int board_mmc_init(bd_t *bis)
{
cm_fx6_set_usdhc_iomux();
usdhc_cfg.sdhc_clk = mxc_get_clock(MXC_ESDHC3_CLK);
return fsl_esdhc_initialize(bis, &usdhc_cfg);
}
int board_mmc_init(bd_t *bis)
{
int i;
cm_fx6_set_usdhc_iomux();
for (i = 0; i < CONFIG_SYS_FSL_USDHC_NUM; i++) {
usdhc_cfg[i].sdhc_clk = mxc_get_clock(usdhc_clk[i]);
usdhc_cfg[i].max_bus_width = 4;
fsl_esdhc_initialize(bis, &usdhc_cfg[i]);
enable_usdhc_clk(1, i);
}
return 0;
}
int board_init(void)
{
int ret;
gd->bd->bi_boot_params = PHYS_SDRAM_1 + 0x100;
cm_fx6_setup_gpmi_nand();
ret = cm_fx6_setup_ecspi();
if (ret)
printf("Warning: ECSPI setup failed: %d\n", ret);
ret = cm_fx6_setup_usb_otg();
if (ret)
printf("Warning: USB OTG setup failed: %d\n", ret);
ret = cm_fx6_setup_usb_host();
if (ret)
printf("Warning: USB host setup failed: %d\n", ret);
/*
* cm-fx6 may have iSSD not assembled and in this case it has
* bypasses for a (m)SATA socket on the baseboard. The socketed
* device is not controlled by those GPIOs. So just print a warning
* if the setup fails.
*/
ret = cm_fx6_setup_issd();
if (ret)
printf("Warning: iSSD setup failed: %d\n", ret);
/* Warn on failure but do not abort boot */
ret = cm_fx6_setup_i2c();
if (ret)
printf("Warning: I2C setup failed: %d\n", ret);
cm_fx6_setup_display();
/* This should be done in the MMC driver when MX6 has a clock driver */
#ifdef CONFIG_FSL_ESDHC
if (IS_ENABLED(CONFIG_BLK)) {
int i;
cm_fx6_set_usdhc_iomux();
for (i = 0; i < CONFIG_SYS_FSL_USDHC_NUM; i++)
enable_usdhc_clk(1, i);
}
#endif
return 0;
}
