/*
* early init callback, read nvram data from flash and checksum it
*/
void __init board_prom_init(void)
{
unsigned int check_len, i;
u8 *boot_addr, *cfe, *p;
char cfe_version[32];
u32 val;
/* read base address of boot chip select (0)
* 6345 does not have MPI but boots from standard
* MIPS Flash address */
if (BCMCPU_IS_6345())
val = 0x1fc00000;
else {
val = bcm_mpi_readl(MPI_CSBASE_REG(0));
val &= MPI_CSBASE_BASE_MASK;
}
boot_addr = (u8 *)KSEG1ADDR(val);
/* dump cfe version */
cfe = boot_addr + BCM963XX_CFE_VERSION_OFFSET;
if (!memcmp(cfe, "cfe-v", 5))
snprintf(cfe_version, sizeof(cfe_version), "%u.%u.%u-%u.%u",
cfe[5], cfe[6], cfe[7], cfe[8], cfe[9]);
else
strcpy(cfe_version, "unknown");
printk(KERN_INFO PFX "CFE version: %s\n", cfe_version);
/* extract nvram data */
memcpy(&nvram, boot_addr + BCM963XX_NVRAM_OFFSET, sizeof(nvram));
/* check checksum before using data */
if (nvram.version <= 4)
check_len = offsetof(struct bcm963xx_nvram, checksum_old);
else
/*
* third stage init callback, register all board devices.
*/
int __init board_register_devices(void)
{
u32 val;
bcm63xx_uart_register();
bcm63xx_wdt_register();
if (board.has_pccard)
bcm63xx_pcmcia_register();
if (board.has_enet0 &&
!board_get_mac_address(board.enet0.mac_addr))
bcm63xx_enet_register(0, &board.enet0);
if (board.has_enet1 &&
!board_get_mac_address(board.enet1.mac_addr))
bcm63xx_enet_register(1, &board.enet1);
if (board.has_ohci0)
bcm63xx_ohci_register();
if (board.has_ehci0)
bcm63xx_ehci_register();
/* read base address of boot chip select (0) */
val = bcm_mpi_readl(MPI_CSBASE_REG(0));
val &= MPI_CSBASE_BASE_MASK;
mtd_resources[0].start = val;
mtd_resources[0].end = 0x1FFFFFFF;
platform_device_register(&mtd_dev);
return 0;
}
int __init bcm63xx_flash_register(void)
{
int flash_type;
u32 val;
flash_type = bcm63xx_detect_flash_type();
switch (flash_type) {
case BCM63XX_FLASH_TYPE_PARALLEL:
/* read base address of boot chip select (0) */
val = bcm_mpi_readl(MPI_CSBASE_REG(0));
val &= MPI_CSBASE_BASE_MASK;
mtd_resources[0].start = val;
mtd_resources[0].end = 0x1FFFFFFF;
return platform_device_register(&mtd_dev);
case BCM63XX_FLASH_TYPE_SERIAL:
pr_warn("unsupported serial flash detected\n");
return -ENODEV;
case BCM63XX_FLASH_TYPE_NAND:
pr_warn("unsupported NAND flash detected\n");
return -ENODEV;
default:
pr_err("flash detection failed for BCM%x: %d\n",
bcm63xx_get_cpu_id(), flash_type);
return -ENODEV;
}
}
int __init bcm63xx_dsp_register(const struct bcm63xx_dsp_platform_data *pd)
{
struct bcm63xx_dsp_platform_data *dpd;
u32 val;
/* Get the memory window */
val = bcm_mpi_readl(MPI_CSBASE_REG(pd->cs - 1));
val &= MPI_CSBASE_BASE_MASK;
voip_dsp_resources[0].start = val;
voip_dsp_resources[0].end = val + 0xFFFFFFF;
voip_dsp_resources[1].start = pd->ext_irq;
/* copy given platform data */
dpd = bcm63xx_voip_dsp_device.dev.platform_data;
memcpy(dpd, pd, sizeof (*pd));
return platform_device_register(&bcm63xx_voip_dsp_device);
