/*
* We cannot (yet) probe for an IO mapped card, although we can check that
* it's where we were told it was, and even do autoirq.
*/
static int __init com20020isa_probe(struct net_device *dev)
{
int ioaddr;
unsigned long airqmask;
struct arcnet_local *lp = dev->priv;
#ifndef MODULE
arcnet_init();
#endif
BUGLVL(D_NORMAL) printk(VERSION);
ioaddr = dev->base_addr;
if (!ioaddr) {
BUGMSG(D_NORMAL, "No autoprobe (yet) for IO mapped cards; you "
"must specify the base address!\n");
return -ENODEV;
}
if (check_region(ioaddr, ARCNET_TOTAL_SIZE)) {
BUGMSG(D_NORMAL, "IO region %xh-%xh already allocated.\n",
ioaddr, ioaddr + ARCNET_TOTAL_SIZE - 1);
return -ENXIO;
}
if (ASTATUS() == 0xFF) {
BUGMSG(D_NORMAL, "IO address %x empty\n", ioaddr);
return -ENODEV;
}
if (com20020_check(dev))
return -ENODEV;
if (!dev->irq) {
/* if we do this, we're sure to get an IRQ since the
* card has just reset and the NORXflag is on until
* we tell it to start receiving.
*/
BUGMSG(D_INIT_REASONS, "intmask was %02Xh\n", inb(_INTMASK));
outb(0, _INTMASK);
airqmask = probe_irq_on();
outb(NORXflag, _INTMASK);
udelay(1);
outb(0, _INTMASK);
dev->irq = probe_irq_off(airqmask);
if (dev->irq <= 0) {
BUGMSG(D_INIT_REASONS, "Autoprobe IRQ failed first time\n");
airqmask = probe_irq_on();
outb(NORXflag, _INTMASK);
udelay(5);
outb(0, _INTMASK);
dev->irq = probe_irq_off(airqmask);
if (dev->irq <= 0) {
BUGMSG(D_NORMAL, "Autoprobe IRQ failed.\n");
return -ENODEV;
}
}
}
lp->card_name = "ISA COM20020";
return com20020_found(dev, 0);
}
static int __init com20020pci_init(void)
{
BUGLVL(D_NORMAL) printk(VERSION);
#ifndef MODULE
arcnet_init();
#endif
return pci_module_init(&com20020pci_driver);
}
int __init com90xx_probe(struct net_device *dev)
{
int count, status, ioaddr, numprint, airq, retval = -ENODEV,
openparen = 0;
unsigned long airqmask;
int ports[(0x3f0 - 0x200) / 16 + 1] =
{0};
u_long shmems[(0xFF800 - 0xA0000) / 2048 + 1] =
{0};
int numports, numshmems, *port;
u_long *shmem;
if (!dev && com90xx_skip_probe)
return -ENODEV;
#ifndef MODULE
arcnet_init();
#endif
BUGLVL(D_NORMAL) printk(VERSION);
/* set up the arrays where we'll store the possible probe addresses */
numports = numshmems = 0;
if (dev && dev->base_addr)
ports[numports++] = dev->base_addr;
else
for (count = 0x200; count <= 0x3f0; count += 16)
ports[numports++] = count;
if (dev && dev->mem_start)
shmems[numshmems++] = dev->mem_start;
else
for (count = 0xA0000; count <= 0xFF800; count += 2048)
shmems[numshmems++] = count;
/* Stage 1: abandon any reserved ports, or ones with status==0xFF
* (empty), and reset any others by reading the reset port.
