Exemplos de jz_lcd_hw_init em C++ (Cpp)

Exemplo n.º 1

Arquivo: jz4770_lcd.c Projeto: IngenicSemiconductor/X-BOOT-WARRIOR

void _lcd_ctrl_init(void *lcdbase)//init ctrl without backlight on
{
	__lcd_close_backlight();
	__lcd_display_pin_init();

	jz_lcd_init_mem(lcdbase, &panel_info);
	jz_lcd_desc_init(&panel_info);
	jz_lcd_hw_init(&panel_info);
}

Exemplo n.º 2

Arquivo: jz_lcd.c Projeto: 7LK/McWRT

void lcd_ctrl_init (void *lcdbase)
{
	__lcd_display_pin_init();

	jz_lcd_init_mem(lcdbase, &panel_info);
	jz_lcd_desc_init(&panel_info);
	jz_lcd_hw_init(&panel_info);

	__lcd_display_on() ;
}

Exemplo n.º 3

Arquivo: jz4750_lcd.c Projeto: yindian/dingoo-linux

void lcd_ctrl_init (void *lcdbase)
{

	__lcd_close_backlight();
	__lcd_display_pin_init();

	jz_lcd_init_mem(lcdbase, &panel_info);
	jz_lcd_desc_init(&panel_info);
	jz_lcd_hw_init(&panel_info);

	__lcd_display_on() ;
	lcd_enable();
}

Exemplo n.º 4

Arquivo: jz4770_lcd.c Projeto: IngenicSemiconductor/X-BOOT-WARRIOR

void lcd_ctrl_init(void *lcdbase)
{
	__lcd_close_backlight();
	__lcd_display_pin_init();
#if defined(CONFIG_ANDROID_LCD_PROBE)
	__gpio_disable_pull(GPIO_LCD_PWR_N);
	__gpio_clear_pin(GPIO_LCD_PWR_N);
	__gpio_as_output(GPIO_LCD_PWR_N);
	msdelay(50);
	__gpio_set_pin(LCD_RESET_PIN);
	msdelay(1);
	__gpio_clear_pin(LCD_RESET_PIN);
	msdelay(10);
	__gpio_set_pin(LCD_RESET_PIN);
	msdelay(100);
	Jz_LcdProbe();

//	__gpio_clear_pin(LCD_RESET_PIN);
//	mdelay(10);
//	__gpio_set_pin(LCD_RESET_PIN);
//	mdelay(100);
#endif
	
	jz_lcd_init_mem(lcdbase, &panel_info);
	jz_lcd_desc_init(&panel_info);
	jz_lcd_hw_init(&panel_info);
	board_lcd_board_init();
//	__lcd_display_on();
//	lcd_enable();

#ifdef DEBUG
	serial_puts_info("***************************LCDC INFO****************************\n");
	serial_puts_msg("lcdbase = ");
	dump_uint(lcdbase);
	serial_puts_msg("  vl_bpix =  ");
	dump_uint(panel_info.vl_bpix);
	serial_puts_msg(" \n");
	print_lcdc_desc(&panel_info);
#endif
}