/* system_rev == higher 16bits of PCBID
XA -> 0000FFFF -> 0x0000
XB -> 0101FFFF -> 0x0101
XC -> 0202FFFF -> 0x0202
*/
static void __init supersonic_init(void)
{
int ret;
struct kobject *properties_kobj;
printk("supersonic_init() revision=%d\n", system_rev);
msm_hw_reset_hook = supersonic_reset;
OJ_BMA_power();
gpio_direction_output(SUPERSONIC_GPIO_PROXIMITY_EN_N, 0);
msm_acpu_clock_init(&supersonic_clock_data);
perflock_init(&supersonic_perflock_data);
#if defined(CONFIG_MSM_SERIAL_DEBUGGER)
msm_device_uart1.dev.platform_data = &msm_uart_debug_pdata;
msm_serial_debug_init(MSM_UART1_PHYS, INT_UART1,
&msm_device_uart1.dev, 1, MSM_GPIO_TO_INT(SUPERSONIC_GPIO_UART1_RX));
#endif
#ifdef CONFIG_ARCH_QSD8X50
bt_export_bd_address();
#endif
/* set the gpu power rail to manual mode so clk en/dis will not
* turn off gpu power, and hang it on resume */
supersonic_kgsl_power_rail_mode(0);
supersonic_kgsl_power(true);
#ifdef CONFIG_SERIAL_MSM_HS
msm_device_uart_dm1.dev.platform_data = &msm_uart_dm1_pdata;
msm_device_uart_dm1.name = "msm_serial_hs_bcm"; /* for bcm */
#endif
config_gpio_table(camera_off_gpio_table,
ARRAY_SIZE(camera_off_gpio_table));
/*gpio_direction_output(SUPERSONIC_GPIO_TP_LS_EN, 0);*/
gpio_direction_output(SUPERSONIC_GPIO_TP_EN, 0);
supersonic_audio_init();
#ifdef CONFIG_MICROP_COMMON
supersonic_microp_init();
#endif
msm_device_i2c_init();
platform_add_devices(devices, ARRAY_SIZE(devices));
if (!opt_usb_h2w_sw) {
msm_register_usb_phy_init_seq(supersonic_phy_init_seq);
msm_register_uart_usb_switch(supersonic_uart_usb_switch);
msm_add_usb_id_pin_gpio(SUPERSONIC_GPIO_USB_ID_PIN);
msm_hsusb_set_product(supersonic_usb_products,
ARRAY_SIZE(supersonic_usb_products));
msm_add_usb_devices(msm_hsusb_8x50_phy_reset, NULL);
}
i2c_register_board_info(0, i2c_devices, ARRAY_SIZE(i2c_devices));
ret = supersonic_init_mmc(system_rev);
if (ret != 0)
pr_crit("%s: Unable to initialize MMC\n", __func__);
properties_kobj = kobject_create_and_add("board_properties", NULL);
if (properties_kobj)
ret = sysfs_create_group(properties_kobj,
&supersonic_properties_attr_group);
if (!properties_kobj || ret)
pr_err("failed to create board_properties\n");
msm_init_pmic_vibrator();
config_gpio_table(usb_phy_3v3_table, ARRAY_SIZE(usb_phy_3v3_table));
config_gpio_table(usb_ID_PIN_table, ARRAY_SIZE(usb_ID_PIN_table));
gpio_set_value(SUPERSONIC_USB_PHY_3V3_ENABLE, 1);
}
static void __init latte_init(void)
{
int rc;
char *cid = NULL;
printk("latte_init() revision = 0x%X\n", system_rev);
board_get_cid_tag(&cid);
/*
* Setup common MSM GPIOS
*/
config_gpios();
/* We need to set this pin to 0 only once on power-up; we will
* not actually enable the chip until we apply power to it via
* vreg.
