/* Start running. Must have called usb_open (above) first */
int sa1100_usb_start( void ) {
usbd_info.state = USB_STATE_SUSPENDED;
/* Enable UDC and mask everything */
UDC_write(Ser0UDCCR , 0xFC);
/* clear stall - receiver seems to start stalled? 19Jan01ww */
/* also clear other stuff just to be thurough 22Feb01ww */
UDC_clear(Ser0UDCCS1, UDCCS1_FST | UDCCS1_RPE | UDCCS1_RPC );
UDC_clear(Ser0UDCCS2, UDCCS2_FST | UDCCS2_TPE | UDCCS2_TPC );
rx_pktsize = 8; // OJO
tx_pktsize = 1; // OJO
/* flush DMA and fire through some -EAGAINs */
ep1_init( usbd_info.dmach_rx );
ep2_init( usbd_info.dmach_tx );
/* clear all top-level sources */
Ser0UDCSR = UDCSR_RSTIR | UDCSR_RESIR | UDCSR_EIR | UDCSR_RIR | UDCSR_TIR | UDCSR_SUSIR ;
/* EXERIMENT - a short line in the spec says toggling this
..bit diddles the internal state machine in the udc to
..expect a suspend */
Ser0UDCCR |= UDCCR_RESIM;
/* END EXPERIMENT 10Feb01ww */
UDC_write( Ser0UDCCR, UDCCR_SUSIM | UDCCR_TIM);
/* clear all top-level sources */
Ser0UDCSR = UDCSR_RSTIR | UDCSR_RESIR | UDCSR_EIR | UDCSR_RIR | UDCSR_TIR | UDCSR_SUSIR ;
return 0;
}
/*
* This gets called when we receive a SET_CONFIGURATION packet to EP0.
* We were configured. We can now send packets to the host.
*/
void udc_ep2_config(struct sausb_dev *usb, unsigned int maxpktsize)
{
/*
* We shouldn't be transmitting anything...
*/
BUG_ON(usb->ep[1].buflen);
BUG_ON(usb->ep[1].pktlen);
/*
* Set our configuration.
*/
usb->ep[1].maxpktsize = maxpktsize;
usb->ep[1].configured = 1;
/*
* Clear any pending TPC status.
*/
udc_set_cs2(UDCCS2_TPC, UDCCS2_TPC, 0);
/*
* Enable EP2 interrupts.
*/
usb->udccr &= ~UDCCR_TIM;
UDC_write(Ser0UDCCR, usb->udccr);
usb->ep[1].udccs = 0;
}
static void ep1_start(void)
{
PRINTKD( "[%lu]ep1_start dma_len %d remain %d pkt %d\n", (jiffies-start_time)*10, ep1_curdmalen, ep1_remain,
rx_pktsize);
sa1100_clear_dma(dmachn_rx);
if (!ep1_curdmalen) {
// ep1_curdmalen is min (rx_pktsize , ep1_remain)
ep1_curdmalen = rx_pktsize;
if (ep1_curdmalen > ep1_remain)
ep1_curdmalen = ep1_remain;
ep1_curdmapos = pci_map_single(NULL, ep1_curdmabuf, ep1_curdmalen, PCI_DMA_FROMDEVICE);
}
UDC_write( Ser0UDCOMP, ep1_curdmalen - 1);
sa1100_start_dma(dmachn_rx, ep1_curdmapos, ep1_curdmalen);
if ( naking ) {
/* turn off NAK of OUT packets, if set */
UDC_flip( Ser0UDCCS1, UDCCS1_RPC );
naking = 0;
}
}
int ep1_init(dma_regs_t *chn)
{
UDC_write( Ser0UDCOMP, rx_pktsize-1 );
dmachn_rx = chn;
sa1100_clear_dma(dmachn_rx);
ep1_done(-EAGAIN);
return 0;
}
/* set feature stall executing, async */
static void ep2_start(struct sausb_dev *usb)
{
ep2_curdmalen = min(ep2_remain, usb->ep[1].maxpktsize);
if (ep2_curdmalen == 0)
return;
/*
* must do this _before_ queue buffer..
* stop NAKing IN tokens
*/
udc_set_cs2(usb->ep[1].udccs | UDCCS2_TPC, UDCCS2_TPC, 0);
UDC_write(Ser0UDCIMP, ep2_curdmalen - 1);
/* Remove if never seen...8Mar01ww */
{
int massive_attack = 20;
while (Ser0UDCIMP != ep2_curdmalen - 1 && massive_attack--) {
printk("usbsnd: Oh no you don't! Let me spin...");
udelay(500);
printk("and try again...\n");
UDC_write(Ser0UDCIMP, ep2_curdmalen - 1);
}
if (massive_attack != 20) {
if (Ser0UDCIMP != ep2_curdmalen - 1)
printk("usbsnd: Massive attack FAILED. %d\n",
20 - massive_attack);
else
printk("usbsnd: Massive attack WORKED. %d\n",
20 - massive_attack);
}
}
/* End remove if never seen... 8Mar01ww */
/*
* fight stupid silicon bug
*/
Ser0UDCAR = usb->ctl->address;
sa1100_start_dma(usb->ep[1].dmach, usb->ep[1].pktdma, ep2_curdmalen);
}
/*
* We saw a reset from the attached hub, or were deconfigured.
