bool system_fileTransfer(system_file_transfer_t* tx, void* reserved)
{
bool status = false;
Stream* serialObj = tx->stream;
if (NULL != Ymodem_Serial_Flash_Update_Handler)
{
status = Ymodem_Serial_Flash_Update_Handler(serialObj, tx->descriptor, NULL);
SPARK_FLASH_UPDATE = 0;
TimingFlashUpdateTimeout = 0;
if (status == true)
{
if (tx->descriptor.store==FileTransfer::Store::FIRMWARE) {
serialObj->println("Restarting system to apply firmware update...");
HAL_Delay_Milliseconds(100);
HAL_Core_System_Reset();
}
}
}
else
{
serialObj->println("Firmware update using this terminal is not supported!");
serialObj->println("Add #include \"Ymodem/Ymodem.h\" to your sketch and try again.");
}
return status;
}
/**
* Do what is needed to finalize the connection.
* @return
*/
wlan_result_t wlan_connect_finalize()
{
// enable connection from stored profiles
HAL_Delay_Milliseconds(1000);
HAL_NET_notify_connected();
INFO("Virtual WLAN connected");
HAL_NET_notify_dhcp(true);
return 0;
}
void USB_USART_LineCoding_BitRate_Handler(void (*handler)(uint32_t bitRate))
{
//Init USB Serial first before calling the linecoding handler
USB_USART_Init(9600);
HAL_Delay_Milliseconds(1000);
//Set the system defined custom handler
SetLineCodingBitRateHandler(handler);
}
bool wlan_smart_config_finalize()
{
if (current_softap_handle) {
softap_stop(current_softap_handle);
wlan_disconnect_now(); // force a full refresh
HAL_Delay_Milliseconds(5);
wlan_activate();
current_softap_handle = NULL;
}
// if wifi creds changed, then indicate the system should enter listening mode on failed connect
return wifi_creds_changed;
}
/**
* Waits indefinitely for the given thread to finish.
* @param thread The thread to wait for.
* @return 0 if the thread has successfully terminated. non-zero if the thread handle is not valid.
*/
os_result_t os_thread_join(os_thread_t thread)
{
#if PLATFORM_ID!=10
while (xTaskIsTaskFinished(thread) != pdTRUE)
{
HAL_Delay_Milliseconds(10);
}
return 0;
#else
return -1;
#endif
}
void NeopixelAnimationContext::wait(uint32_t ms, bool *abort) {
uint32_t start = millis();
// Provide a default for the abort pointer
bool dontAbort = false;
if (!abort) {
abort = &dontAbort;
}
do {
if (process) {
process();
}
HAL_Delay_Milliseconds(1);
} while(!(*abort) && millis() - start < ms);
}