*/
numprint = -1;
for (port = &ports[0]; port - ports < numports; port++) {
numprint++;
numprint %= 8;
if (!numprint) {
BUGMSG2(D_INIT, "\n");
BUGMSG2(D_INIT, "S1: ");
}
BUGMSG2(D_INIT, "%Xh ", *port);
ioaddr = *port;
if (check_region(*port, ARCNET_TOTAL_SIZE)) {
BUGMSG2(D_INIT_REASONS, "(check_region)\n");
BUGMSG2(D_INIT_REASONS, "S1: ");
BUGLVL(D_INIT_REASONS) numprint = 0;
*port = ports[numports - 1];
numports--;
port--;
continue;
}
if (ASTATUS() == 0xFF) {
BUGMSG2(D_INIT_REASONS, "(empty)\n");
BUGMSG2(D_INIT_REASONS, "S1: ");
BUGLVL(D_INIT_REASONS) numprint = 0;
*port = ports[numports - 1];
numports--;
port--;
continue;
}
inb(_RESET); /* begin resetting card */
BUGMSG2(D_INIT_REASONS, "\n");
BUGMSG2(D_INIT_REASONS, "S1: ");
BUGLVL(D_INIT_REASONS) numprint = 0;
}
BUGMSG2(D_INIT, "\n");
if (!numports) {
BUGMSG2(D_NORMAL, "S1: No ARCnet cards found.\n");
return -ENODEV;
}
/* Stage 2: we have now reset any possible ARCnet cards, so we can't
* do anything until they finish. If D_INIT, print the list of
* cards that are left.
*/
numprint = -1;
for (port = &ports[0]; port - ports < numports; port++) {
numprint++;
numprint %= 8;
if (!numprint) {
BUGMSG2(D_INIT, "\n");
BUGMSG2(D_INIT, "S2: ");
}
BUGMSG2(D_INIT, "%Xh ", *port);
}
BUGMSG2(D_INIT, "\n");
mdelay(RESETtime);
/* Stage 3: abandon any shmem addresses that don't have the signature
* 0xD1 byte in the right place, or are read-only.
*/
numprint = -1;
for (shmem = &shmems[0]; shmem - shmems < numshmems; shmem++) {
u_long ptr = *shmem;
numprint++;
numprint %= 8;
if (!numprint) {
BUGMSG2(D_INIT, "\n");
BUGMSG2(D_INIT, "S3: ");
}
BUGMSG2(D_INIT, "%lXh ", *shmem);
if (check_mem_region(*shmem, BUFFER_SIZE)) {
BUGMSG2(D_INIT_REASONS, "(check_mem_region)\n");
BUGMSG2(D_INIT_REASONS, "Stage 3: ");
BUGLVL(D_INIT_REASONS) numprint = 0;
*shmem = shmems[numshmems - 1];
numshmems--;
shmem--;
continue;
}
if (isa_readb(ptr) != TESTvalue) {
BUGMSG2(D_INIT_REASONS, "(%02Xh != %02Xh)\n",
isa_readb(ptr), TESTvalue);
BUGMSG2(D_INIT_REASONS, "S3: ");
BUGLVL(D_INIT_REASONS) numprint = 0;
*shmem = shmems[numshmems - 1];
numshmems--;
shmem--;
continue;
}
/* By writing 0x42 to the TESTvalue location, we also make
* sure no "mirror" shmem areas show up - if they occur
* in another pass through this loop, they will be discarded
* because *cptr != TESTvalue.
*/
isa_writeb(0x42, ptr);
if (isa_readb(ptr) != 0x42) {
BUGMSG2(D_INIT_REASONS, "(read only)\n");
BUGMSG2(D_INIT_REASONS, "S3: ");
*shmem = shmems[numshmems - 1];
numshmems--;
shmem--;
continue;
}
BUGMSG2(D_INIT_REASONS, "\n");
BUGMSG2(D_INIT_REASONS, "S3: ");
BUGLVL(D_INIT_REASONS) numprint = 0;
}
BUGMSG2(D_INIT, "\n");
if (!numshmems) {
BUGMSG2(D_NORMAL, "S3: No ARCnet cards found.\n");
return -ENODEV;
}
/* Stage 4: something of a dummy, to report the shmems that are
* still possible after stage 3.
*/
numprint = -1;
for (shmem = &shmems[0]; shmem - shmems < numshmems; shmem++) {
numprint++;
numprint %= 8;
if (!numprint) {
BUGMSG2(D_INIT, "\n");
BUGMSG2(D_INIT, "S4: ");
}
BUGMSG2(D_INIT, "%lXh ", *shmem);
}
BUGMSG2(D_INIT, "\n");
/* Stage 5: for any ports that have the correct status, can disable
* the RESET flag, and (if no irq is given) generate an autoirq,
* register an ARCnet device.
