int arch_cpu_init(void)
{
chip_configuration_unlock();
icache_enable();
if (cpu_is_k2g()) {
msmc_k2g_setup();
} else {
msmc_k2hkle_common_setup();
if (cpu_is_k2e())
msmc_k2e_setup();
else if (cpu_is_k2l())
msmc_k2l_setup();
else
msmc_k2hk_setup();
}
/* Initialize the PCIe-0 to work as Root Complex */
config_pcie_mode(0, ROOTCOMPLEX);
#if defined(CONFIG_SOC_K2E) || defined(CONFIG_SOC_K2L)
/* Initialize the PCIe-1 to work as Root Complex */
config_pcie_mode(1, ROOTCOMPLEX);
#endif
#ifdef CONFIG_SOC_K2L
osr_init();
#endif
/*
* just initialise the COM2 port so that TI specific
* UART register PWREMU_MGMT is initialized. Linux UART
* driver doesn't handle this.
*/
#ifndef CONFIG_DM_SERIAL
NS16550_init((NS16550_t)(CONFIG_SYS_NS16550_COM2),
CONFIG_SYS_NS16550_CLK / 16 / CONFIG_BAUDRATE);
#endif
return 0;
}
static int ks2_eth_probe(struct udevice *dev)
{
struct ks2_eth_priv *priv = dev_get_priv(dev);
struct mii_dev *mdio_bus;
int ret;
priv->dev = dev;
/* These clock enables has to be moved to common location */
if (cpu_is_k2g())
writel(KS2_ETHERNET_RGMII, KS2_ETHERNET_CFG);
/* By default, select PA PLL clock as PA clock source */
#ifndef CONFIG_SOC_K2G
if (psc_enable_module(KS2_LPSC_PA))
return -EACCES;
#endif
if (psc_enable_module(KS2_LPSC_CPGMAC))
return -EACCES;
if (psc_enable_module(KS2_LPSC_CRYPTO))
return -EACCES;
if (cpu_is_k2e() || cpu_is_k2l())
pll_pa_clk_sel();
priv->net_rx_buffs.buff_ptr = rx_buffs;
priv->net_rx_buffs.num_buffs = RX_BUFF_NUMS;
priv->net_rx_buffs.buff_len = RX_BUFF_LEN;
if (priv->slave_port == 1) {
/*
* Register MDIO bus for slave 0 only, other slave have
* to re-use the same
*/
mdio_bus = mdio_alloc();
if (!mdio_bus) {
error("MDIO alloc failed\n");
return -ENOMEM;
}
priv->mdio_bus = mdio_bus;
mdio_bus->read = keystone2_mdio_read;
mdio_bus->write = keystone2_mdio_write;
mdio_bus->reset = keystone2_mdio_reset;
mdio_bus->priv = priv->mdio_base;
sprintf(mdio_bus->name, "ethernet-mdio");
ret = mdio_register(mdio_bus);
if (ret) {
error("MDIO bus register failed\n");
return ret;
}
} else {
/* Get the MDIO bus from slave 0 device */
struct ks2_eth_priv *parent_priv;
parent_priv = dev_get_priv(dev->parent);
priv->mdio_bus = parent_priv->mdio_bus;
}
#ifndef CONFIG_SOC_K2G
keystone2_net_serdes_setup();
#endif
priv->netcp_pktdma = &netcp_pktdma;
if (priv->has_mdio) {
priv->phydev = phy_connect(priv->mdio_bus, priv->phy_addr,
dev, priv->phy_if);
phy_config(priv->phydev);
}
return 0;
}