* This means we are no longer configured.
*/
void udc_ep2_reset(struct sausb_dev *usb)
{
/*
* Disable EP2 interrupts.
*/
usb->udccr |= UDCCR_TIM;
UDC_write(Ser0UDCCR, usb->udccr);
usb->ep[1].configured = 0;
usb->ep[1].maxpktsize = 0;
sa1100_reset_dma(usb->ep[1].dmach);
udc_ep2_done(usb, -EINTR);
}
static void hub_interrupt_complete(int flag, int size) {
int flags;
PRINTKI( "[%lu]Hub_interrupt_complete (status %d)\n",(jiffies-start_time)*10, flag);
local_irq_save(flags);
if (flag == 0)
{
//printk( "hub_interrupt_complete: ¿queda pendiente?\n");
hub_interrupt_queued = 0;
}
else
{
printk( "hub_interrupt_complete con error?: flag %d, size %d\n", flag, size);
}
local_irq_restore(flags);
// Mask EP2 interrupts
Ser0UDCCR = 0xFC;
UDC_write(Ser0UDCCR, UDCCR_TIM);
//UDC_write(Ser0UDCCR, UDCCR_TIM | UDCCR_REM); // Errata 29
if (device_retry>0) {
PRINTKI( "[%lu]GetHub/PortStatus: retry port %d \n", (jiffies-start_time)*10, device_retry);
}
// Keep sending Device 5 connected until PORT_RESET received
if (machine_state==DEVICE5_WAIT_READY && device_retry>0) {
machine_state=DEVICE4_READY;
SET_TIMER (10);
}
// Keep sending Device 3 disconnected until PORT_STATUS received
if (machine_state==DEVICE3_WAIT_DISCONNECT && device_retry>0) {
machine_state=DEVICE5_READY;
SET_TIMER (10);
}
}
static void udc_int_hndlr(int irq, void *dev_id, struct pt_regs *regs)
{
__u32 status = Ser0UDCSR;
if (start_time==0) {
start_time = jiffies;
}
//PRINTKD("[%lu]Status %d Mask %d\n", (jiffies-start_time)*10, status, Ser0UDCCR);
UDC_flip(Ser0UDCSR, status); // clear all pending sources
/* ReSeT Interrupt Request - UDC has been reset */
if (status & UDCSR_RSTIR)
{
Ser0UDCCR = 0xFC;
if (second_reset) {
UDC_write(Ser0UDCCR, UDCCR_TIM);
//UDC_write(Ser0UDCCR, UDCCR_TIM | UDCCR_REM); // Errata 29
}
else {
Ser0UDCCR = UDCCR_TIM;
//Ser0UDCCR = UDCCR_TIM | UDCCR_REM; // Errata 29
}
if (Ser0UDCCR & UDCCR_TIM || second_reset==1) {
/* starting 20ms or so reset sequence now... */
ep0_reset(); // just set state to idle
ep1_reset(); // flush dma, clear false stall
ep2_reset(); // flush dma, clear false stall
}
second_reset = 1;
//UDC_flip(Ser0UDCSR, status); // clear all pending sources
PRINTKI("[%lu]Reset: Mask %d\n", (jiffies-start_time)*10, Ser0UDCCR);
return;
}
second_reset = 0;
// /* RESume Interrupt Request ojo eliminar?*/
if ( status & UDCSR_RESIR )
{
core_kicker();
Ser0UDCCR = 0xFC;
Ser0UDCCR = UDCCR_TIM | UDCCR_RESIM;
//UDC_flip(Ser0UDCSR, status); // clear all pending sources
PRINTKD("[%lu]Resume: Mask %d\n", (jiffies-start_time)*10, Ser0UDCCR);
return;
}
/* SUSpend Interrupt Request */
if ( status & UDCSR_SUSIR )
{
Ser0UDCCR = 0xFC;
// Does not seems to help either to be necessary
// if (tr==2) {
// core_kicker();
// }
UDC_write(Ser0UDCCR, UDCCR_TIM | UDCCR_SUSIM);
//UDC_write(Ser0UDCCR, UDCCR_TIM | UDCCR_SUSIM | UDCCR_REM); // Errata 29
//UDC_flip(Ser0UDCSR, status); // clear all pending sources
PRINTKI("[%lu]Suspended: Mask %d\n", (jiffies-start_time)*10, Ser0UDCCR);
return;
}
//UDC_flip(Ser0UDCSR, status); // clear all pending sources
if (status & UDCSR_RIR)
ep1_int_hndlr();
if (status & UDCSR_TIR)
ep2_int_hndlr();
if (status & UDCSR_EIR)
ep0_int_hndlr();
}
