void BOOT_Start(void) {
#if PL_IS_BOOTLOADER
BL_Bootloader(); /* does not return */
#else
RTOS_Start(); /* does not return */
#endif
}
void Initial()
{
CyGlobalIntEnable;
//Check_Boot();
Timer_RTOS_Start();
PWM_Start();
I2C_Start();
UART_Start();
RTC_Start();
RTC_SetPeriod(1,1000);
RTOS_Start();
SetTask(Brightles_PID_Controll);
LCD_WS0010Start();
SetTask(WaitPowerStab);
SetTimerTask(OPT_Get_Result, 1300);
//BLE_Status();
GlobalStruct.OS_Status = 0;
SetTimerTask(Display_Controll, 2000);
}
void main(void) {
/* Write your local variable definition here */
#if PL_BOARD_LCD
/* NOTE: the JM128 on the TWR-LCD needs at least to pull-up the microSD card
detection pin, otherwise the signal is floating for the the driver in U5A */
PTGPE_PTGPE3 = 1; /* pull up enable for card detection line. Otherwise a CPU on the elevator will not be able to read the SD card detection signal */
#endif
#if PL_BOARD_LCD && !PL_IS_BOOTLOADER && !PL_APP_MODE_I2C_LCD /* we are the TWR-LCD, and not the bootloader or the I2C application */
/* if we are not the bootloader:
- if JM_ELE (SW1-3) is ON/low, then TWR CPU has control over the display (tristate lines)
- if EuSD (SW1-4) is ON/low, then TWR CPU has control over the microSD card (tristate lines, pull-up CD line)
- if TP_SEL (SW1-6) is OFF/high, then TWR CPU has control over the touch panel lines (tristate lines)
*/
if (!CanUseTouchPanel()) {
for(;;) {}
}
if (!CanUseDisplay()) {
for(;;) {}
}
#endif
#if PL_HAS_BOOTLOADER
BL_RedirectUserVectors(); /* need to redirect vectors before initializing the drivers below */
#endif
/*** Processor Expert internal initialization. DON'T REMOVE THIS CODE!!! ***/
PE_low_level_init();
/*** End of Processor Expert internal initialization. ***/
#if PL_IS_BOOTLOADER
BL_Bootloader(); /* does not return */
#else
RTOS_Start(); /* does not return */
#endif
/*** Don't write any code pass this line, or it will be deleted during code generation. ***/
/*** Processor Expert end of main routine. DON'T MODIFY THIS CODE!!! ***/
for(;;){}
/*** Processor Expert end of main routine. DON'T WRITE CODE BELOW!!! ***/
} /*** End of main routine. DO NOT MODIFY THIS TEXT!!! ***/
void APP_Run(void) {
LCD_Test();
EVNT1_SetEvent(EVNT1_INIT);
TRG1_AddTrigger(TRG1_LED_BLINK, 100, APP_LedBlink);
RTOS_Start();
}