int main( void )
{
// Stop watchdog timer to prevent time out reset
WDTCTL = WDTPW + WDTHOLD;
// timerA_start(timing, OUTMOD_SET_RESET); // starte PWM
INIT_PORTS();
// INIT_ADC();
// init_XT2();
init_PWM_TimerA();
set_PWM_duty_cycle(0);
P1OUT |= LED_PWR_ON;
P1OUT |= LED2;
//_BIS_SR(LPM3_bits);
_BIS_SR(LPM0_bits + GIE); // Enter LPM0 w/ interrupt
// while(1) // warte bis sich was tut
// {
// }
// return 0;
}
void main(void)
{
/******************************************************************************/
// Init
/******************************************************************************/
WDTCTL = WDTPW + WDTHOLD; // watchdog timer off
configureClocks();
init_PWM_TimerA();
hour = 6;
hour24 = 6;
minute = 1; // Set to one because with 0 no LED is on which is confusing.
second = 0;
state = SET_HOUR;
capsense=0;
LEDState=OFF;
timer=0;
DEMOPointer = 1;
P1REN = BIT6 + BIT7; // P1REN = pullup/down enable
P1OUT = BIT6 + BIT7; // P1OUT = define pullup
P1IFG = 0;
P1IES = BIT6 + BIT7; // set high to low transition for P1.6&7 interrupt
P1IE = BIT6 + BIT7; // enable P1.6&7 interrupt
P1REN |= BIT4 + BIT5; // P1REN = pullup/down enable
P1OUT |= BIT4 + BIT5; // P1OUT = pullup
P2REN |= BIT0; // P2REN = pullup/down enable
P2OUT |= BIT0; // P2OUT = pullup
P2OUT |= BIT3;
P2DIR |= BIT3;
P3REN = 0xFF; // Tie all P3 ports which are not available on N package
P3OUT = 0xFF;
WDTCTL = WDTPW + WDTTMSEL + WDTCNTCL + WDTSSEL; // watchdog counter mode, ACLK, /32768
IFG1 &= ~WDTIFG; // Clear WDT interrupt flag
IE1 |= WDTIE; // WDT interrupt enable
measure_count(); // Establish baseline capacitance
base_cnt = meas_cnt;
for(i=15; i>0; i--) // Repeat and avg base measurement
{
measure_count();
base_cnt = (meas_cnt+base_cnt)/2;
}
/******************************************************************************/
// Mainloop
/******************************************************************************/
__enable_interrupt();
while(1)
{
switch(state)
{
case NORMAL:
if (capsense)
{
CapTouch();
}
if (LEDState==ON)
{
HourView();
}
if (LEDState==ON && ((hour24>=7) && (hour24<18)))
{
MoonOff();
SunOn();
}
if (LEDState==ON && ((hour24>=18) || (hour24<7)))
{
SunOff();
MoonOn();
}
break;
case SET_HOUR:
capsense=OFF;
MoonOff();
SunOff();
HourView();
break;
case SET_MINUTE:
capsense=OFF;
MoonOff();
SunOff();
MinuteView();
break;
case DEMO:
if (DEMOPointer==1)
{
MoonOn();
SunOff();
}
if (DEMOPointer==7)
{
MoonOff();
SunOn();
}
j = 5000/DEMOPointer;
for(i=0;i<j;i++)
{
unsigned int OnTime = 10*DEMOPointer;
unsigned int OffTime = 120/DEMOPointer;
for(LEDPointer = 1;LEDPointer <= DEMOPointer;LEDPointer++)
{
LEDOn();
delay(OnTime);
LEDOff();
delay(OffTime);
}
}
DEMOPointer++;
if (DEMOPointer==13)
{
DEMOPointer=1;
}
break;
}
}
} // main()
