static void initialize()
{
CLOCK_StopTimer();
tx_power = Model.tx_power;
phase = initialize_rx_tx_addr();
telemetry_setup_state = CFLIE_TELEM_SETUP_STATE_INIT;
packet_counter = 0;
int delay = cflie_init();
dbgprintf("cflie init\n");
if (phase == CFLIE_INIT_SEARCH) {
PROTOCOL_SetBindState(0xFFFFFFFF);
}
CLOCK_StartTimer(delay, cflie_callback);
}
// Generate id and hopping freq
static void CORONA_init()
{
#ifdef CORONA_FORCE_ID
// Example of ID and channels taken from dumps
switch (Model.proto_opts[PROTO_OPTS_FORMAT]) {
case FORMAT_V1:
memcpy((void *)rx_tx_addr,(void *)"\x1F\xFE\x6C\x35",CORONA_ADDRESS_LENGTH);
memcpy((void *)hopping_frequency,(void *)"\x17\x0D\x03\x49",CORONA_RF_NUM_CHANNELS+1);
break;
case FORMAT_V2:
memcpy((void *)rx_tx_addr,(void *)"\xFE\xFE\x02\xFB",CORONA_ADDRESS_LENGTH);
memcpy((void *)hopping_frequency,(void *)"\x14\x3D\x35",CORONA_RF_NUM_CHANNELS);
break;
case FORMAT_FDV3:
memcpy((void *)rx_tx_addr,(void *)"\x02\xfa\x38\x38",CORONA_ADDRESS_LENGTH);
memcpy((void *)hopping_frequency,(void *)"\x71\xb9\x30",CORONA_RF_NUM_CHANNELS);
break;
}
#else
// From dumps channels are anything between 0x00 and 0xC5 on V1.
// But 0x00 and 0xB8 should be avoided on V2 since they are used for bind.
// Below code make sure channels are between 0x02 and 0xA0, spaced with
// a minimum of 2 and not ordered (RX only use the 1st channel unless there is an issue).
// Extra hopping frequency used for Flydream V3 id packets
initialize_rx_tx_addr();
u8 order = rx_tx_addr[3] & 0x03;
for (u8 i=0; i < CORONA_RF_NUM_CHANNELS+1; i++)
hopping_frequency[i^order] = 2+rx_tx_addr[3-i]%39+(i<<5)+(i<<3);
if (Model.proto_opts[PROTO_OPTS_FORMAT] != FORMAT_FDV3) {
// ID looks random but on the 15 V1 dumps they all show the same odd/even rule
if (rx_tx_addr[3] & 0x01) { // If [3] is odd then [0] is odd and [2] is even
rx_tx_addr[0] |= 0x01;
rx_tx_addr[2] &= 0xFE;
} else { // If [3] is even then [0] is even and [2] is odd
rx_tx_addr[0] &= 0xFE;
rx_tx_addr[2] |= 0x01;
}
rx_tx_addr[1] = 0xFE; // Always FE in the dumps of V1 and V2
} else {
rx_tx_addr[1] = 0xFA; // Always FA for Flydream V3
rx_tx_addr[3] = hopping_frequency[CORONA_RF_NUM_CHANNELS]; // channel used for id/freq packets
}
#endif
}