static void snd_imx_dma_err_callback(int channel, void *data, int err)
{
struct snd_pcm_substream *substream = data;
struct snd_soc_pcm_runtime *rtd = substream->private_data;
struct imx_pcm_dma_params *dma_params =
snd_soc_dai_get_dma_data(rtd->dai->cpu_dai, substream);
struct snd_pcm_runtime *runtime = substream->runtime;
struct imx_pcm_runtime_data *iprtd = runtime->private_data;
int ret;
pr_err("DMA timeout on channel %d -%s%s%s%s\n",
channel,
err & IMX_DMA_ERR_BURST ? " burst" : "",
err & IMX_DMA_ERR_REQUEST ? " request" : "",
err & IMX_DMA_ERR_TRANSFER ? " transfer" : "",
err & IMX_DMA_ERR_BUFFER ? " buffer" : "");
imx_dma_disable(iprtd->dma);
ret = imx_dma_setup_sg(iprtd->dma, iprtd->sg_list, iprtd->sg_count,
IMX_DMA_LENGTH_LOOP, dma_params->dma_addr,
substream->stream == SNDRV_PCM_STREAM_PLAYBACK ?
DMA_MODE_WRITE : DMA_MODE_READ);
if (!ret)
imx_dma_enable(iprtd->dma);
}
static int snd_imx_pcm_trigger(struct snd_pcm_substream *substream, int cmd)
{
struct snd_pcm_runtime *runtime = substream->runtime;
struct imx_pcm_runtime_data *iprtd = runtime->private_data;
switch (cmd) {
case SNDRV_PCM_TRIGGER_START:
case SNDRV_PCM_TRIGGER_RESUME:
case SNDRV_PCM_TRIGGER_PAUSE_RELEASE:
imx_dma_enable(iprtd->dma);
break;
case SNDRV_PCM_TRIGGER_STOP:
case SNDRV_PCM_TRIGGER_SUSPEND:
case SNDRV_PCM_TRIGGER_PAUSE_PUSH:
imx_dma_disable(iprtd->dma);
break;
default:
return -EINVAL;
}
return 0;
}
static void mx27_camera_dma_enable(struct mx2_camera_dev *pcdev)
{
u32 tmp;
imx_dma_enable(pcdev->dma);
tmp = readl(pcdev->base_csi + CSICR1);
tmp |= CSICR1_RF_OR_INTEN;
writel(tmp, pcdev->base_csi + CSICR1);
}
static int imxmci_cmd_done(struct imxmci_host *host, unsigned int stat)
{
struct mmc_command *cmd = host->cmd;
int i;
u32 a,b,c;
struct mmc_data *data = host->data;
if (!cmd)
return 0;
host->cmd = NULL;
if (stat & STATUS_TIME_OUT_RESP) {
dev_dbg(mmc_dev(host->mmc), "CMD TIMEOUT\n");
cmd->error = MMC_ERR_TIMEOUT;
} else if (stat & STATUS_RESP_CRC_ERR && cmd->flags & MMC_RSP_CRC) {
dev_dbg(mmc_dev(host->mmc), "cmd crc error\n");
cmd->error = MMC_ERR_BADCRC;
}
if(cmd->flags & MMC_RSP_PRESENT) {
if(cmd->flags & MMC_RSP_136) {
for (i = 0; i < 4; i++) {
u32 a = MMC_RES_FIFO & 0xffff;
u32 b = MMC_RES_FIFO & 0xffff;
cmd->resp[i] = a<<16 | b;
}
} else {
a = MMC_RES_FIFO & 0xffff;
b = MMC_RES_FIFO & 0xffff;
c = MMC_RES_FIFO & 0xffff;
cmd->resp[0] = a<<24 | b<<8 | c>>8;
}
}
dev_dbg(mmc_dev(host->mmc), "RESP 0x%08x, 0x%08x, 0x%08x, 0x%08x, error %d\n",
cmd->resp[0], cmd->resp[1], cmd->resp[2], cmd->resp[3], cmd->error);
if (data && (cmd->error == MMC_ERR_NONE) && !(stat & STATUS_ERR_MASK)) {
if (host->req->data->flags & MMC_DATA_WRITE) {
/* Wait for FIFO to be empty before starting DMA write */
stat = MMC_STATUS;
if(imxmci_busy_wait_for_status(host, &stat,
STATUS_APPL_BUFF_FE,
40, "imxmci_cmd_done DMA WR") < 0) {
cmd->error = MMC_ERR_FIFO;
imxmci_finish_data(host, stat);
if(host->req)
imxmci_finish_request(host, host->req);
dev_warn(mmc_dev(host->mmc), "STATUS = 0x%04x\n",
stat);
return 0;
}
if(test_bit(IMXMCI_PEND_DMA_DATA_b, &host->pending_events)) {
imx_dma_enable(host->dma);
}
}
} else {
struct mmc_request *req;
imxmci_stop_clock(host);
req = host->req;
if(data)
imxmci_finish_data(host, stat);
if( req ) {
imxmci_finish_request(host, req);
} else {
dev_warn(mmc_dev(host->mmc), "imxmci_cmd_done: no request to finish\n");
}
}
return 1;
}
static void imxmci_setup_data(struct imxmci_host *host, struct mmc_data *data)
{
unsigned int nob = data->blocks;
unsigned int blksz = data->blksz;
unsigned int datasz = nob * blksz;
int i;
if (data->flags & MMC_DATA_STREAM)
nob = 0xffff;
host->data = data;
data->bytes_xfered = 0;
MMC_NOB = nob;
MMC_BLK_LEN = blksz;
/*
* DMA cannot be used for small block sizes, we have to use CPU driven transfers otherwise.
