Exemplos de fts_5x06_key_cancel em C++ (Cpp)

Exemplo n.º 1

Arquivo: ft5x06_driver.c Projeto: KhioGie/imo_s88_kk

static void tpd_suspend(struct early_suspend *h)
 {
	int ret = 0;
	int iRetry = 5;
	const char data = 0x3;
#ifdef CONFIG_TOUCHSCREEN_SWEEP2WAKE
	scr_suspended = true;
printk("[SWEEP2WAKE]: power suspend\n");
	if ((sweep2wake == 0 || sweep2wake == 3) && doubletap2wake == 0) {
#endif

	if ( g_pts ){
		 CTP_DBG("TPD enter sleep\n");
		if (atomic_read(&g_pts->isp_opened)){
			CTP_DBG("isp is already opened.");
			return;
		}

		 mt_eint_mask(CUST_EINT_TOUCH_PANEL_NUM);
		mutex_lock(&g_pts->mutex);//Unlock on resume
		 
#ifdef CONFIG_TOUCHSCREEN_FT5X05_DISABLE_KEY_WHEN_SLIDE
		fts_5x06_key_cancel();
#endif

#ifdef CONFIG_TOUCHSCREEN_POWER_DOWN_WHEN_SLEEP
	mt_set_gpio_mode(GPIO_CTP_RST_PIN, GPIO_CTP_RST_PIN_M_GPIO);
	mt_set_gpio_dir(GPIO_CTP_RST_PIN, GPIO_DIR_OUT);
	mt_set_gpio_out(GPIO_CTP_RST_PIN, GPIO_OUT_ZERO);
	msleep(2);
#ifdef MT6577
		hwPowerDown(MT65XX_POWER_LDO_VGP, "touch"); 
#else
		mt_set_gpio_mode(GPIO_CTP_EN_PIN, GPIO_CTP_EN_PIN_M_GPIO);
		mt_set_gpio_dir(GPIO_CTP_EN_PIN, GPIO_DIR_OUT);
		mt_set_gpio_out(GPIO_CTP_EN_PIN, GPIO_OUT_ZERO);
#endif	
#else //!CONFIG_TOUCHSCREEN_POWER_DOWN_WHEN_SLEEP
		//make sure the WakeUp is high before it enter sleep mode, 
		//otherwise the touch can't be resumed.
		//mt_set_gpio_mode(GPIO_CTP_EN_PIN, GPIO_CTP_EN_PIN_M_GPIO);
		//mt_set_gpio_dir(GPIO_CTP_EN_PIN, GPIO_DIR_OUT);
		//mt_set_gpio_out(GPIO_CTP_EN_PIN, GPIO_OUT_ONE);
		//msleep(1);  

		while (iRetry) {
			ret = i2c_smbus_write_i2c_block_data(g_pts->client, 0xA5, 1, &data);  //TP enter sleep mode
			if ( ret < 0 ){
				TPD_DMESG("Enter sleep mode is %d\n", ret);
#ifdef MT6577
				hwPowerDown(MT65XX_POWER_LDO_VGP, "touch"); 
#else
				mt_set_gpio_mode(GPIO_CTP_EN_PIN, GPIO_CTP_EN_PIN_M_GPIO);
				mt_set_gpio_dir(GPIO_CTP_EN_PIN, GPIO_DIR_OUT);
				mt_set_gpio_out(GPIO_CTP_EN_PIN, GPIO_OUT_ZERO);
#endif	
				msleep(2);  
				fts_5x06_hw_init();
			}else{
				break;
			}
			iRetry--;
			msleep(100);  
		} 
#endif//CONFIG_TOUCHSCREEN_POWER_DOWN_WHEN_SLEEP
#if 0//Android 4.0 don't need to report these up events.
		ft5x06_complete_unfinished_event();
#endif
		atomic_set( &g_pts->ts_sleepState, 1 );
	}

#ifdef CONFIG_TOUCHSCREEN_SWEEP2WAKE
	} else if ((sweep2wake > 0 && sweep2wake < 3) || doubletap2wake > 0)
		mt_eint_unmask(CUST_EINT_TOUCH_PANEL_NUM);
#endif
}

Exemplo n.º 2

Arquivo: ft5406_driver.c Projeto: dreamer7/NeoKernel-MT6589-A116

static void tpd_suspend(struct early_suspend *h)
 {
	int ret = 0;
	int iRetry = 5;
	const char data = 0x3;
 
	if ( g_pts ){
		 CTP_DBG("TPD enter sleep\n");
		if (atomic_read(&g_pts->isp_opened)){
			CTP_DBG("isp is already opened.");
			return;
		}

		 mt65xx_eint_mask(CUST_EINT_TOUCH_PANEL_NUM);
		mutex_lock(&g_pts->mutex);//Unlock on resume
		 
#ifdef CONFIG_TOUCHSCREEN_FT5X05_DISABLE_KEY_WHEN_SLIDE
		fts_5x06_key_cancel();
#endif

#ifdef CONFIG_TOUCHSCREEN_POWER_DOWN_WHEN_SLEEP
	mt_set_gpio_mode(GPIO_CTP_RST_PIN, GPIO_CTP_RST_PIN_M_GPIO);
	mt_set_gpio_dir(GPIO_CTP_RST_PIN, GPIO_DIR_OUT);
	mt_set_gpio_out(GPIO_CTP_RST_PIN, GPIO_OUT_ZERO);
	msleep(2);
#if 1 // def MT6577
		hwPowerDown(MT65XX_POWER_LDO_VGP5, "touch"); 
#else
		mt_set_gpio_mode(GPIO_CTP_EN_PIN, GPIO_CTP_EN_PIN_M_GPIO);
		mt_set_gpio_dir(GPIO_CTP_EN_PIN, GPIO_DIR_OUT);
		mt_set_gpio_out(GPIO_CTP_EN_PIN, GPIO_OUT_ZERO);
#endif	
#else //!CONFIG_TOUCHSCREEN_POWER_DOWN_WHEN_SLEEP
		//make sure the WakeUp is high before it enter sleep mode, 
		//otherwise the touch can't be resumed.
		//mt_set_gpio_mode(GPIO_CTP_EN_PIN, GPIO_CTP_EN_PIN_M_GPIO);
		//mt_set_gpio_dir(GPIO_CTP_EN_PIN, GPIO_DIR_OUT);
		//mt_set_gpio_out(GPIO_CTP_EN_PIN, GPIO_OUT_ONE);
		//msleep(1);  

		while (iRetry) {
			ret = i2c_smbus_write_i2c_block_data(g_pts->client, 0xA5, 1, &data);  //TP enter sleep mode
			if ( ret < 0 ){
				TPD_DMESG("Enter sleep mode is %d\n", ret);
#if 1 // def MT6577
				hwPowerDown(MT65XX_POWER_LDO_VGP5, "touch"); 
#else
				mt_set_gpio_mode(GPIO_CTP_EN_PIN, GPIO_CTP_EN_PIN_M_GPIO);
				mt_set_gpio_dir(GPIO_CTP_EN_PIN, GPIO_DIR_OUT);
				mt_set_gpio_out(GPIO_CTP_EN_PIN, GPIO_OUT_ZERO);
#endif	
				msleep(2);  
				fts_5x06_hw_init();
			}else{
				break;
			}
			iRetry--;
			msleep(100);  
		} 
#endif//CONFIG_TOUCHSCREEN_POWER_DOWN_WHEN_SLEEP

		atomic_set( &g_pts->ts_sleepState, 1 );
	}
 }