/*
* main.c
*/
void main() {
init_pins();
init_button();
init_adc();
init_wdt();
WDT_delay = CURRENT_DELAY;
BCSCTL1 = CALBC1_8MHZ;
DCOCTL = CALDCO_8MHZ;
LCD_setup();
_bis_SR_register(GIE); // enable interrupts
// initialize LCD and say hello a few times :-)
LCD_init();
LCD_send_string((char*)msg);
while(1){
LCD_put(0x80+40); // cursor to line 2, first position
snprintf(hex, 20, HEX, (int)colourArray[1], (int)colourArray[2], (int)colourArray[0]);
LCD_send_string(hex);
}
_bis_SR_register(LPM0_bits);
//delay(0); // maximum delay
}
static void PutBitsOnPins(char bits) {
if (lcd_connected == -1) {
LCD_setup();
}
if (lcd_connected == 1) {
char buf[1];
buf[0] = bits;
if (write(fd,buf,1) != 1) {
printf("Failed to write to the i2c bus.\n");
lcd_connected = 0;
}
}
}
// Setup
inline void Scan_setup()
{
// Setup UART Connect, if Output_Available, this is the master node
Connect_setup( Output_Available );
// Setup GPIO pins for matrix scanning
Matrix_setup();
// Setup ISSI chip to control the leds
LED_setup();
// Setup the ST/NHD lcd display
LCD_setup();
// Reset scan count
Scan_scanCount = 0;
}