*/
gpio_direction_output(LATTE_GPIO_LS_EN, 0);
/* disable power for cm3602 chip */
__capella_cm3602_power(0);
msm_hw_reset_hook = latte_reset;
msm_acpu_clock_init(&latte_clock_data);
perflock_init(&latte_perflock_data);
#if defined(CONFIG_MSM_SERIAL_DEBUGGER)
if (!opt_disable_uart3)
msm_serial_debug_init(MSM_UART3_PHYS, INT_UART3,
&msm_device_uart3.dev, 1,
MSM_GPIO_TO_INT(LATTE_GPIO_UART3_RX));
#endif
msm_add_devices();
#ifdef CONFIG_SERIAL_MSM_HS
msm_device_uart_dm1.dev.platform_data = &msm_uart_dm1_pdata;
msm_add_serial_devices(3);
#else
msm_add_serial_devices(0);
#endif
msm_add_serial_devices(2);
/*
msm_change_usb_id(0x0bb4, 0x0c10);
*/
msm_add_usb_id_pin_gpio(LATTE_GPIO_USB_ID_PIN);
msm_register_usb_phy_init_seq(espresso_phy_init_seq);
msm_hsusb_set_product(espresso_usb_products,
ARRAY_SIZE(espresso_usb_products));
msm_add_usb_devices(latte_phy_reset, latte_phy_shutdown);
msm_add_mem_devices(&pmem_setting);
msm_init_pmic_vibrator();
#ifdef CONFIG_MICROP_COMMON
latte_microp_init();
#endif
latte_init_h2w_power_gpio();
rc = latte_init_mmc(system_rev);
if (rc)
printk(KERN_CRIT "%s: MMC init failure (%d)\n", __func__, rc);
/* register flashlight at new-XA above */
platform_device_register(&latte_flashlight_device);
/* probe camera driver */
i2c_register_board_info(0, i2c_camera_devices, ARRAY_SIZE(i2c_camera_devices));
msm_device_i2c.dev.platform_data = &latte_i2c_device_data;
platform_add_devices(devices, ARRAY_SIZE(devices));
i2c_register_board_info(0, i2c_devices, ARRAY_SIZE(i2c_devices));
latte_init_keypad();
}
static void __init incrediblec_init(void)
{
int ret;
struct kobject *properties_kobj;
printk("incrediblec_init() revision=%d, engineerid=%d\n", system_rev, engineerid);
msm_hw_reset_hook = incrediblec_reset;
if (0 == engineerid || 0xF == engineerid) {
mdp_pmem_pdata.start = MSM_PMEM_MDP_XA_BASE;
android_pmem_adsp_pdata.start = MSM_PMEM_ADSP_XA_BASE;
msm_kgsl_resources[1].start = MSM_GPU_MEM_XA_BASE;
msm_kgsl_resources[1].end = MSM_GPU_MEM_XA_BASE + MSM_GPU_MEM_SIZE - 1;
} else if (engineerid >= 3) {
mdp_pmem_pdata.start = MSM_PMEM_MDP_BASE + MSM_MEM_128MB_OFFSET;
android_pmem_adsp_pdata.start = MSM_PMEM_ADSP_BASE + MSM_MEM_128MB_OFFSET;
msm_kgsl_resources[1].start = MSM_GPU_MEM_BASE;
msm_kgsl_resources[1].end = msm_kgsl_resources[1].start + MSM_GPU_MEM_SIZE - 1;
}
OJ_BMA_power();
gpio_direction_output(INCREDIBLEC_GPIO_PROXIMITY_EN_N, 0);
msm_acpu_clock_init(&incrediblec_clock_data);
perflock_init(&incrediblec_perflock_data);
#if defined(CONFIG_MSM_SERIAL_DEBUGGER)
msm_serial_debug_init(MSM_UART1_PHYS, INT_UART1,
&msm_device_uart1.dev, 1, INT_UART1_RX);
#endif
#ifdef CONFIG_ARCH_QSD8X50
bt_export_bd_address();
#endif
/* set the gpu power rail to manual mode so clk en/dis will not
* turn off gpu power, and hang it on resume */
incrediblec_kgsl_power_rail_mode(0);
incrediblec_kgsl_power(true);
#ifdef CONFIG_SERIAL_MSM_HS
msm_device_uart_dm1.dev.platform_data = &msm_uart_dm1_pdata;
msm_device_uart_dm1.name = "msm_serial_hs_bcm"; /* for bcm */
#endif
incrediblec_config_uart_gpios();
config_gpio_table(camera_off_gpio_table,
ARRAY_SIZE(camera_off_gpio_table));
/*gpio_direction_output(INCREDIBLEC_GPIO_TP_LS_EN, 0);*/
gpio_direction_output(INCREDIBLEC_GPIO_TP_EN, 0);
incrediblec_audio_init();
msm_device_i2c_init();
#ifdef CONFIG_MICROP_COMMON
incrediblec_microp_init();
#endif
msm_init_ums_lun(2); /*0: sd card, 1: moving nand*/
msm_register_usb_phy_init_seq(incrediblec_phy_init_seq);
msm_hsusb_set_product(incrediblec_usb_products,
ARRAY_SIZE(incrediblec_usb_products));
msm_register_uart_usb_switch(NULL);
msm_add_usb_id_pin_gpio(INCREDIBLEC_GPIO_USB_ID_PIN);
msm_add_usb_devices(msm_hsusb_8x50_phy_reset, NULL);
if (system_rev >= 2) {
microp_data.num_functions = ARRAY_SIZE(microp_functions_1);
microp_data.microp_function = microp_functions_1;
}
platform_add_devices(devices, ARRAY_SIZE(devices));
i2c_register_board_info(0, i2c_devices, ARRAY_SIZE(i2c_devices));
ret = incrediblec_init_mmc(system_rev);
if (ret != 0)
pr_crit("%s: Unable to initialize MMC\n", __func__);
properties_kobj = kobject_create_and_add("board_properties", NULL);
if (properties_kobj)
ret = sysfs_create_group(properties_kobj,
&incrediblec_properties_attr_group);
if (!properties_kobj || ret)
pr_err("failed to create board_properties\n");
msm_init_pmic_vibrator();
config_gpio_table(incrediblec_usb_phy_3v3_table, ARRAY_SIZE(incrediblec_usb_phy_3v3_table));
config_gpio_table(usb_ID_PIN_table, ARRAY_SIZE(usb_ID_PIN_table));
gpio_direction_output(INCREDIBLEC_USB_PHY_3V3_ENABLE, 1);
}
