C++ (Cpp) LEDBlinkyRoutine 예제들

예제 #1

파일: main.c 프로젝트: nqngo22/CC3200_LED

//****************************************************************************
//
//! Main function
//!
//! \param none
//! 
//! This function  
//!    1. Invokes the LEDBlinkyTask
//!
//! \return None.
//
//****************************************************************************
int
main()
{
    //
    // Initialize Board configurations
    //
    BoardInit();
    
    //
    // Power on the corresponding GPIO port B for 9,10,11.
    // Set up the GPIO lines to mode 0 (GPIO)
    //
    PinMuxConfig();

	#ifndef NOTERM
		//
		// Configuring UART
		//
		InitTerm();
	#endif

	DisplayBanner("Lab 0");
    Message("\t\t****************************************************\n\r");
    Message("\t\t\t        CC3200 UART Echo Usage        \n\r");
    Message("\t\t To get to state 3, the user must press and hold SW2  \n\r");
    Message("\t\t then press SW3 without releasing SW2   \n\r");
    Message("\t\t and then release SW2 while continuing to press SW3\n\r");
    Message("\n\n\n\r");

    GPIO_IF_LedConfigure(LED1|LED2|LED3);

    GPIO_IF_LedOff(MCU_ALL_LED_IND);
    
    //
    // Start the LEDBlinkyRoutine
    //
    LEDBlinkyRoutine();
    return 0;
}

예제 #2

파일: main.c 프로젝트: ClarePhang/CC3200

//****************************************************************************
//
//! Main function
//!
//! \param none
//!
//! This function
//!    1. Invokes the LEDBlinkyTask
//!
//! \return None.
//
//****************************************************************************
int
main()
{
    //
    // Initialize Board configurations
    //
    BoardInit();

    //
    // Power on the corresponding GPIO port B for 9,10,11.
    // Set up the GPIO lines to mode 0 (GPIO)
    //
    PinMuxConfig();
    GPIO_IF_LedConfigure(LED1|LED2|LED3);

    GPIO_IF_LedOff(MCU_ALL_LED_IND);

    //
    // Start the LEDBlinkyRoutine
    //
    LEDBlinkyRoutine();
    return 0;
}