int board_late_init(void)
{
char *idk_lcd;
setup_board_eeprom_env();
/*
* DEV_CTRL.DEV_ON = 1 please - else palmas switches off in 8 seconds
* This is the POWERHOLD-in-Low behavior.
*/
palmas_i2c_write_u8(TPS65903X_CHIP_P1, 0xA0, 0x1);
/* TBD: Add LCD panel detection once information is available */
if (am571x_idk_needs_lcd())
idk_lcd = "osd101t2045"; /* Default to legacy LCD */
else
idk_lcd = "no";
setenv("idk_lcd", idk_lcd);
#if !defined(CONFIG_SPL_BUILD)
board_set_ethaddr();
#endif
return 0;
}
int board_late_init(void)
{
setup_board_eeprom_env();
/*
* DEV_CTRL.DEV_ON = 1 please - else palmas switches off in 8 seconds
* This is the POWERHOLD-in-Low behavior.
*/
palmas_i2c_write_u8(TPS65903X_CHIP_P1, 0xA0, 0x1);
return 0;
}
int board_late_init(void)
{
setup_board_eeprom_env();
u8 val;
/*
* DEV_CTRL.DEV_ON = 1 please - else palmas switches off in 8 seconds
* This is the POWERHOLD-in-Low behavior.
*/
palmas_i2c_write_u8(TPS65903X_CHIP_P1, 0xA0, 0x1);
/*
* Default FIT boot on HS devices. Non FIT images are not allowed
* on HS devices.
*/
if (get_device_type() == HS_DEVICE)
env_set("boot_fit", "1");
/*
* Set the GPIO7 Pad to POWERHOLD. This has higher priority
* over DEV_CTRL.DEV_ON bit. This can be reset in case of
* PMIC Power off. So to be on the safer side set it back
* to POWERHOLD mode irrespective of the current state.
*/
palmas_i2c_read_u8(TPS65903X_CHIP_P1, TPS65903X_PRIMARY_SECONDARY_PAD2,
&val);
val = val | TPS65903X_PAD2_POWERHOLD_MASK;
palmas_i2c_write_u8(TPS65903X_CHIP_P1, TPS65903X_PRIMARY_SECONDARY_PAD2,
val);
omap_die_id_serial();
omap_set_fastboot_vars();
am57x_idk_lcd_detect();
#if !defined(CONFIG_SPL_BUILD)
board_ti_set_ethaddr(2);
#endif
return 0;
}
