usb_hw_init();
#endif
#ifdef CONFIG_USB_GADGET_ATMEL_USBA
	at91_udp_hw_init();
	usba_udc_probe(&pdata);
#endif
	return 0;
}

Esempio n. 3

File: vinco.c Progetto: 01hyang/u-boot

int board_eth_init(bd_t *bis)
{
	int rc = 0;

#ifdef CONFIG_MACB
	rc = macb_eth_initialize(0, (void *)ATMEL_BASE_GMAC0, 0x00);
#endif

#ifdef CONFIG_USB_GADGET_ATMEL_USBA
	usba_udc_probe(&pdata);
#ifdef CONFIG_USB_ETH_RNDIS
	usb_eth_initialize(bis);
#endif
#endif

	return rc;
}

Esempio n. 4

File: sama5d4_xplained.c Progetto: linux4sam/u-boot-at91

int board_eth_init(bd_t *bis)
{
    int rc = 0;

#ifdef CONFIG_MACB
    rc = macb_eth_initialize(0, (void *)ATMEL_BASE_GMAC0, 0x00);
    if (rc)
        printf("GMAC register failed\n");
    else
        set_ethaddr_from_eeprom();
#endif

#ifdef CONFIG_USB_GADGET_ATMEL_USBA
    usba_udc_probe(&pdata);
#ifdef CONFIG_USB_ETH_RNDIS
    usb_eth_initialize(bis);
#endif
#endif

    return rc;
}