*
* Currently, we can only register one device per probe, so quit
* after the first one is found.
*/
numprint = -1;
for (port = &ports[0]; port - ports < numports; port++) {
numprint++;
numprint %= 8;
if (!numprint) {
BUGMSG2(D_INIT, "\n");
BUGMSG2(D_INIT, "S5: ");
}
BUGMSG2(D_INIT, "%Xh ", *port);
ioaddr = *port;
status = ASTATUS();
if ((status & 0x9D)
!= (NORXflag | RECONflag | TXFREEflag | RESETflag)) {
BUGMSG2(D_INIT_REASONS, "(status=%Xh)\n", status);
BUGMSG2(D_INIT_REASONS, "S5: ");
BUGLVL(D_INIT_REASONS) numprint = 0;
*port = ports[numports - 1];
numports--;
port--;
continue;
}
ACOMMAND(CFLAGScmd | RESETclear | CONFIGclear);
status = ASTATUS();
if (status & RESETflag) {
BUGMSG2(D_INIT_REASONS, " (eternal reset, status=%Xh)\n",
status);
BUGMSG2(D_INIT_REASONS, "S5: ");
BUGLVL(D_INIT_REASONS) numprint = 0;
*port = ports[numports - 1];
numports--;
port--;
continue;
}
/* skip this completely if an IRQ was given, because maybe
* we're on a machine that locks during autoirq!
*/
if (!dev || !dev->irq) {
/* if we do this, we're sure to get an IRQ since the
* card has just reset and the NORXflag is on until
* we tell it to start receiving.
*/
airqmask = probe_irq_on();
AINTMASK(NORXflag);
udelay(1);
AINTMASK(0);
airq = probe_irq_off(airqmask);
if (airq <= 0) {
BUGMSG2(D_INIT_REASONS, "(airq=%d)\n", airq);
BUGMSG2(D_INIT_REASONS, "S5: ");
BUGLVL(D_INIT_REASONS) numprint = 0;
*port = ports[numports - 1];
numports--;
port--;
continue;
}
} else {
airq = dev->irq;
}
BUGMSG2(D_INIT, "(%d,", airq);
openparen = 1;
/* Everything seems okay. But which shmem, if any, puts
* back its signature byte when the card is reset?
*
* If there are multiple cards installed, there might be
* multiple shmems still in the list.
*/
#ifdef FAST_PROBE
if (numports > 1 || numshmems > 1) {
inb(_RESET);
mdelay(RESETtime);
} else {
/* just one shmem and port, assume they match */
isa_writeb(TESTvalue, shmems[0]);
}
#else
inb(_RESET);
mdelay(RESETtime);
#endif
for (shmem = &shmems[0]; shmem - shmems < numshmems; shmem++) {
u_long ptr = *shmem;
if (isa_readb(ptr) == TESTvalue) { /* found one */
BUGMSG2(D_INIT, "%lXh)\n", *shmem);
openparen = 0;
/* register the card */
retval = com90xx_found(dev, *port, airq, *shmem);
numprint = -1;
/* remove shmem from the list */
*shmem = shmems[numshmems - 1];
numshmems--;
break; /* go to the next I/O port */
} else {
BUGMSG2(D_INIT_REASONS, "%Xh-", isa_readb(ptr));
}
}
if (openparen) {
BUGLVL(D_INIT) printk("no matching shmem)\n");
BUGLVL(D_INIT_REASONS) printk("S5: ");
BUGLVL(D_INIT_REASONS) numprint = 0;
}
*port = ports[numports - 1];
numports--;
port--;
}
BUGLVL(D_INIT_REASONS) printk("\n");
/* Now put back TESTvalue on all leftover shmems. */
for (shmem = &shmems[0]; shmem - shmems < numshmems; shmem++)
isa_writeb(TESTvalue, *shmem);
if (retval && dev && !numcards)
BUGMSG2(D_NORMAL, "S5: No ARCnet cards found.\n");
return retval;
}