* We are in big troubles for non-512 byte transfers according to note in the paragraph
* 20.6.7 of User Manual anyway, but we need to be able to transfer SCR at least.
* The situation is even more complex in reality. The SDHC in not able to handle wll
* partial FIFO fills and reads. The length has to be rounded up to burst size multiple.
* This is required for SCR read at least.
*/
if (datasz < 512) {
host->dma_size = datasz;
if (data->flags & MMC_DATA_READ) {
host->dma_dir = DMA_FROM_DEVICE;
/* Hack to enable read SCR */
MMC_NOB = 1;
MMC_BLK_LEN = 512;
} else {
host->dma_dir = DMA_TO_DEVICE;
}
/* Convert back to virtual address */
host->data_ptr = (u16*)(page_address(data->sg->page) + data->sg->offset);
host->data_cnt = 0;
clear_bit(IMXMCI_PEND_DMA_DATA_b, &host->pending_events);
set_bit(IMXMCI_PEND_CPU_DATA_b, &host->pending_events);
return;
}
if (data->flags & MMC_DATA_READ) {
host->dma_dir = DMA_FROM_DEVICE;
host->dma_nents = dma_map_sg(mmc_dev(host->mmc), data->sg,
data->sg_len, host->dma_dir);
imx_dma_setup_sg(host->dma, data->sg, data->sg_len, datasz,
host->res->start + MMC_BUFFER_ACCESS_OFS, DMA_MODE_READ);
/*imx_dma_setup_mem2dev_ccr(host->dma, DMA_MODE_READ, IMX_DMA_WIDTH_16, CCR_REN);*/
CCR(host->dma) = CCR_DMOD_LINEAR | CCR_DSIZ_32 | CCR_SMOD_FIFO | CCR_SSIZ_16 | CCR_REN;
} else {
host->dma_dir = DMA_TO_DEVICE;
host->dma_nents = dma_map_sg(mmc_dev(host->mmc), data->sg,
data->sg_len, host->dma_dir);
imx_dma_setup_sg(host->dma, data->sg, data->sg_len, datasz,
host->res->start + MMC_BUFFER_ACCESS_OFS, DMA_MODE_WRITE);
/*imx_dma_setup_mem2dev_ccr(host->dma, DMA_MODE_WRITE, IMX_DMA_WIDTH_16, CCR_REN);*/
CCR(host->dma) = CCR_SMOD_LINEAR | CCR_SSIZ_32 | CCR_DMOD_FIFO | CCR_DSIZ_16 | CCR_REN;
}
#if 1 /* This code is there only for consistency checking and can be disabled in future */
host->dma_size = 0;
for(i=0; i<host->dma_nents; i++)
host->dma_size+=data->sg[i].length;
if (datasz > host->dma_size) {
dev_err(mmc_dev(host->mmc), "imxmci_setup_data datasz 0x%x > 0x%x dm_size\n",
datasz, host->dma_size);
}
#endif
host->dma_size = datasz;
wmb();
if(host->actual_bus_width == MMC_BUS_WIDTH_4)
BLR(host->dma) = 0; /* burst 64 byte read / 64 bytes write */
else
BLR(host->dma) = 16; /* burst 16 byte read / 16 bytes write */
RSSR(host->dma) = DMA_REQ_SDHC;
set_bit(IMXMCI_PEND_DMA_DATA_b, &host->pending_events);
clear_bit(IMXMCI_PEND_CPU_DATA_b, &host->pending_events);
/* start DMA engine for read, write is delayed after initial response */
if (host->dma_dir == DMA_FROM_DEVICE) {
imx_dma_enable(host->dma);
}
}
