static int iwlagn_rxon_connect(struct iwl_priv *priv,
struct iwl_rxon_context *ctx)
{
int ret;
struct iwl_rxon_cmd *active = (void *)&ctx->active;
if (ctx->ctxid == IWL_RXON_CTX_BSS) {
ret = iwl_send_rxon_timing(priv, ctx);
if (ret) {
IWL_ERR(priv, "Failed to send timing (%d)!\n", ret);
return ret;
}
}
iwlagn_update_qos(priv, ctx);
if (ctx->vif && (ctx->vif->type == NL80211_IFTYPE_AP)) {
ret = iwlagn_update_beacon(priv, ctx->vif);
if (ret) {
IWL_ERR(priv,
"Error sending required beacon (%d)!\n",
ret);
return ret;
}
}
priv->start_calib = 0;
ret = iwl_dvm_send_cmd_pdu(priv, ctx->rxon_cmd, CMD_SYNC,
sizeof(struct iwl_rxon_cmd), &ctx->staging);
if (ret) {
IWL_ERR(priv, "Error setting new RXON (%d)\n", ret);
return ret;
}
memcpy(active, &ctx->staging, sizeof(*active));
if (ctx->vif && (ctx->vif->type == NL80211_IFTYPE_ADHOC))
if (iwlagn_update_beacon(priv, ctx->vif))
IWL_ERR(priv, "Error sending IBSS beacon\n");
iwl_init_sensitivity(priv);
ret = iwl_set_tx_power(priv, priv->tx_power_next, true);
if (ret) {
IWL_ERR(priv, "Error sending TX power (%d)\n", ret);
return ret;
}
if (ctx->vif && ctx->vif->type == NL80211_IFTYPE_STATION &&
cfg(priv)->ht_params && cfg(priv)->ht_params->smps_mode)
ieee80211_request_smps(ctx->vif,
cfg(priv)->ht_params->smps_mode);
return 0;
}
static int iwlagn_rxon_connect(struct iwl_priv *priv,
struct iwl_rxon_context *ctx)
{
int ret;
struct iwl_rxon_cmd *active = (void *)&ctx->active;
/* RXON timing must be before associated RXON */
if (ctx->ctxid == IWL_RXON_CTX_BSS) {
ret = iwl_send_rxon_timing(priv, ctx);
if (ret) {
IWL_ERR(priv, "Failed to send timing (%d)!\n", ret);
return ret;
}
}
/* QoS info may be cleared by previous un-assoc RXON */
iwlagn_update_qos(priv, ctx);
/*
* We'll run into this code path when beaconing is
* enabled, but then we also need to send the beacon
* to the device.
*/
if (ctx->vif && (ctx->vif->type == NL80211_IFTYPE_AP)) {
ret = iwlagn_update_beacon(priv, ctx->vif);
if (ret) {
IWL_ERR(priv,
"Error sending required beacon (%d)!\n",
ret);
return ret;
}
}
priv->start_calib = 0;
/*
* Apply the new configuration.
*
* Associated RXON doesn't clear the station table in uCode,
* so we don't need to restore stations etc. after this.
*/
ret = trans_send_cmd_pdu(&priv->trans, ctx->rxon_cmd, CMD_SYNC,
sizeof(struct iwl_rxon_cmd), &ctx->staging);
if (ret) {
IWL_ERR(priv, "Error setting new RXON (%d)\n", ret);
return ret;
}
memcpy(active, &ctx->staging, sizeof(*active));
iwl_reprogram_ap_sta(priv, ctx);
/* IBSS beacon needs to be sent after setting assoc */
if (ctx->vif && (ctx->vif->type == NL80211_IFTYPE_ADHOC))
if (iwlagn_update_beacon(priv, ctx->vif))
IWL_ERR(priv, "Error sending IBSS beacon\n");
iwl_init_sensitivity(priv);
/*
* If we issue a new RXON command which required a tune then
* we must send a new TXPOWER command or we won't be able to
* Tx any frames.
*
* It's expected we set power here if channel is changing.
*/
ret = iwl_set_tx_power(priv, priv->tx_power_next, true);
if (ret) {
IWL_ERR(priv, "Error sending TX power (%d)\n", ret);
return ret;
}
if ((ctx->vif && ctx->vif->type == NL80211_IFTYPE_STATION) &&
priv->cfg->ht_params->smps_mode)
ieee80211_request_smps(ctx->vif,
priv->cfg->ht_params->smps_mode);
return 0;
}
static void iwlagn_bt_traffic_change_work(struct work_struct *work)
{
struct iwl_priv *priv =
container_of(work, struct iwl_priv, bt_traffic_change_work);
struct iwl_rxon_context *ctx;
int smps_request = -1;
if (priv->bt_enable_flag == IWLAGN_BT_FLAG_COEX_MODE_DISABLED) {
/* bt coex disabled */
return;
}
/*
* Note: bt_traffic_load can be overridden by scan complete and
* coex profile notifications. Ignore that since only bad consequence
* can be not matching debug print with actual state.
*/
IWL_DEBUG_COEX(priv, "BT traffic load changes: %d\n",
priv->bt_traffic_load);
switch (priv->bt_traffic_load) {
case IWL_BT_COEX_TRAFFIC_LOAD_NONE:
if (priv->bt_status)
smps_request = IEEE80211_SMPS_DYNAMIC;
else
smps_request = IEEE80211_SMPS_AUTOMATIC;
break;
case IWL_BT_COEX_TRAFFIC_LOAD_LOW:
smps_request = IEEE80211_SMPS_DYNAMIC;
break;
case IWL_BT_COEX_TRAFFIC_LOAD_HIGH:
case IWL_BT_COEX_TRAFFIC_LOAD_CONTINUOUS:
smps_request = IEEE80211_SMPS_STATIC;
break;
default:
IWL_ERR(priv, "Invalid BT traffic load: %d\n",
priv->bt_traffic_load);
break;
}
mutex_lock(&priv->mutex);
/*
* We can not send command to firmware while scanning. When the scan
* complete we will schedule this work again. We do check with mutex
* locked to prevent new scan request to arrive. We do not check
* STATUS_SCANNING to avoid race when queue_work two times from
* different notifications, but quit and not perform any work at all.
*/
if (test_bit(STATUS_SCAN_HW, &priv->status))
goto out;
iwl_update_chain_flags(priv);
if (smps_request != -1) {
priv->current_ht_config.smps = smps_request;
for_each_context(priv, ctx) {
if (ctx->vif && ctx->vif->type == NL80211_IFTYPE_STATION)
ieee80211_request_smps(ctx->vif, smps_request);
}
}