}
/*
* early init callback
*/
void __init board_prom_init(void)
{
u32 val;
/* read base address of boot chip select (0) */
val = bcm_mpi_readl(MPI_CSBASE_REG(0));
val &= MPI_CSBASE_BASE_MASK;
/* assume board is a Livebox */
memcpy(&board, bcm963xx_boards[0], sizeof(board));
/* setup pin multiplexing depending on board enabled device,
* this has to be done this early since PCI init is done
* inside arch_initcall */
val = 0;
if (board.has_pci) {
bcm63xx_pci_enabled = 1;
if (BCMCPU_IS_6348())
val |= GPIO_MODE_6348_G2_PCI;
}
if (board.has_pccard) {
if (BCMCPU_IS_6348())
val |= GPIO_MODE_6348_G1_MII_PCCARD;
}
if (board.has_enet0 && !board.enet0.use_internal_phy) {
if (BCMCPU_IS_6348())
val |= GPIO_MODE_6348_G3_EXT_MII |
GPIO_MODE_6348_G0_EXT_MII;
}
if (board.has_enet1 && !board.enet1.use_internal_phy) {
if (BCMCPU_IS_6348())
val |= GPIO_MODE_6348_G3_EXT_MII |
GPIO_MODE_6348_G0_EXT_MII;
}
bcm_gpio_writel(val, GPIO_MODE_REG);
}
/*
* early init callback, read nvram data from flash and checksum it
*/
void __init board_prom_init(void)
{
unsigned int i;
u8 *boot_addr, *cfe;
char cfe_version[32];
char *board_name;
u32 val;
/* read base address of boot chip select (0)
* 6328 does not have MPI but boots from a fixed address
*/
if (BCMCPU_IS_6328())
val = 0x18000000;
else {
val = bcm_mpi_readl(MPI_CSBASE_REG(0));
val &= MPI_CSBASE_BASE_MASK;
}
boot_addr = (u8 *)KSEG1ADDR(val);
/* dump cfe version */
cfe = boot_addr + BCM963XX_CFE_VERSION_OFFSET;
if (!memcmp(cfe, "cfe-v", 5))
snprintf(cfe_version, sizeof(cfe_version), "%u.%u.%u-%u.%u",
cfe[5], cfe[6], cfe[7], cfe[8], cfe[9]);
else
strcpy(cfe_version, "unknown");
printk(KERN_INFO PFX "CFE version: %s\n", cfe_version);
bcm63xx_nvram_init(boot_addr + BCM963XX_NVRAM_OFFSET);
board_name = bcm63xx_nvram_get_name();
/* find board by name */
for (i = 0; i < ARRAY_SIZE(bcm963xx_boards); i++) {
if (strncmp(board_name, bcm963xx_boards[i]->name, 16))
continue;
/* copy, board desc array is marked initdata */
memcpy(&board, bcm963xx_boards[i], sizeof(board));
break;
}
/* bail out if board is not found, will complain later */
if (!board.name[0]) {
char name[17];
memcpy(name, board_name, 16);
name[16] = 0;
printk(KERN_ERR PFX "unknown bcm963xx board: %s\n",
name);
return;
}
/* setup pin multiplexing depending on board enabled device,
* this has to be done this early since PCI init is done
* inside arch_initcall */
val = 0;
#ifdef CONFIG_PCI
if (board.has_pci) {
bcm63xx_pci_enabled = 1;
if (BCMCPU_IS_6348())
val |= GPIO_MODE_6348_G2_PCI;
}
#endif
if (board.has_pccard) {
if (BCMCPU_IS_6348())
val |= GPIO_MODE_6348_G1_MII_PCCARD;
}
if (board.has_enet0 && !board.enet0.use_internal_phy) {
if (BCMCPU_IS_6348())
val |= GPIO_MODE_6348_G3_EXT_MII |
GPIO_MODE_6348_G0_EXT_MII;
}
if (board.has_enet1 && !board.enet1.use_internal_phy) {
if (BCMCPU_IS_6348())
val |= GPIO_MODE_6348_G3_EXT_MII |
GPIO_MODE_6348_G0_EXT_MII;
}
bcm_gpio_writel(val, GPIO_MODE_REG);
}