/**
* ath5k_hw_set_gpio_intr() - Initialize the GPIO interrupt (RFKill switch)
* @ah: The &struct ath5k_hw
* @gpio: The GPIO pin to use
* @interrupt_level: True to generate interrupt on active pin (high)
*
* This function is used to set up the GPIO interrupt for the hw RFKill switch.
* That switch is connected to a GPIO pin and it's number is stored on EEPROM.
* It can either open or close the circuit to indicate that we should disable
* RF/Wireless to save power (we also get that from EEPROM).
*/
void
ath5k_hw_set_gpio_intr(struct ath5k_hw *ah, unsigned int gpio,
u32 interrupt_level)
{
u32 data;
if (gpio >= AR5K_NUM_GPIO)
return;
/*
* Set the GPIO interrupt
*/
data = (ath5k_hw_reg_read(ah, AR5K_GPIOCR) &
~(AR5K_GPIOCR_INT_SEL(gpio) | AR5K_GPIOCR_INT_SELH |
AR5K_GPIOCR_INT_ENA | AR5K_GPIOCR_OUT(gpio))) |
(AR5K_GPIOCR_INT_SEL(gpio) | AR5K_GPIOCR_INT_ENA);
ath5k_hw_reg_write(ah, interrupt_level ? data :
(data | AR5K_GPIOCR_INT_SELH), AR5K_GPIOCR);
ah->ah_imr |= AR5K_IMR_GPIO;
/* Enable GPIO interrupts */
AR5K_REG_ENABLE_BITS(ah, AR5K_PIMR, AR5K_IMR_GPIO);
}
/*
* Set GPIO outputs
*/
int ath5k_hw_set_gpio_output(struct ath5k_hw *ah, u32 gpio)
{
if (gpio >= AR5K_NUM_GPIO)
return -EINVAL;
ath5k_hw_reg_write(ah,
(ath5k_hw_reg_read(ah, AR5K_GPIOCR) & ~AR5K_GPIOCR_OUT(gpio))
| AR5K_GPIOCR_OUT(gpio), AR5K_GPIOCR);
return 0;
}