static void s3c2410_pm_prepare(void)
{
/* ensure at least GSTATUS3 has the resume address */
__raw_writel(virt_to_phys(s3c_cpu_resume), S3C2410_GSTATUS3);
S3C_PMDBG("GSTATUS3 0x%08x\n", __raw_readl(S3C2410_GSTATUS3));
S3C_PMDBG("GSTATUS4 0x%08x\n", __raw_readl(S3C2410_GSTATUS4));
if (machine_is_h1940()) {
void *base = phys_to_virt(H1940_SUSPEND_CHECK);
unsigned long ptr;
unsigned long calc = 0;
/* generate check for the bootloader to check on resume */
for (ptr = 0; ptr < 0x40000; ptr += 0x400)
calc += __raw_readl(base+ptr);
__raw_writel(calc, phys_to_virt(H1940_SUSPEND_CHECKSUM));
}
/* RX3715 and RX1950 use similar to H1940 code and the
* same offsets for resume and checksum pointers */
if (machine_is_rx3715() || machine_is_rx1950()) {
void *base = phys_to_virt(H1940_SUSPEND_CHECK);
unsigned long ptr;
unsigned long calc = 0;
/* generate check for the bootloader to check on resume */
for (ptr = 0; ptr < 0x40000; ptr += 0x4)
calc += __raw_readl(base+ptr);
__raw_writel(calc, phys_to_virt(H1940_SUSPEND_CHECKSUM));
}
if ( machine_is_aml_m5900() )
s3c2410_gpio_setpin(S3C2410_GPF(2), 1);
if (machine_is_rx1950()) {
/* According to S3C2442 user's manual, page 7-17,
* when the system is operating in NAND boot mode,
* the hardware pin configuration - EINT[23:21] –
* must be set as input for starting up after
* wakeup from sleep mode
*/
s3c_gpio_cfgpin(S3C2410_GPG(13), S3C2410_GPIO_INPUT);
s3c_gpio_cfgpin(S3C2410_GPG(14), S3C2410_GPIO_INPUT);
s3c_gpio_cfgpin(S3C2410_GPG(15), S3C2410_GPIO_INPUT);
}
}
static int __init rx1950_init(void)
{
int ret;
if (!machine_is_rx1950())
return -ENODEV;
ret = gpio_request(S3C2410_GPA(1), "speaker-power");
if (ret)
goto err_gpio;
ret = gpio_direction_output(S3C2410_GPA(1), 0);
if (ret)
goto err_gpio_conf;
s3c24xx_snd_device = platform_device_alloc("soc-audio", -1);
if (!s3c24xx_snd_device) {
ret = -ENOMEM;
goto err_plat_alloc;
}
platform_set_drvdata(s3c24xx_snd_device, &rx1950_asoc);
ret = platform_device_add(s3c24xx_snd_device);
if (ret) {
platform_device_put(s3c24xx_snd_device);
goto err_plat_add;
}
return 0;
err_plat_add:
err_plat_alloc:
err_gpio_conf:
gpio_free(S3C2410_GPA(1));
err_gpio:
return ret;
}
