/*TODO: move into pass-thru module */
static void init_passthru(void)
{
if (init_iommu() != 0) {
panic("failed to initialize iommu!");
}
ptdev_init();
}
/* Platform has no romstage entry point under mainboard directory,
* so this one is named with prefix mainboard.
*/
void mainboard_romstage_entry(unsigned long bist)
{
sysinfo_t sysinfo;
int s3resume = 0;
int cbmem_initted;
u16 reg16;
/* basic northbridge setup, including MMCONF BAR */
gm45_early_init();
if (bist == 0)
enable_lapic();
/* First, run everything needed for console output. */
i82801ix_early_init();
setup_pch_gpios(&mainboard_gpio_map);
mb_setup_lpc();
mb_setup_superio();
console_init();
report_bist_failure(bist);
reg16 = pci_read_config16(LPC_DEV, D31F0_GEN_PMCON_3);
pci_write_config16(LPC_DEV, D31F0_GEN_PMCON_3, reg16);
if ((MCHBAR16(SSKPD_MCHBAR) == 0xCAFE) && !(reg16 & (1 << 9))) {
printk(BIOS_DEBUG, "soft reset detected, rebooting properly\n");
gm45_early_reset();
}
/* ASPM related setting, set early by original BIOS. */
DMIBAR16(0x204) &= ~(3 << 10);
/* Check for S3 resume. */
s3resume = southbridge_detect_s3_resume();
/* RAM initialization */
enter_raminit_or_reset();
memset(&sysinfo, 0, sizeof(sysinfo));
get_mb_spd_addrmap(sysinfo.spd_map);
const struct device *dev;
dev = pcidev_on_root(2, 0);
if (dev)
sysinfo.enable_igd = dev->enabled;
dev = pcidev_on_root(1, 0);
if (dev)
sysinfo.enable_peg = dev->enabled;
get_gmch_info(&sysinfo);
mb_pre_raminit_setup(&sysinfo);
raminit(&sysinfo, s3resume);
mb_post_raminit_setup();
const u32 deven = pci_read_config32(MCH_DEV, D0F0_DEVEN);
/* Disable D4F0 (unknown signal controller). */
pci_write_config32(MCH_DEV, D0F0_DEVEN, deven & ~0x4000);
init_pm(&sysinfo, 0);
i82801ix_dmi_setup();
gm45_late_init(sysinfo.stepping);
i82801ix_dmi_poll_vc1();
MCHBAR16(SSKPD_MCHBAR) = 0xCAFE;
init_iommu();
cbmem_initted = !cbmem_recovery(s3resume);
romstage_handoff_init(cbmem_initted && s3resume);
printk(BIOS_SPEW, "exit main()\n");
}
