static inline void done(adc_t line)
{
if (dev(line) == ADC0) {
bit_clear32(&SIM->SCGC6, SIM_SCGC6_ADC0_SHIFT);
}
#ifdef ADC1
else if (dev(line) == ADC1) {
#if defined(SIM_SCGC3_ADC1_SHIFT)
bit_clear32(&SIM->SCGC3, SIM_SCGC3_ADC1_SHIFT);
#elif defined(SIM_SCGC6_ADC1_SHIFT)
bit_clear32(&SIM->SCGC6, SIM_SCGC6_ADC1_SHIFT);
#endif
}
#endif /* ADC1 */
mutex_unlock(&locks[dev_num(line)]);
}
/**
* @brief Enable workarounds for some known CPU errata
*/
static inline void cpu_errata_fixes(void)
{
#ifdef SIM_SCGC7_FLEXBUS_SHIFT
/* K series errata
* e4218: SIM/FLEXBUS: SIM_SCGC7[FLEXBUS] bit should be cleared when the
* FlexBus is not being used.
*
* Description: The SIM_SCGC7[FLEXBUS] bit is set by default. This means
* that the FlexBus will be enabled and come up in global chip select mode.
* With some code sequence and register value combinations the core could
* attempt to prefetch from the FlexBus even though it might not actually
* use the value it prefetched. In the case where the FlexBus is
* unconfigured, this can result in a hung bus cycle on the FlexBus.
*
* Workaround: If the FlexBus is not being used, disabled the clock to the
* FlexBus during chip initialization by clearing the SIM_SCGC7[FLEXBUS] bit.
* If the FlexBus will be used, then enable at least one chip select as
* early in the chip initialization process as possible.
*/
bit_clear32(&SIM->SCGC7, SIM_SCGC7_FLEXBUS_SHIFT);
#endif
#ifdef RSIM
/* KW41Z errata
* e10224: RSIM: XTAL_OUT_EN signal from the pin is enabled by default
*
* Description: The XTAL_OUT_EN signal from the default XTAL_OUT_EN pin,
* PTB0, is enabled out of reset. This will result in the reference
* oscillator being enabled when this pin is asserted high regardless of the
* port control multiplexor setting.
*
* Workaround: To prevent the pin from enabling the XTAL out feature
* unintentionally, set RSIM_RF_OSC_CTRL[RADIO_EXT_OSC_OVRD_EN]=1.
*/
bit_set32(&RSIM->RF_OSC_CTRL, RSIM_RF_OSC_CTRL_RADIO_EXT_OSC_OVRD_EN_SHIFT);
#endif
}