void Move (uint8_t chan, float angle, servo type)
{
switch(chan)
{
case 1:
TIM_SetCompare1(TIM12, AngleToDuty(angle, type));
break;
case 2:
TIM_SetCompare2(TIM12, AngleToDuty(angle, type));
break;
case 3:
TIM_SetCompare1(TIM3, AngleToDuty(angle, type));
break;
case 4:
TIM_SetCompare2(TIM3, AngleToDuty(angle, type));
break;
case 5:
TIM_SetCompare3(TIM3, AngleToDuty(angle, type));
break;
case 6:
TIM_SetCompare1(TIM4, AngleToDuty(angle, type));
break;
case 7:
TIM_SetCompare2(TIM4, AngleToDuty(angle, type));
break;
case 8:
TIM_SetCompare3(TIM4, AngleToDuty(angle, type));
break;
case 9:
TIM_SetCompare4(TIM4, AngleToDuty(angle, type));
break;
case 10:
TIM_SetCompare1(TIM4, AngleToDuty(angle, type));
break;
default:
break;
}
}
void initServos()
{
Timer4Init(20000);
Timer3Init(20000);
Timer12Init(20000);
PWM12Ch1Init(AngleToDuty(0.0, HD_1501MG)); // servo przy podstawie (obrót wokó³ osi pionowej)
PWM12Ch2Init(AngleToDuty(0.0, HD_1501MG)); // servo przy podstawie (obrót wokó³ osi poziomej)
PWM3Ch1Init(AngleToDuty(90.0, HD_1201MG)); // serwo na przegubie 3
PWM3Ch2Init(AngleToDuty(0.0, HD_1201MG)); // servo na przegubie 4
PWM3Ch3Init(AngleToDuty(0.0, HS_645MG)); // servo na przegubie 5 (oœ wzd³u¿ ogniwa)
PWM4Ch1Init(AngleToDuty(0.0, HS_485HB)); // servo na przegubie 6
PWM4Ch2Init(AngleToDuty(45.0, HS_55)); // chwytak 1
PWM4Ch3Init(AngleToDuty(-45.0, HS_55)); // chwytak 2
}
void SetPanAngle(int angle) {
u32 duty = SERVO_NEUTRAL;
if (angle < SERVO_ANGLE_MIN) {
MOTOR_DEBUG_PRINT("Attempted pan angle too low: %d\n", angle);
angle = SERVO_ANGLE_MIN;
} else if (angle > SERVO_ANGLE_MAX) {
MOTOR_DEBUG_PRINT("Attempted pan angle too high: %d\n", angle);
angle = SERVO_ANGLE_MAX;
}
duty = AngleToDuty(angle);
DRIVER_BOARD_IP_mWriteReg(DRIVER_BOARD_BASE_ADDR, PAN_REG_OFFSET, duty);
CurrentPanAngle = angle;
}
