/* *********************************************************************** */
void creat_ini()
{
disptitle("BATCH INFORMATION *CREATION*");
setmidwin();
clrscr();
curoff();
resetwin();
dispfuncv(NFKEYS,Createkeys);
}
main(int argc, char *argv[])
{
/*
This is the main section of this driver. It's makeup is entirely
up to you. With of course, several REQUIRED sets.
*/
int i,x,count;
int y=0,block_size=1024;
int send=0,do_acks=0;
char s[81],s1[81];
qvideo();
clrscrn();
Screen_ptr = malloc(1 * 4000);
if(Screen_ptr == NULL) exit(1);
uncomprs(&Screen_ptr[0*4000], tmod); /* uncompress screen 1 */
memtoscr(2000, 0, Screen_ptr);
curoff();
for(i=1;i<argc;i++)
{
if(argv[i][0] == '/' || argv[i][0] == '-')
{
switch(toupper(argv[i][1]))
{
case 'S' : block_size = atoi(argv[i+1]);
if(block_size > 1024)
block_size = 1024;
break;
case 'A' : do_acks = 1;break;
case 'K' : delete_aborted_transfers = 0;
break;
case 'P' : port_ptr = atoi(argv[i+1]);
port_ptr--;
break;
case 'B' : connect_rate = atoi(argv[i+1]);
cur_baud = connect_rate;
block_size = (connect_rate > 2400) ? 2048 : 1024;
break;
case 'L' : locked_port = atol(argv[i+1]);
break;
case 'R' : set_com();
/*
You should continue to cycle receiving files until
Zrecfile returns a ZERO, indicating that it did not
receive any files or the session was aborted.
*/
while ( Zrecfile(do_acks,block_size) && (async_carrier(port))) clear_screen() ;
/* Following the last file, the sender will require an ACK
to signal the receivers acknowledges end of session.
The Sender doesn't respond back after receiving the ACK so
continue with you processing after sending a couple of
ACKS. Two is suggested, an extra incase line noise blew the
first one.
*/
com_putc(ACK);
com_putc(ACK);
end_prg();
break;
case 'F' : set_com();
i++;
for(;i<argc;i++)
{
memset(s,'\0',sizeof(s));
parser(argv[i],&s[0]);
/* Cycle until all files are sent or Zsendfile returns
a zero indicating Session was aborted. */
if(!Zsendfile(argv[i],s))
end_prg();
if(!async_carrier(port)) end_prg();
clear_screen();
}
i = count = 0;
/* Cycle sending EOT until receiver sees it and ACKs
the ending EOT. I suggest cycling only two periods
, period being defined as trying ACKEOT function twice. */
while(!count && i <= 1)
{
com_putc(EOT);
i++;
if(ackeot()) count = 1;
if(!async_carrier(port)) count = 1;
}
end_prg();
break;
}
}
}
}