int main (void) {
uint32_t err_code;
//
// Initialization
//
led_init(LED_0);
// We default to doing ranging at the start
app.app_ranging = 1;
// Set to effective -1
app.calibration_index = 255;
// Get stored address
memcpy(_ble_address, (uint8_t*) ADDRESS_FLASH_LOCATION, 6);
// And use it to setup the BLE
ble_config.device_id = (_ble_address[1] << 8) | _ble_address[0];
// Setup BLE
simple_ble_app = simple_ble_init(&ble_config);
// Setup the advertisement to use the Eddystone format.
// We include the device name in the scan response
ble_advdata_t srdata;
memset(&srdata, 0, sizeof(srdata));
srdata.name_type = BLE_ADVDATA_FULL_NAME;
eddystone_adv(PHYSWEB_URL, &srdata);
// Need a timer to make sure we have inited the tripoint
timers_init();
// Init the nRF hardware to work with the tripoint module.
err_code = tripoint_hw_init();
APP_ERROR_CHECK(err_code);
// Init the state machine on the tripoint
err_code = tripoint_init(updateData);
if (err_code == NRF_SUCCESS) {
tripoint_inited = true;
}
// Start the ranging!!!
if (tripoint_inited) {
tripoint_start_ranging(true, 10);
}
led_on(LED_0);
while (1) {
power_manage();
if (updated) {
tripointDataUpdate();
}
}
}
int main (void) {
printf("[BLE] UART over BLE\n");
// Setup BLE
conn_handle = simple_ble_init(&ble_config)->conn_handle;
// Advertise the UART service
ble_uuid_t adv_uuid = {0x0001, BLE_UUID_TYPE_VENDOR_BEGIN};
simple_adv_service(&adv_uuid);
}
int main(void) {
// Setup BLE
simple_ble_init(&ble_config);
// Advertise this
simple_adv_service(&dis_service_uuid);
// Enter main loop
while(1) {
power_manage();
}
}
int main(void) {
uint32_t err_code;
led_init(LED_0);
// Setup BLE
simple_ble_init(&ble_config);
// Advertise because why not
simple_adv_only_name();
led_on(LED_0);
while (1) {
power_manage();
}
}
int main (void) {
uint32_t err_code;
// Setup BLE
simple_ble_init(&ble_config);
// Advertise because why not
simple_adv_only_name();
// RTT code
log_rtt_init();
log_rtt_printf(0, "Debug to RTT\n");
while (1) {
power_manage();
}
}