/*
* static function
*/
static inline void cpu_enter_lowpower(unsigned int cpu)
{
//HOTPLUG_INFO("cpu_enter_lowpower\n");
#ifdef SPM_MCDI_FUNC
spm_hot_plug_out_after(cpu);
#endif
/* Clear the SCTLR C bit to prevent further data cache allocation */
__disable_dcache();
/* Clean and invalidate all data from the L1 data cache */
inner_dcache_flush_L1();
//Just flush the cache.
//flush_cache_all();
/* Clean all data from the L2 data cache */
__inner_clean_dcache_L2();
/* Execute a CLREX instruction */
__asm__ __volatile__("clrex");
/* Switch the processor from SMP mode to AMP mode by clearing the ACTLR SMP bit */
__switch_to_amp();
}
void atomic_flush(void)
{
__disable_cache();
inner_dcache_flush_L1();
atomic_inc(&L1_flush_done);
//update cr_alignment for other kernel function usage
cr_alignment = cr_alignment & ~(0x4); //C1_CBIT
}
/*
* static function
*/
static inline void cpu_enter_lowpower(unsigned int cpu)
{
HOTPLUG_INFO("cpu_enter_lowpower\n");
/* Cluster off */
if ((cpu == 3 && cpu_online(2) == 0) || (cpu == 2 && cpu_online(3) == 0)) {
/* Clear the SCTLR C bit to prevent further data cache allocation */
__disable_dcache();
isb();
dsb();
/* Clean and invalidate all data from the L1, L2 data cache */
inner_dcache_flush_all();
/* flush_cache_all(); */
/* Switch the processor from SMP mode to AMP mode by clearing the ACTLR SMP bit */
__switch_to_amp();
isb();
dsb();
/* disable CA15 CCI */
spm_write(CA15_CCI400_DVM_EN, spm_read(CA15_CCI400_DVM_EN) & ~0x3);
/* wait cci change pending */
while (spm_read(CCI400_STATUS) & 0x1)
;
/* Ensure the ACP master does not send further requests to the individual processor.
Assert AINACTS to idle the ACP slave interface after all responses are received. */
/* mt65xx_reg_sync_writel( *CA15_MISC_DBG | 0x11, CA15_MISC_DBG); */
spm_write(CA15_MISC_DBG, spm_read(CA15_MISC_DBG) | 0x11);
} else {
/* Clear the SCTLR C bit to prevent further data cache allocation */
__disable_dcache();
isb();
dsb();
/* Clean and invalidate all data from the L1 data cache */
inner_dcache_flush_L1();
/* Just flush the cache. */
/* flush_cache_all(); */
/* Execute a CLREX instruction */
__asm__ __volatile__("clrex");
/* Switch the processor from SMP mode to AMP mode by clearing the ACTLR SMP bit */
__switch_to_amp();
}
}
/*
* static function
*/
static inline void cpu_enter_lowpower(unsigned int cpu)
{
//HOTPLUG_INFO("cpu_enter_lowpower\n");
if (((cpu == 4) && (cpu_online(5) == 0) && (cpu_online(6) == 0) && (cpu_online(7) == 0)) ||
((cpu == 5) && (cpu_online(4) == 0) && (cpu_online(6) == 0) && (cpu_online(7) == 0)) ||
((cpu == 6) && (cpu_online(4) == 0) && (cpu_online(5) == 0) && (cpu_online(7) == 0)) ||
((cpu == 7) && (cpu_online(4) == 0) && (cpu_online(5) == 0) && (cpu_online(6) == 0)))
{
#if 0
/* Clear the SCTLR C bit to prevent further data cache allocation */
__disable_dcache();
/* Clean and invalidate all data from the L1/L2 data cache */
inner_dcache_flush_L1();
//flush_cache_all();
/* Execute a CLREX instruction */
__asm__ __volatile__("clrex");
/* Clean all data from the L2 data cache */
inner_dcache_flush_L2();
#else
__disable_dcache__inner_flush_dcache_L1__inner_flush_dcache_L2();
#endif
/* Switch the processor from SMP mode to AMP mode by clearing the ACTLR SMP bit */
__switch_to_amp();
/* Execute an ISB instruction to ensure that all of the CP15 register changes from the previous steps have been committed */
isb();
/* Execute a DSB instruction to ensure that all cache, TLB and branch predictor maintenance operations issued by any processor in the multiprocessor device before the SMP bit was cleared have completed */
dsb();
/* Disable snoop requests and DVM message requests */
REG_WRITE(CCI400_SI3_SNOOP_CONTROL, REG_READ(CCI400_SI3_SNOOP_CONTROL) & ~(SNOOP_REQ | DVM_MSG_REQ));
while (REG_READ(CCI400_STATUS) & CHANGE_PENDING);
/* Disable CA15L snoop function */
#if defined(CONFIG_ARM_PSCI) || defined(CONFIG_MTK_PSCI)
mcusys_smc_write_phy(virt_to_phys(MP1_AXI_CONFIG), REG_READ(MP1_AXI_CONFIG) | ACINACTM);
#else //#if defined(CONFIG_ARM_PSCI) || defined(CONFIG_MTK_PSCI)
mcusys_smc_write(MP1_AXI_CONFIG, REG_READ(MP1_AXI_CONFIG) | ACINACTM);
#endif //#if defined(CONFIG_ARM_PSCI) || defined(CONFIG_MTK_PSCI)
}
else
{
#if 0
/* Clear the SCTLR C bit to prevent further data cache allocation */
__disable_dcache();
/* Clean and invalidate all data from the L1 data cache */
inner_dcache_flush_L1();
//Just flush the cache.
//flush_cache_all();
/* Clean all data from the L2 data cache */
//__inner_clean_dcache_L2();
#else
//FIXME: why __disable_dcache__inner_flush_dcache_L1 fail but 2 steps ok?
//__disable_dcache__inner_flush_dcache_L1();
__disable_dcache__inner_flush_dcache_L1__inner_clean_dcache_L2();
#endif
/* Execute a CLREX instruction */
__asm__ __volatile__("clrex");
/* Switch the processor from SMP mode to AMP mode by clearing the ACTLR SMP bit */
__switch_to_amp();
}
}
