/*add by miaofng*/ void low_level_init(struct netif *netif) { // // Enable and Reset the Ethernet Controller. // SysCtlPeripheralEnable(SYSCTL_PERIPH_ETH); SysCtlPeripheralReset(SYSCTL_PERIPH_ETH); // // Enable Port F for Ethernet LEDs. // LED0 Bit 3 Output // LED1 Bit 2 Output // SysCtlPeripheralEnable(SYSCTL_PERIPH_GPIOF); GPIOPinTypeEthernetLED(GPIO_PORTF_BASE, GPIO_PIN_2 | GPIO_PIN_3); /* initialize the hardware */ stellarisif_hwinit(netif); }
/** * Should be called at the beginning of the program to set up the * network interface. It calls the function stellarisif_hwinit() to do the * actual setup of the hardware. * * This function should be passed as a parameter to netif_add(). * * @param netif the lwip network interface structure for this ethernetif * @return ERR_OK if the loopif is initialized * ERR_MEM if private data couldn't be allocated * any other err_t on error */ err_t stellarisif_init(struct netif *netif) { LWIP_ASSERT("netif != NULL", (netif != NULL)); #if LWIP_NETIF_HOSTNAME /* Initialize interface hostname */ netif->hostname = "lwip"; #endif /* LWIP_NETIF_HOSTNAME */ /* * Initialize the snmp variables and counters inside the struct netif. * The last argument should be replaced with your link speed, in units * of bits per second. */ NETIF_INIT_SNMP(netif, snmp_ifType_ethernet_csmacd, 1000000); netif->state = &stellarisif_data; netif->name[0] = IFNAME0; netif->name[1] = IFNAME1; /* We directly use etharp_output() here to save a function call. * You can instead declare your own function an call etharp_output() * from it if you have to do some checks before sending (e.g. if link * is available...) */ netif->output = etharp_output; netif->linkoutput = stellarisif_output; stellarisif_data.ethaddr = (struct eth_addr *)&(netif->hwaddr[0]); stellarisif_data.txq.qread = stellarisif_data.txq.qwrite = 0; stellarisif_data.txq.overflow = 0; /* initialize the hardware */ stellarisif_hwinit(netif); return ERR_OK; }