GCodePlanner::GCodePlanner(GCodeExport& gcode, int travelSpeed, int retractionMinimalDistance)
: gcode(gcode), travelConfig(travelSpeed, 0, "travel")
{
lastPosition = gcode.getPositionXY();
comb = NULL;
extrudeSpeedFactor = 100;
travelSpeedFactor = 100;
extraTime = 0.0;
totalPrintTime = 0.0;
forceRetraction = false;
alwaysRetract = false;
currentExtruder = gcode.getExtruderNr();
this->retractionMinimalDistance = retractionMinimalDistance;
}
GCodePlanner::GCodePlanner(GCodeExport& gcode, SliceDataStorage& storage, RetractionConfig* retraction_config_travel, double travelSpeed, bool retraction_combing, unsigned int layer_nr, int64_t comb_boundary_offset, bool travel_avoid_other_parts, int64_t travel_avoid_distance)
: gcode(gcode), storage(storage)
, travelConfig(retraction_config_travel, "MOVE")
{
lastPosition = gcode.getPositionXY();
travelConfig.setSpeed(travelSpeed);
comb = nullptr;
last_retraction_config = &storage.retraction_config; // start with general config
setExtrudeSpeedFactor(1.0);
setTravelSpeedFactor(1.0);
extraTime = 0.0;
totalPrintTime = 0.0;
currentExtruder = gcode.getExtruderNr();
if (retraction_combing)
{
was_combing = true; // means it will try to get inside the comb boundary first
is_going_to_comb = true; // means it will try to get inside the comb boundary
comb = new Comb(storage, layer_nr, comb_boundary_offset, travel_avoid_other_parts, travel_avoid_distance);
}
else
comb = nullptr;
}