void soc_configure_i2c6pad(void)
{
/*
* I2C6 on Tegra124/132 requires some special init.
* The SOR block must be unpowergated, and a couple of
* display-based peripherals must be clocked and taken
* out of reset so that a DPAUX register can be
* configured to enable the I2C6 mux routing.
* Afterwards, we can disable clocks to the display blocks
* and put Host1X back in reset. DPAUX must remain out of
* reset and the SOR partition must remained unpowergated.
*/
power_ungate_partition(POWER_PARTID_SOR);
/* Host1X needs a valid clock source so DPAUX can be accessed */
clock_configure_source(host1x, PLLP, 204000);
enable_sor_periph_clocks();
remove_clamps(POWER_PARTID_SOR);
unreset_sor_periphs();
/* Now we can write the I2C6 mux in DPAUX */
write32(I2C6_PADCTL, (void *)DPAUX_HYBRID_PADCTL);
/*
* Delay before turning off Host1X/DPAUX clocks.
* This delay is needed to keep the sequence from
* hanging the system.
*/
udelay(CLOCK_PLL_STABLE_DELAY_US);
/* Stop Host1X/DPAUX clocks and reset Host1X */
disable_sor_periph_clocks();
clock_set_reset_l(CLK_L_HOST1X);
}
void soc_configure_host1x(void)
{
power_ungate_partition(POWER_PARTID_SOR);
/* Host1X needs a valid clock source so DPAUX can be accessed. */
clock_configure_source(host1x, PLLP, 204000);
enable_sor_periph_clocks();
remove_clamps(POWER_PARTID_SOR);
unreset_sor_periphs();
}