Exemplo n.º 1
0
void NETCLASS::SetParams( const NETCLASS& aDefaults )
{
    SetClearance( aDefaults.GetClearance() );
    SetTrackWidth( aDefaults.GetTrackWidth() );
    SetViaDiameter( aDefaults.GetViaDiameter() );
    SetViaDrill( aDefaults.GetViaDrill() );
    SetuViaDiameter( aDefaults.GetuViaDiameter() );
    SetuViaDrill( aDefaults.GetuViaDrill() );
}
Exemplo n.º 2
0
void NETCLASS::SetParams( const NETCLASS* defaults )
{
    if( defaults )
    {
        SetClearance( defaults->GetClearance() );
        SetTrackWidth( defaults->GetTrackWidth() );
        SetViaDiameter( defaults->GetViaDiameter() );
        SetViaDrill( defaults->GetViaDrill() );
        SetuViaDiameter( defaults->GetuViaDiameter() );
        SetuViaDrill( defaults->GetuViaDrill() );
    }
    else
    {

/* Dick 5-Feb-2012:  I do not believe this comment to be true with current code.
        It is certainly not a constructor race.  Normally items are initialized
        within a class according to the order of their appearance.

        // Note:
        // We use m_Parent->GetDesignSettings() to get some default values
        // But when this function is called when instantiating a BOARD class,
        // by the NETCLASSES constructor that calls NETCLASS constructor,
        // the BOARD constructor (see BOARD::BOARD) is not yet run,
        // and BOARD::m_designSettings contains not yet initialized values.
        // So inside the BOARD constructor itself, you SHOULD recall SetParams
*/

        const BOARD_DESIGN_SETTINGS& g = m_Parent->GetDesignSettings();

        SetTrackWidth(  g.m_TrackMinWidth );
        SetViaDiameter( g.m_ViasMinSize );
        SetuViaDiameter(g.m_MicroViasMinSize );

        // Use default values for next parameters:
        SetClearance( DEFAULT_CLEARANCE );
        SetViaDrill( DEFAULT_VIA_DRILL );
        SetuViaDrill( DEFAULT_UVIA_DRILL );
    }
}
Exemplo n.º 3
0
NETCLASS::NETCLASS( const wxString& aName ) :
    m_Name( aName )
{
    // Default settings
    SetClearance( DEFAULT_CLEARANCE );
    SetViaDrill( DEFAULT_VIA_DRILL );
    SetuViaDrill( DEFAULT_UVIA_DRILL );
    // These defaults will be overwritten by SetParams,
    // from the board design parameters, later
    SetTrackWidth( DEFAULT_TRACK_WIDTH );
    SetViaDiameter( DEFAULT_VIA_DIAMETER );
    SetuViaDiameter( DEFAULT_UVIA_DIAMETER );
}